Dergiler / Textile and Apparel / 2019 / Cilt: 29 Sayı: 4

EVALUATING THE EFFECT OF WATER-REPELLENT FINISHING ON THERMAL INSULATION PROPERTIES OF ROWING SHIRTS USING A THERMAL MANIKIN

Sayfa
279–288
Yayın Tarihi
2019-12-31
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Moreover, not only the water repellent finishing, but also the structure of garment is also important in terms of heat loss and thermal insulation.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:The activity of rowing is majorly performed outside, namely on rivers or lakes, and the probability of getting the t-shirt wet due to splash or rain is high.
📊
Temel Bulgular & Veri:The shirts were treated with a 5% of a fluorocarbon-based product water repellent finishing.
💡
Sonuç & Katkı:Moreover, not only the water repellent finishing, but also the structure of garment is also important in terms of heat loss and thermal insulation.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Rowing shirts · thermal comfort · thermal manikin

Abstract

The activity of rowing is majorly performed outside, namely on rivers or lakes, and the probability of getting the t-shirt wet due to splash or rain is high. Since nowadays, one of the problems of rivers and lakes is contaminated water, protecting the rower from that contaminated water in order to prevent skin problems is one of the goals of manufacturers. Thus, the necessity of using a water repellent finishing (WRF) treatment on the rowing clothing may be of importance if health is an issue, although it can also change comfort parameters such as thermal behaviour. In order to evaluate the impact of water repellent finishing on the thermal insulation, several rowing shirts made with different structures and raw material were tested and compared by means of a thermal manikin, before and after finishing. The shirts were treated with a 5% of a fluorocarbon-based product water repellent finishing. The heat loss values of rowing shirts were measured by using a thermal manikin and the effective clothing insulation values were calculated. Moreover, the effect of garment design on thermal insulation was investigated by comparing shirts with more than one knitted structure with single knitting structures shirts. Considering the results for the heat loss values, after WRF, the heat flux of rowing shirts was lower. Shirt B and shirt B-1 had higher effective thermal insulation value after WRF, where the other shirts had lower thermal insulation values. Moreover, not only the water repellent finishing, but also the structure of garment is also important in terms of heat loss and thermal insulation.

🔖

Bu Makaleye Atıf Yap

TAMA, D., CATARİNO, A., ABREU, M. J. (2019). EVALUATING THE EFFECT OF WATER-REPELLENT FINISHING ON THERMAL INSULATION PROPERTIES OF ROWING SHIRTS USING A THERMAL MANIKIN. Textile and Apparel, Cilt: 29 Sayı: 4, 279–288. https://ajindex.com/articles/943512

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (9)

  1. Choudhury, A.K.R., Majumdar, P. K. and Datta, C. (2011) Improving Comfort in Clothing, Chapter 1: Factors affecting comfort: human physiology and the role of clothing, The Textile Institute, Woodhead Publishing Limited, England, 459p
  2. Das, A. and Alagirusamy, R. (2010) Science in Clothing Comfort, The Textile Institute, Woodhead Publishing Limited, England, 173p
  3. Li, Y. and Wong, A. S. W. (2006) Clothing Biosensory Engineering, Chapter 1: Introduction to Clothing Biosensory Engineering, The Textile Institute, Woodhead Publishing Limited, England, 381p
  4. Abreu, M. J., Validation of the thermal comfort behaviour of active wear through thermal manikin measurements, CD of Proceedings, Futurotextiles 08 - 2nd International Scientific Conference Textiles of the Future. Kortrijk, Belgium, 2008 5. Abreu, M. J., Catarino, A., Cardoso, C. and Kueblbeck, S. (2012) Influence of Water-repellent Finishing on Outer Water Sportswear Regarding Thermal Insulation, The Fiber Society 2012 Spring Conference, 23-25 May 2012, St. Gallen, Switzerland, pp. 40-42
  5. Abreu, M. J., Braga, I., Duarte, F. - Simulating Human Physiological Response with a Thermal Manikin testing different Non Active Medical Devices, Journal Materials Science Forum, Editora Transtec, Vol. 636-637, p.36-40, 2010, ISSN 0255-5476
  6. Oliveira, A. V. M, Branco, V. J., Gaspar, A. R. and Quintela, D. A. (2008) Measuring Thermal Insulation of Clothing With Different Manikin Control Methods, Comparative Analysis of The Calculation Methods, 7th International Thermal Manikin and Modelling Meeting, University of Coimbra, https://www.adai.pt/7i3m/Documentos_online/papers/ 11.oliveira_portugal.pdf 8. Holmer, I. (2004) Thermal manikin history and applications, European Journal of Applied Physiology, Vol. 92, 6, pp.614-618
  7. Abreu, M. J., Catarino, A., Cardoso, C. and Martin, E. (2011) Effects of Sportswear Design on Thermal Comfort, AUTEX 2011 Conference, 8-10th June, Mulhouse, France, pp. 50-55
  8. Secher, N.H. (1993) Sports Medicine, 15: 24.
  9. McGregor, A. (2015) Injury prevention and performance –are they mutually exclusive? What does science tell us?, BMC Sports Science, Medicine and Rehabilitation, 7 (Suppl 1):O7, doi: 10.1186/2052-1847-7-S1-O7 12. Abreu, M. J., Catarino, A. P. and Haeussermann, N. (2016) Comfort Effects of Weft-knitted Structures on Rowing Shirts Using IR Thermography, The Fiber Society, 2016 Spring Conference, Textile Innovations