Dergiler / Atmospheric Pollution Research / 2020 / Cilt: 11 - Sayı: 6

Experimental study on the improvement of wetting performance of OP-10solution by inorganic salt additives

Sayfa
153–161
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

After adding the inorganic salt additives into OP-10 surfactant solution, the improvement on the dust-reduction efficiency of the respirable dust was more significant than that of the total dust.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Inorganic salt additives can further improve the wetting performance of surfactants, thereby increasing the dust-reduction efficiency of spraying.
📊
Temel Bulgular & Veri:In this study, the improvement on the performance of OP-10 surfactant solutionwas investigated through experiments on surface tension, reverse osmosis, water retention, and dust-reductionefficiency via spraying.
💡
Sonuç & Katkı:After adding the inorganic salt additives into OP-10 surfactant solution, the improvement on the dust-reduction efficiency of the respirable dust was more significant than that of the total dust.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri

Özet

Inorganic salt additives can further improve the wetting performance of surfactants, thereby increasing the dust-reduction efficiency of spraying. In this study, the improvement on the performance of OP-10 surfactant solutionwas investigated through experiments on surface tension, reverse osmosis, water retention, and dust-reductionefficiency via spraying. The experimental results showed that when the concentration of OP-10 solution waslower than CMC, the inorganic salt additives had a certain effect on the surface tension of the solution. With theincrease of the concentration of the additives, the surface tension of the solution continued to decrease. All fourtypes of inorganic salt additives can improve the wetting performance of the surfactant to a certain extent andimproved the reverse osmosis moisture absorption of coal dust. Two types of additives, i.e., CaCl2and Na2SO4,had better performance than the other two types. CaCl2also had good water retention properties, which can slowdown the evaporation of water. After adding CaCl2with a mass fraction of 0.5% in the OP-10 solution, the dust-reduction efficiencies for both the total dust and the respirable were improved to a certain extent. With theincrease of the water supply pressure, the improvement of the dust-reduction efficiency by the Additive was lessobvious. After adding the inorganic salt additives into OP-10 surfactant solution, the improvement on the dust-reduction efficiency of the respirable dust was more significant than that of the total dust.

🔖

Bu Makaleye Atıf Yap

WANG, P., JİANG, Y., LİU, R., LİU, L., HE, Y. (2020). Experimental study on the improvement of wetting performance of OP-10solution by inorganic salt additives. Atmospheric Pollution Research, Cilt: 11 - Sayı: 6, 153–161. https://ajindex.com/articles/151234

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (12)

  1. Ai, H.R., 2014. The change law of dynamic surface tension of surfactant dampening so-lution. J. Yichun Univ. 36, 29–31.
  2. Bao, Q., Nie, W., Liu, C.Q., Zhan, H.H., Wang, H.K., Jin, H., Yan, J.Y., Liu, Q., 2020. Thepreparation of a novel hydrogel based on crosslinked polymers for suppressing coaldusts. J. Clean. Prod. 249, 119343. Bera, A., Kumar, T., Ojha, K., Mandal, A., 2013. Adsorption of surfactants on sand surfacein enhanced oil recovery: isotherms, kinetics and thermodynamic studies. Appl. Surf.Sci. 284, 87–99.
  3. Chen, D.W., Nie, W., Cai, P., Liu, Z.Q., 2018. The diffusion of dust in a fully-mechanizedmining face with a mining height of 7 m and the application of wet dust-collectingnets. J. Clean. Prod. 205, 463–476.
  4. Chen, Y.P., Xu, G., Huang, J.X., Eksteen, J., Liu, X.F., Zhao, Z.D., 2019. Characterizationof coal particles wettability in surfactant solution by using four laboratory static tests.Colloids Surf., A 567, 304–312.
  5. Cybulski, K., Malich, B., Wieczorek, A., 2015. Evaluation of the effectiveness of coal andmine dust wetting. Journal of Sustainable Mining 14, 83–92.
  6. Dong, P., Shan, Z.J., Li, Z., 2004. Study on the surface wet characteristic of ultrafine coalpowder. J. China Coal Soc. 29, 346–349.
  7. Du, J., Zeng, X.C., 2002. An investigation on the variation of critical micelle concentra-tions of CTAB and SDS surfactant influenced by salts. J. Sichuan Univ. 39, 733–736.
  8. Han, H., Wang, P.F., Li, Y.J., Liu, R.H., Tian, C., 2020. Effect of water supply pressure onatomization characteristics and dust-reduction efficiency of internal mixing air ato-mizing nozzle. Adv. Powder Technol. 31, 252–268.
  9. He, G.X., Sun, H.J., Zan, H.T., Wu, H., 2008. Effect of inorganic salt on surface tension ofSDS solution. Chem. Ind. Times 22, 42–44.
  10. Hua, Y., Nie, W., Liu, Q., Peng, H.T., Wei, W.L., Cai, P., 2020. The Development andapplication of a novel multi-radial-vortex-based ventilation system for dust removalin a fully mechanized tunnelling face. Tunn. Undergr. Space Technol. 98, 103253. Kilaua, H.W., Pahlman, J.E., 1987. Coal wetting ability of surfactant solutions and theeffect of multivalent anion additions. Colloid. Surface. 26, 217–242.
  11. Kumar, S., Mandal, A., 2016. Studies on interfacial behavior and wettability changephenomena by ionic and nonionic surfactants in presence of alkalis and salt for en-hanced oil recovery. Appl. Surf. Sci. 372, 42–51.
  12. Li, Y.J., Wang, P.F., Liu, R.H., Gao, R.Z., 2019. Optimization of structural parameters andinstallation position of the