KaydedilenlerDerginizi ekleyin

Dergiler / International Journal of Innovative Research and Reviews / 2018 / Cilt: 2 - Sayı: 2

Numerical Analysis of Heat Transfer of Hot Oil and Cold Water Fluids in a Concentric Type Heat Exchanger with Ansys Fluent

Mansour NASİRİ KHALAJİ
Muhammet Harun OSTA
Kenan YAKUT
Sayfa
24–27
Yayın Tarihi
2018-12-15
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

The numerical re-sults and mesh validations are shown below.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:In this study, the heat transfer performance of a trunk pipe heat exchanger using motor oil as hot fluid and cold water as cold fluid was analyzed by a compu-tational fluid dynamic (An-sys Fluent) program.
📊
Temel Bulgular & Veri:The engine oil heat exchanger at different temperature rang-es (70C) and at different velocity (0.1m/s).
💡
Sonuç & Katkı:The numerical re-sults and mesh validations are shown below.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Engine oil · CFD · Heat exchanger

Abstract

In this study, the heat transfer performance of a trunk pipe heat exchanger using motor oil as hot fluid and cold water as cold fluid was analyzed by a compu-tational fluid dynamic (An-sys Fluent) program. The engine oil heat exchanger at different temperature rang-es (70C) and at different velocity (0.1m/s). Same case, the cold water at dif-ferent temperature ranges of the heat exchanger (5C) and different speed (1m/s) enters. The numerical re-sults and mesh validations are shown below.

🔖

Bu Makaleye Atıf Yap

KHALAJİ, M. N., OSTA, M. H., YAKUT, K. (2018). Numerical Analysis of Heat Transfer of Hot Oil and Cold Water Fluids in a Concentric Type Heat Exchanger with Ansys Fluent. International Journal of Innovative Research and Reviews, Cilt: 2 - Sayı: 2, 24–27. https://ajindex.com/articles/767590

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (6)

  1. Galeazzo FCC, Miura RY, Gut JAW, Tadini CC. Experimental and numerical heat transfer in a plate heat exchanger. Chemical Engineering Science (2006) 61(21):7133–7138. doi:10.1016/j.ces.2006.07.029
  2. Mussard M, Nydal OJ. Comparison of oil and aluminum-based heat storage charged with a small-scale solar parabolic trough. Applied Thermal Engineering (2013) 58(1-2):146–154. doi:10.1016/j.applthermaleng.2013.03.059
  3. Pacio J, Singer C, Wetzel T, Uhlig R. Thermodynamic evalua-tion of liquid metals as heat transfer fluids in concentrated so-lar power plants. Applied Thermal Engineering (2013) 60(1-2):295–302. doi:10.1016/j.applthermaleng.2013.07.010
  4. Terekhov VI, Pakhomov MA. Numerical study of heat transfer in a laminar mist flow over a isothermal flat plate. Internatio-nal Journal of Heat and Mass Transfer (2002) 45(10):2077–2085. doi:10.1016/S0017-9310(01)00318-0
  5. Diaz GC. Simulation and Control of Heat Exchangers Using Artificial Neural Networks. PhD Thesis. University of Notre Dame. Notre Dame, Indiana (2000) [cited 2018 Dec 17]. 179 p. Available from:
  6. Wang Q-W, Lin M, Zeng M. Effect of lateral fin profiles on turbulent flow and heat transfer performance of internally fin-ned tubes. Applied Thermal Engineering (2009) 29(14-15):3006–3013. doi:10.1016/j.applthermaleng.2009.03.016.