Dergiler / Konya Mühendislik Bilimleri Dergisi / 2023 / Cilt: 11 - Sayı: 1

KEKİK YAĞI İLE HAZIRLANMIŞ BİYOPOLİMER KOMPOZİT FİLMLER VE ÖZELLİKLERİNİN İNCELENMESİ

Investigation of the Properties of Biopolymer Composite Films Prepared with Thyme Oil

Sayfa
247–260
Yayın Tarihi
2023-03-01
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Bu değerlerde oldukça düşük bir su buharı geçirgenliğine sahip olduklarını göstermektedir.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Bu çalışmada, tamamen yenilenebilir ve biyolojik olarak parçalanabilen kompozit filmler üretmek için; polimer matris olarak biyobazlı akrilatlanmış epoksitlenmiş soya yağı (AESO) öncelikle antibakteriyel özelliği kanıtlanmış güçlü bir esansiyel yağ olan kekik yağı (KY) farklı oranlarda (ağırlıkça %0, %1, %2, %3, %4, %5) ilave edilerek oluşturulan filmlerin antibakteriyel özellikleri incelenmiş ve en uygun oran belirlenmiştir.
📊
Temel Bulgular & Veri:Bu oran sabit tutularak çalışmanın ikinci aşamasında farklı oranlarda nanokil (ağırlıkça %1, %2, %3, %4, %5 ) ilavesi ile nanokompozit filmler hazırlanmıştır.
💡
Sonuç & Katkı:Bu değerlerde oldukça düşük bir su buharı geçirgenliğine sahip olduklarını göstermektedir.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Kekik yağı · antibakteriyel aktiflik · nanokil

Özet

Bu çalışmada, tamamen yenilenebilir ve biyolojik olarak parçalanabilen kompozit filmler üretmek için; polimer matris olarak biyobazlı akrilatlanmış epoksitlenmiş soya yağı (AESO) öncelikle antibakteriyel özelliği kanıtlanmış güçlü bir esansiyel yağ olan kekik yağı (KY) farklı oranlarda (ağırlıkça %0, %1, %2, %3, %4, %5) ilave edilerek oluşturulan filmlerin antibakteriyel özellikleri incelenmiş ve en uygun oran belirlenmiştir. Bu oran sabit tutularak çalışmanın ikinci aşamasında farklı oranlarda nanokil (ağırlıkça %1, %2, %3, %4, %5 ) ilavesi ile nanokompozit filmler hazırlanmıştır. Elde edilen malzemelerin antibakteriyel aktivite testleri yapılmış, su buharı geçirgenlik özellikleri incelenmiş, ayrıca pH, şişme-çözünürlük-su içeriğine bakılmıştır. Su içerisinde şişme oranı ortalama %0,2437-2,1500 arasında belirlenirken, suda çözünürlük oranı % 0,1550-0,3100 aralığında olmuştur. Su sorpsiyonu ise % 0,6633-0,8917 aralığında değerler almıştır. 72 saat sonunda pH değerleri 7.23-7.29 aralıklarında ölçülmüş ve bu değer cilt pH’ı ile uyumludur. Son olarak su buharı geçirgenliği testinde 1381,9- 2,1357x10-10 g.m/(m2*Pa*s) aralığında değerler kaydedilmiştir. Bu değerlerde oldukça düşük bir su buharı geçirgenliğine sahip olduklarını göstermektedir.

Abstract

In this study, to produce fully renewable and biodegradable composite films; acrylate epoxidized soybean oil (AESO) was used as the polymer matrix. Thyme oil (TO), an essential oil with proven antibacterial properties, was added to this biobased matrix structure at different rates (0, 1, 2, 3, 4, and 5 wt%). The antibacterial properties of the films obtained were examined and the most suitable ratio was determined. The antibacterial properties of the films were investigated and the most suitable TO ratio was determined. In the second stage of the study, the amount of TO was kept constant and nanocomposite films were obtained by adding nanoclay (NC) at different weight ratios (1, 2, 3, 4, and 5 wt%). The antibacterial activity tests of the obtained materials were carried out, their water vapor permeability properties were examined, and also pH, swelling-solubility-water content were examined. While the swelling ratio in water is determined between 0,2437-2,1500%, the water solubility ratio is between 0,1550-0,3100%. In water content, values were in the range of 0,6633-0,8917%. After 72 hours, pH values were measured between 7,23-7,29 and this value is compatible with skin pH. Finally, the values recorded in the range of 1381,9-2,1357x10-10 g.m/(m2*Pa*s) in the water vapor permeability test showed that the films had a very low water vapor permeability.

