Journals / Gazi Üniversitesi Mühendislik Mimarlık Fakültesi Dergisi / 2007 / Cilt: 22 - Sayı: 3

Experimental investigation of tire pressure and vehicle speed effects on the change of dynamic radius

Lastik hava basıncı ve taşıt hızının dinamik yarıçap değişimine etkilerinin deneysel olarak incelenmesi

Pages
305–311
Publication Date
2022-10-18
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

The results showed that increasing in the tire dynamic radius causes to reduce traction force and hence reduce the traction efficiency indirectly.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Variation of tire dynamic radius is one of the important factors affecting the wheel traction and traction efficiency.
📊
Key Findings & Data:It was seen that dynamic radius increases with increasing of vehicle speed and tire pressure.
💡
Conclusion & Impact:The results showed that increasing in the tire dynamic radius causes to reduce traction force and hence reduce the traction efficiency indirectly.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Abstract

Variation of tire dynamic radius is one of the important factors affecting the wheel traction and traction efficiency. In this experimental study; three tires with the same dimensions but that have different load and velocity index were tested for several tire pressures and vehicle speeds. Influences of speed and tire pressure on the dynamic radius were investigated on a vehicle in laboratory conditions. It was seen that dynamic radius increases with increasing of vehicle speed and tire pressure. However, after 60 km/h of speed, no considerable change was observed. It is known that tire traction force is also changed by changing of tire dynamic radius. The results showed that increasing in the tire dynamic radius causes to reduce traction force and hence reduce the traction efficiency indirectly.

Özet

Lastik dinamik yarıçapı değişimi, çeki kuvvetini ve verimini etkileyen önemli faktörlerden birisidir. Bu deneysel çalışmada; farklı yük ve hız özelliklerine sahip üç lastik değişik lastik basıncı ve taşıt hızlarında denenmiştir. Laboratuar koşullarında taşıt üzerinde yapılan deneysel çalışmalarda hıza bağlı olarak değişik lastik basınçlarının lastik dinamik yarıçapı üzerindeki etkileri incelenmiştir. Hız artışına ve lastik hava basıncı değişimine bağlı olarak tekerlek dinamik yarıçapında artma tespit edilmiştir. Dinamik yarıçapın, yaklaşık 60 km/h taşıt hızından sonra belirgin bir artış göstermediği gözlemlenmiştir. Lastik çeki kuvvetinin ise, dinamik yarıçapın bir fonksiyonu olarak değiştiği bilinmektedir. Bu nedenle; meydana gelen dinamik yarıçap artışı, çeki kuvvetini ve dolayısıyla çeki verimini azaltmaktadır.

🔖

Cite This Article

KOCA, A. (2022). Experimental investigation of tire pressure and vehicle speed effects on the change of dynamic radius. Gazi Üniversitesi Mühendislik Mimarlık Fakültesi Dergisi, Cilt: 22 - Sayı: 3, 305–311. https://ajindex.com/articles/524392

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (12)

  1. Böhler, H., “Simulation of The Dynamic Loads of a Tractor with the Help of a Multi-Body System Program”,http://www.ltm.mw.tum.de/~boehler/is tvs.pdf 07.02.2004
  2. Kuti, I., “Dynamic Analysis of Vehicle Manueuvres on The Basis of The Finite Element Method”, Periodica Polytechnica Ser. Transp. Eng., 29 (1-2): 47-58 (2001)
  3. Shannon L. M., Youngberg B., Millie A., Schweizer P., Gerdes C. J., “Calculating Longitudinal Wheel Slip and Tire Parameters Using GPS Velocity”, The American Control Conference, Arlington, 1800-1805 (2001)
  4. Özen, C., Brisa A.Ş., Kocaeli, [email protected], 30.09.2003
  5. Çelik İ., Dumlupınar Üniversitesi M.M.F., Kütahya, [email protected], (25.06.2004)
  6. Koca, A., “Tekerleklerde Dinamik Yarıçap Değişiminin Çeki Kuvvetine Etkisi”, Fen Bilimleri Enstitüsü, Gazi University, 14 (12):249-259, 2001
  7. Sharma, A.K. and Pandey K.P., “Modelling Power Requirement for Traction Tyres With Zero Sinkage”, Journal of Terramechanics, 34 (1):13-21, 1997
  8. Ichiro, K. and Satoru K., “A Study on Tire Modelling For Camber Thrust and Camber Torque”, Society of Automotive Engineers of Japan Inc, 23, 323-331, 2002
  9. Staudt, W., “Motorlu Taşıt Mekaniği”, Altıparmak D., Milli Eğitim Basımevi, İstanbul, 231-233, 2001
  10. Kiss, P., “Rolling Radius of a Pneumatic Tyre on Deformable Soil”, Biosystems Engineering, 85 (2): 153-161, 2003
  11. Komandi G., “A Kinematic Model for the Determination of the Peripheral Force”, Journal of Terramechanics, 34: 261-268, 1998
  12. Nacar, M., “Pasif Devre Elemanları”, Temel Elektronik, 1-2, İskenderun, 2002.