The time and the load parameter at the onset of yielding in the cylinder are determined while the uniform heat generation is increased in the quasi-static manner.
📌 3 Key Takeaways
🎯
Objective & Hypothesis:In this study, the thermal stresses in a fixed-end cylinder with uniform heat generation under the effect of the radial temperature distribution are investigated.
📊
Key Findings & Data:In this study, the thermal stresses in a fixed-end cylinder with uniform heat generation under the effect of the radial temperature distribution are investigated.
💡
Conclusion & Impact:The time and the load parameter at the onset of yielding in the cylinder are determined while the uniform heat generation is increased in the quasi-static manner.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Isıl gerilme · üniform olmayan sıcaklık dağılımı · Thermal stress
Abstract
In this study, the thermal stresses in a fixed-end cylinder with uniform heat generation under the effect of the radial temperature distribution are investigated. The time and the load parameter at the onset of yielding in the cylinder are determined while the uniform heat generation is increased in the quasi-static manner.
Özet
Bu çalışmada, uçları sabit, içinde iç ısı üretimi olan bir silindirde, zamana bağlı sıcaklık dağılımından kaynaklanan ısıl gerilmeler incelenmiştir. Silindir içerisindeki iç ısı üretimi miktarı yavaş yavaş arttırılarak, hangi yük parametresinde ve hangi zamanda silindirde akmanın başlayacağı belirlenmiştir.
GÜLGEÇ, M., TÜRKBAŞ, S. (2013). THERMAL STRESS ANALYSIS OF A FIXED-END CYLINDER WITH RADIAL TEMPERATURE DISTRIBUTION. Gazi Üniversitesi Mühendislik Mimarlık Fakültesi Dergisi, Cilt: 17 - Sayı: 1, 1–9. https://ajindex.com/articles/21386
Çıtakoğlu, E., “Thermal Stress in a Finite Composite Cylinder with Uniform Energy Generation Under Special BCs”, METU J. Pure Appl. Sci., Cilt 12, -97, 1979.
Gülgeç, M.,”Influence of the Temperature Dependence of the Yield Stress on the Stress Distribution in a Heat Generating Elastic-Plastic Cylinder”, ZAMM, Cilt 79, No 7, 210-218, 1999.
Gülgeç, M. Orçan, M., “Elastic-Plastic Deformation of a Heat Generating Tube with Temperature Dependent Yield Stress”, Int. J. Eng. Science, Cilt 38, No 1, -106, 2000.
Carslaw, H. S., Jaeger, J. C., Conduction of Heat in Solids, 2. Baskı,