Dergiler / Tekstil ve Konfeksiyon / 2015 / Cilt: 25 - Sayı: 2

PAMUK BİTKİSİNDEN ELDE EDİLEN SAK LİFLERİNİN TERBİYESİNİN OPTİMİZASYONU

PARAMETERS OPTIMIZATION FOR DEGUMMING OF COTTON-STRAW BAST FIBER

Sayfa
135–139
Yayın Tarihi
2015-12-01
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Optimum technological parameters of second boiling for degumming of cotton-straw base fiber were alkaline content 12g/L, hydrogen peroxide content 17g/L, temperature 80 , and time 60min by using the fuzzy comprehensive evaluation

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Abstract: As a bast fiber, cotton-straw bast fiber consists of cellulosic and non-cellulosic substances, such as hemicellulose, pectin, lignin, and wax, and these noncellulosic substances affect the application of cotton-straw base fiber.
📊
Temel Bulgular & Veri:Alkali-H2O2 treatment does not only remove hemicellulose, lignin and pectin effectively, but bleach fiber as well.
💡
Sonuç & Katkı:Optimum technological parameters of second boiling for degumming of cotton-straw base fiber were alkaline content 12g/L, hydrogen peroxide content 17g/L, temperature 80 , and time 60min by using the fuzzy comprehensive evaluation
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Cotton-straw bast fiber · degumming · orthogonal experimental

Abstract

Abstract: As a bast fiber, cotton-straw bast fiber consists of cellulosic and non-cellulosic substances, such as hemicellulose, pectin, lignin, and wax, and these noncellulosic substances affect the application of cotton-straw base fiber. Alkali-H2O2 treatment does not only remove hemicellulose, lignin and pectin effectively, but bleach fiber as well. Through orthogonal experimental, the degumming for first boiling and second boiling of alkali-H2O2 was investigated. Experimental results showed that the optimum combination of parameters for first boiling was 8g/L NaOH, 9g/L H2O2, 1:100 bath ratio and 30min treatment time by using mathematical statistic analysis. Optimum technological parameters of second boiling for degumming of cotton-straw base fiber were alkaline content 12g/L, hydrogen peroxide content 17g/L, temperature 80 , and time 60min by using the fuzzy comprehensive evaluation

🔖

Bu Makaleye Atıf Yap

LI, L., SHENG, G., WANG, Q. (2015). PAMUK BİTKİSİNDEN ELDE EDİLEN SAK LİFLERİNİN TERBİYESİNİN OPTİMİZASYONU. Tekstil ve Konfeksiyon, Cilt: 25 - Sayı: 2, 135–139. https://ajindex.com/articles/46159

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (11)

  1. Gassan J., Bledzki A.K., 1997, “The Influence of Fiber Surface Treatment on the Mechanical Properties of Jute Polypropylene Composites”, Composites: Part A, Vol. 28A(12), pp. 1001-1005
  2. Bledzki A.K., Gassan J., 1999, “Composites Reinforced with Cellulose Based Fiber”, Progress in Polymer Science, Vol. 24(2), pp.221-274
  3. Gautam S, Arup C., 2008, “Dynamic Mechanical and Thermal Properties of PE-EPDM Based Jute Fiber Composites”, Journal of Applied Polymer Science, Vol. 108(6), pp.3442-3453
  4. Li L., Sheng G.Z., Wu L., 2008, “Development and Utilization of Cotton Bast Fibers resource”, Plant Fiber Science in China, Vol.30(4), pp.204-206
  5. Liu L. 2010, “Investigation on the Spinning Technology and Yarn Property of treated cotton-straw bast fibers/cotton”, Thesis of Xi’an Polytechnic University, China, pp.27-42 6. Jinhua W., Ramaswamy G. N., 2003, “One-Step Processing and Bleaching of Mechanically Separated Kenaf Fibers: Effects on Physical and Chemical Properties”, Textile Research Journal, Vol. 73(4), pp. 339-344
  6. Akin D.E., Dodd R.B., Perkins W., Henriksson G., 2000, “Spray Enzymatic Retting: A New Method for Processing Flax Fibers”, Textile Research Journal, Vol.70(6), pp.486-494
  7. Henriksson G., Akin D.E., Rigsby L.L., Patel N., 1997, “Influence of Chelating Agents and Mechanical Pretreatment on Enzymatic Retting of Flax”, Textile Research Journal, Vol. 67(11), pp.829-836
  8. Wang H.M., Postle R., Kessler R.W., 2003, “Removing Pectin and Lignin During Chemical Processing of Hemp for Textile Applications”, Textile Research Journal, Vol. 73(8),pp.664-669
  9. Henriksson G., Eriksson K.E.L., Akin D.E., 1998, “Chemical/Physical Retting of Flax Using Detergent and Oxalic Acid at High pH”, Textile Research Journal, Vol.68(12), pp.942-947
  10. Romanoschi O., Romanoschi S., Collier J.R., and Collier B.J., 1997, “Kenaf Alkali Processing”, Cellulose Chemistry and Technology, Vol.31(5-6), pp.347-359 12. Hyung-Min C., 2002, “One-Bath Dyeing and Nonformaldehyde Durable Press Finishing of Cotton Using Dialdehyde and a Monochlorotriazinyl Reactive Dye”, Textile Research Journal, Vol. 72(6), pp. 469-473
  11. Yang S.H., 2001, “Plant Fiber Chemical”, China Light Industry Press, Beijing, China, 55 14. Jiang F.C., Shao K., Jiang Y., 1989, “Ramie Spinning”, Textile Industry Press, Beijing, China, 53 15. Qu L.J., Zhu S.F., Liu M. J., and Wang S.Y., 2005, “The Mechanism and Technology Parameters Optimization of Alkali-H2O2 One–Bath Cooking and Bleaching of Hemp