SavedAdd your journal

Journals / Journal of the Turkish Chemical Society Section B: Chemical Engineering / 2024 / Volume: 7 Issue: 2

EFFECT OF BORIC ACID ADDITION ON ANTIBACTERIAL DYE PRODUCTION

Numan Yurtalan(ONDOKUZ MAYIS ÜNİVERSİTESİ)0009-0007-7206-1960
Feza Geyikçi(ONDOKUZ MAYIS ÜNİVERSİTESİ)0000-0003-4789-1026
Gediz Uğuz(ONDOKUZ MAYIS ÜNİVERSİTESİ)0000-0002-6796-6067
Pages
—
Publication Date
2024-10-04
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

The results showed that the antibacterial effect of boric acid did not have a negative effect on the dye quality, but maintained the standard values of the dye.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In this study, the use of interior dyes with antibacterial properties was examined.
📊
Key Findings & Data:Boric acid (H3BO3), which is a cheap and easily obtainable boron compound from our country's resources, has an antibacterial effect.
💡
Conclusion & Impact:The results showed that the antibacterial effect of boric acid did not have a negative effect on the dye quality, but maintained the standard values of the dye.
🔬Design:Research Article
📍Scope:2012 Verileri
⚙️Variables:Waste marble powder · Boric acid · Antibacterial material

Abstract

In this study, the use of interior dyes with antibacterial properties was examined. Boric acid (H3BO3), which is a cheap and easily obtainable boron compound from our country's resources, has an antibacterial effect. Within the scope of the study, firstly, boric acid mixtures were prepared in appropriate concentrations and antibacterial dye production studies were carried out by adding them to indoor dyes. The antibacterial properties of the obtained dye were investigated through the inhibition effect on E. coli bacteria and its antibacterial activity was tested, and then the brightness, density, film thickness, scorching, pencil hardness and drying time tests of the dyes and the suitability of their characteristics to TS 5808/2012 and the applicability of these dyes were evaluated. The results showed that the antibacterial effect of boric acid did not have a negative effect on the dye quality, but maintained the standard values of the dye.

🔖

Cite This Article

Yurtalan, N., Geyikçi, F., Uğuz, G. (2024). EFFECT OF BORIC ACID ADDITION ON ANTIBACTERIAL DYE PRODUCTION. Journal of the Turkish Chemical Society Section B: Chemical Engineering, Volume: 7 Issue: 2. https://doi.org/10.58692/jotcsb.1503140

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (15)

  1. Abbasoğlu, U. (2007). Tests measuring the effectiveness of disinfectants on microorganisms. 5th National Sterilization Disinfection Congress, (pp. 41-62). Ankara.
  2. Akaydın, M., & Kalkancı, M. (2014). A study on the antibacterial properties of fabrics used as hospital garments. Süleyman Demirel University Faculty of Arts and Science Journal of Science, 9(1), 20-34.
  3. Bal, Ş., & Şanlı, N. O. (2020). Evaluation of the effectiveness of antibacterial wall dye in increasing indoor hygiene conditions. Journal of Gazi University Faculty of Engineering and Architecture, 35(4), 1913-1922.
  4. Caliskan, V. (2019). Investigation of Attachments on the Properties of Temporary Coatings of Different Plasticizers. M.Sc. Thesis, Kocaeli University, Institute of Natural and Applied Sciences, Department of Chemical Engineering, Kocaeli, Turkey.
  5. Concia E, Mazzaferri F, Cordioli M (2016). New antibiotic development: Barriers and opportunities. Ital J Med, 10, 255-271.
  6. Ekin, İ. H., & Gülaydın, Ö. (2019). Antimicrobial Activity of Boric Acid Solution Against Listeria monocytogenes and Staphylococcus aureus. Van Veterinary Journal, 163-166.
  7. Uğuz, G. (2019). Investigation Of The Effects Of Different Dienophiles On Dye Properties. Hitit University, Department of Chemical Engineering. Çorum: Institute of Natural and Applied Sciences.
  8. Haesebrouck F, Baele M, De Keyser H, Hermans K, Pasmans F (2009). Antimicrobial activity of an acetic and boric acid solution against Staphylococcus pseudintermedius. Vlaams Diergeneeskundig Tijdschrift, 78 (2), 89-90.
  9. Kapukaya, R., & Külahçı, Ö. (2020). Treatment of Wounds with Tissue Defects with Polyurethane Sponge Containing Boric Acid. Journal Of Boron, 5(2), 83-90.
  10. Kırbaş, C. (2012, FEBRUARY). Architectural-Mechanical Project Design and Application Principles in Hospitals. Installation Engineering (TMMOBTesseat Engineering (TMMOB Chamber of Mechanical Engineers)(127), 15-30.
  11. Kuru, R., & Yarat, A. (2017, September 15). An Updated Look at Boron and Its Effects on Our Health. Clinical and Experimental Health Sciences. dergipark.org.tr, 7(3), 107-115.
  12. Ozkan, E. (2013). Determination of the Structural Properties of the Conductive Dye to be Applied on the New Generation Ceramics. M.Sc. Thesis, Yildiz Technical University, Institute of Natural and Applied Sciences, Department of Chemical Engineering, Istanbul.
  13. Sari, M. (2008). The kinetics of dissolution of different minerals in boric acid solutions. M.Sc. Thesis, Istanbul Technical University, Institute of Natural and Applied Sciences, Department of Chemical Engineering, Istanbul.
  14. Zan R, Hubbezoglu I, Ozdemir AK, Tunç T, Sumer Z, Alıcı O (2013). Antibacterial effect of different concentration of boric acid against Enterococcus faecalis biofilms in root canal. Marmara Dental J, 1 (2), 76-80
  15. Zer, Y., Karabacak, F. N., & Manay, A. B. (2022). Investigation of disinfectant effectiveness of boric acid. Turkish Journal of Hygiene and Experimental Biology, 79(1), 145-152.