Journals / NanoEra / 2025 / Volume: 5 Issue: 2

Structural investigation of the effect of annealing temperature on the Fe:WO3 structure on a silicon substrate

Sevda Sarıtaş(ATATÜRK ÜNİVERSİTESİ)0000-0002-7274-3968
Journal
NanoEra
Pages
—
Publication Date
2025-12-31
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

These results suggest that Fe incorporation effectively alters the lattice parameters and structural stability of WO₃ without creating any secondary Fe-based oxide phases.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In this study, iron-doped tungsten oxide (Fe: WO₃) thin films were synthesized on p-type silicon (Si (111)) and glass substrates using a DC/RF co-magnetron sputtering technique under controlled deposition conditions.
📊
Key Findings & Data:The effect of post-deposition annealing on the structural and crystallographic evolution of the films was systematically examined at temperatures of 550°C, 650°C, and 750°C in air.
💡
Conclusion & Impact:These results suggest that Fe incorporation effectively alters the lattice parameters and structural stability of WO₃ without creating any secondary Fe-based oxide phases.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Fe: WO₃ · X-ray diffraction (XRD) · DC/RF co-magnetron sputtering

Abstract

In this study, iron-doped tungsten oxide (Fe: WO₃) thin films were synthesized on p-type silicon (Si (111)) and glass substrates using a DC/RF co-magnetron sputtering technique under controlled deposition conditions. The effect of post-deposition annealing on the structural and crystallographic evolution of the films was systematically examined at temperatures of 550°C, 650°C, and 750°C in air. X-ray diffraction (XRD) analysis revealed that the as-deposited films were poorly crystalline. In contrast, progressive annealing resulted in a significant enhancement in crystallinity, accompanied by the formation of a well-defined monoclinic WO₃ phase. Increasing the annealing temperature led to sharper diffraction peaks and larger grain sizes, confirming thermally induced grain growth and improved structural ordering. A noticeable shift of diffraction peaks toward higher 2θ values was observed with Fe incorporation, indicating lattice contraction due to the substitution of W⁶⁺ ions by smaller Fe³⁺ ions, as well as the generation of oxygen vacancies for charge compensation. The average crystallite size increased from 21.6 nm at 550°C to 62.4 nm at 750°C, demonstrating that Fe doping promotes thermally assisted grain coalescence. These results suggest that Fe incorporation effectively alters the lattice parameters and structural stability of WO₃ without creating any secondary Fe-based oxide phases. Overall, these findings provide valuable insights into the relationship between microstructural evolution and dopant-induced modifications in Fe: WO₃ systems, paving the way for optimizing their performance in photocatalytic and gas-sensing applications.

🔖

Cite This Article

Sarıtaş, S. (2025). Structural investigation of the effect of annealing temperature on the Fe:WO3 structure on a silicon substrate. NanoEra, Volume: 5 Issue: 2. https://ajindex.com/articles/1627650

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (11)

  1. Al-Kuhaili MF, Drmosh QA. Investigating the structural and optoelectronic properties of co-sputtered Fe-doped WO3 thin films and their suitability for photocatalytic applications. Mater Chem Phys. 2022;281:125897. doi:10.1016/j.matchemphys.2022.125897
  2. Tesfamichael T, Piloto C, Arita M, Bell J. Fabrication of Fe-doped WO3 films for NO2 sensing at lower operating temperature. Sensors Actuators B Chem. 2015;221:393-400. doi:10.1016/j.snb.2015.06.090
  3. Ramkumar S, Rajarajan G. Effect of Fe doping on structural, optical and photocatalytic activity of WO3 nanostructured thin films. J Mater Sci Mater Electron. 2016;27(2):1847-1853. doi:10.1007/s10854-015-3963-6
  4. Osiac M, Cioatera N, Jigau M. Structural, Morphological, and Optical Properties of Iron Doped WO3 Thin Film Prepared by Pulsed Laser Deposition. Coatings. 2020;10(4):412. doi:10.3390/coatings10040412
  5. Tesfamichael T, Ponzoni A, Ahsan M, Faglia G. Gas sensing characteristics of Fe-doped tungsten oxide thin films. Sensors Actuators B Chem. 2012;168:345-353. doi:10.1016/j.snb.2012.04.032
  6. Chaudhari AK, Singh VB. Mechanical and physical properties of electrodeposited Ni-Fe, WO3 doped nanocomposite. Surf Coatings Technol. 2016;307:683-692. doi:10.1016/j.surfcoat.2016.09.072
  7. Ouadah E, Hamdadou NE, Ammari A. Morphological, Structural and Optical Properties of Fe-Doped WO3 Films Deposited by Spray-Pyrolysis. J Electron Mater. 2022;51(1):356-369. doi:10.1007/s11664-021-09300-0
  8. Dhunna R, Koshy P, Sorrell CC. Effect of Iron Doping on the Mineralogical, microstructural, Optical, and Chemical Properties of WO3 Thin Films. J Aust Ceram Soc Vol. 2015;51(2):18-22.
  9. Yin Y, Lan C, Hu S, Li C. Effect of Gd-doping on electrochromic properties of sputter deposited WO3 films. J Alloys Compd. 2018;739:623-631. doi:10.1016/j.jallcom.2017.12.290
  10. Piloto C, Shafiei M, Khan H, Gupta B, Tesfamichael T, Motta N. Sensing performance of reduced graphene oxide-Fe doped WO3 hybrids to NO2 and humidity at room temperature. Appl Surf Sci. 2018;434:126-133. doi:10.1016/j.apsusc.2017.10.152
  11. Salari MA, Şenay V, Muğlu GM, Sarıtaş S, Kundakçı M. Evaluation of the optical, structural, and morphological characteristics of a Sn-doped α-Fe2O3 thin film fabricated using RF and DC magnetron Co-sputtering technique. Ceram Int. 2025;51(17):23068-23076. doi:10.1016/j.ceramint.2025.02.410