🔖

Bu Makaleye Atıf Yap

SOYDAL, Ü., GÜNBATTI, F. S. (2023). KEKİK YAĞI İLE HAZIRLANMIŞ BİYOPOLİMER KOMPOZİT FİLMLER VE ÖZELLİKLERİNİN İNCELENMESİ. Konya Mühendislik Bilimleri Dergisi, Cilt: 11 - Sayı: 1, 247–260. https://ajindex.com/articles/884122

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (12)

  1. A. Yasmin, J.J. Luo, J.L. Abot, and I.M. Daniel, “Mechanical and thermal behaviour of clay/epoxy nanocomposites”, Composites Science and Technology, vol. 66, pp. 2415-2422, 2006
  2. V.Mittal, “Bio-nanocomposites: future high-value material”, in Nanocomposites with Biodegradable Polymers: Synthesis, Properties and Future Perspectives, V. Mittal, Ed., Oxford University Press, Oxford, 2011, pp. 1-27
  3. H. Salam, and Y. Dong, “Property evaluation and material characterization of soybean oil modified bioepoxy/clay nanocomposites for environmental sustainability”, Materials Today Sustainability, vol. 5, e100012, 2019
  4. V. Tanrattanakul, and P. Saithai, “Mechanical properties of bioplastics and bioplastic-organoclay nanocomposites prepared from epoxidized soybean oil with different epoxide contents”, Journal of Applied Polymer Science, vol. 114, no. 5, pp. 3057-3067, 2009
  5. A. Ammar, A.W.M. Iling, K. Ramesh, and S. Ramesh, “Development of fully organic coating system modified with epoxidized soybean oil with superior corrosion protection performance”, Progress in Organic Coatings, vol. 140, e105523, 2020
  6. S. J. Park, F. L. Jin, and J. R. Lee, “Synthesis and thermal properties of epoxidized vegetable oil”, Macromolecular Rapid Communications, vol. 25, no. 6, pp. 724- 727, 2004
  7. H. Uyama, M. Kuwabara, T. Tsujimoto, M. Nakano, A. Usuki, and S. Kobayashi, “Organic-inorganic hybrids from renewable plant oils and clay”, Macromolecular Bioscience, vol. 4, no. 3, pp. 354-360, 2004
  8. X. Ge, L. Yu, Z. Liu, H. Liu, Y. Chen, and L. Chen, “Developing acrylated epoxidized soybean oil coating for improving moisture sensitivity and permeability of starch-based film”, International Journal of Biological Macromolecules, vol. 125, pp. 370-375, 2019
  9. C. Zhang, M. Yan, E.W. Cochran, and M.R. Kessler, “Biorenewable polymers based on acrylated epoxidized soybean oil and methacrylated vanillin”, Materials Today Communications, vol. 5, pp. 18-22, 2015
  10. E. Baştürk, T. Inan, and A. Güngör, “Flame retardant UV-curable acrylated epoxidized soybean oil based organic–inorganic hybrid coating”, Progress in Organic Coatings, vol. 76, pp. 985-992, 2013
  11. L.Q. Carrillo, S. Duart, N. Montanes, S. T. Giner, and R. Balart, “Enhancement of the mechanical and thermal properties of injection-molded polylactide parts by the addition of acrylated epoxidized soybean oil”, Materials and Design, vol. 140, pp. 54-63, 2018
  12. Y. Hu, P. Jia, Q. Shang, M. Zhang,G. Feng, C.