SavedAdd your journal

Journals / International Journal of Automotive Engineering and Technologies / 2017 / Cilt: 6 - Sayı: 3

Investigation of Effect of n-hexane Additives in Biodiesel in Combustion and Exhaust Emissions in Diesel Engines

Mehmet DEMİRALP
Mehmet ÇELİK
İlker ÖRS
Cihan BAYINDIRLI
Pages
140–147
Publication Date
2022-10-18
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

As the n-hexane ratio increases, the emissions of CO, HC and smoke decrease while NOx emissions increase

📌 3 Key Takeaways

🎯
Objective & Hypothesis:There are various studies concerning biodiesel fuel and its spraying, combustion and emission properties within the diesel engines.
📊
Key Findings & Data:In the diesel engines, the hazardous emissions such as carbonmonoxide (CO), carbondioxide (CO2), hydrocarbon (HC) and particle matter (PM) decreased along with the use of biodiesel.
💡
Conclusion & Impact:As the n-hexane ratio increases, the emissions of CO, HC and smoke decrease while NOx emissions increase
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Abstract

There are various studies concerning biodiesel fuel and its spraying, combustion and emission properties within the diesel engines. In the diesel engines, the hazardous emissions such as carbonmonoxide (CO), carbondioxide (CO2), hydrocarbon (HC) and particle matter (PM) decreased along with the use of biodiesel. But a slight increase in azotoxit (NOx) emissions was observed due to the use of biodiesel which is an oxygenated fuel. In this study; by volume 4% 12% and 20% n-hexane were added in biodiesel which produced by transesterification method from cottonseed oil. Engine tests were carried out at 6 min-1. The maximum moment obtained at 1400 min-1. The maximum increase in moment is 3.95% in CHX20 fuel, while the specific fuel consumption is reduced by 5.52%. At 1400 min-1, the maximum of cylinder pressure and heat dissipation is increased by increasing of additive ratio. As the n-hexane ratio increases, the emissions of CO, HC and smoke decrease while NOx emissions increase

🔖

Cite This Article

DEMİRALP, M., ÇELİK, M., ÖRS, İ., BAYINDIRLI, C. (2022). Investigation of Effect of n-hexane Additives in Biodiesel in Combustion and Exhaust Emissions in Diesel Engines. International Journal of Automotive Engineering and Technologies, Cilt: 6 - Sayı: 3, 140–147. https://ajindex.com/articles/540346

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (11)

  1. M. Çelik, “Combustion, performance and exhaust emission characteristics of organic based manganese addition to cotton methyl ester”, Applied Thermal Engineering, vol. 108, pp. 1178–1189, 2016
  2. A. Uyumaz, H. Solmaz, E. Yılmaz, H. Yamık, S. Polat, “Experimental examination of theeffects of military aviation fuel JP-8 and biodiesel fuel blends on the engine performance, exhaust emissions and combustion in a direct injection engine”, Fuel Process. Technol. vol. 128, pp. 158–165, 2014
  3. H. Solmaz, Combustion, performance and emission characteristics of fusel oil in a spark ignition engine, Fuel Process. Technol. vol. 133, pp. 20–28, 2015
  4. C. Sayın, “Diesel engine emissions improvements by the use of sun flower methyl ester /diesel blends”, J. Of Thermal Science and Technology, vol. 33 (2), pp.83- 88, 2013 [5] H.K. Imdadul, H.H Masjuki, M.A. Kalam, N.W.M. Zulkifli, A. Alabdulkarem, M.M. Rashed, A.M. Ashraful, “Influences of ignition improver additive on ternary (dieselbiodiesel-higher alcohol) blends thermal stability and diesel engine performance”, Energy Convers and Manage. vol. 123, pp. 252-264, 2016
  5. C.C. Enweramadu, H.L. Rutto, “Combustion, emission and engine performance characteristics of used cooking oil biodiesel—a review”, Renew. Sustain. Energy Rev. vol. 14, pp. 2863–2873, 2010
  6. B.R. Vahid, M. Haghighi, “Urea-nitrate combustion synthesis of MgO/MgAl2O4 nanocatalyst used in biodiesel production from sunflower oil: Influence of fuel ratio on catalytic properties and performance”, Energy Convers and Manage. vol. 126, pp. 362-372, 2016
  7. M. Olkiewicz, M.P. Caporgno, A. Fortuny, F. Stüber, A. Fabregat, J. Font, C. Bengoa, “Direct liquid–liquid extraction of lipid from municipal sewage sludge for biodiesel production”, Fuel Process. Technol. vol. 128, pp. 331–338, 2014
  8. M. Raita, J. Arnthong, V. Champreda, N. Laosiripojana, “Modification of magnetic nanoparticle lipase designs for biodiesel production from palm oil”, Fuel Process. Technol. vol. 134, pp. 189–197, 2015
  9. A.F.G. Lopes, M.C. Talavera-Prieto, A.G.M. Ferreira, J.B. Santos, M.J. Santos, A.T. G. Portugal, “Speed of sound in pure fatty acid methyl esters and biodiesel fuels”, Fuel, vol. 116, pp. 242–254, 2014
  10. W.J. Thoo, A. Kevric, H.K. Ng, S. Gan, P. Shayler, A.L. Rocca, “Characterisation of ignition delay period for a compression ignition engine operating on blended mixtures of diesel and gasoline”, Appl. Therm. Eng. vol. 66, pp. 55–64, 2014
  11. M. Shahabud