KaydedilenlerDerginizi ekleyin

Dergiler / Research on Engineering Structures and Materials / 2018 / Cilt: 4 - Sayı: 2

Thermo-hydraulic performance analyses of water based CuO-SiO2 hybrid nanofluid flow in a horizontal straight tube

Toygun DAGDEVİR
Orhan KEKLİKÇİOĞLU
Veysel ÖZCEYHAN
Sayfa
91–102
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

However, due to better hydraulic properties of SiO2 than CuO, the higher volume fraction of SiO2 compared to CuO, the higher thermo-hydraulic performance was obtained.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:This study presents a numerical investigation of volume fraction effect of water based hybrid CuO-SiO2 nanofluid in a horizontal tube on thermal performance.
📊
Temel Bulgular & Veri:Fully developed turbulent flow was ensured with adjusting solution domain. k-epsilon turbulent model was chosen to simulate turbulent flow, and analyses were implemented for Reynolds number ranging from 10,000 to 50,000.
💡
Sonuç & Katkı:However, due to better hydraulic properties of SiO2 than CuO, the higher volume fraction of SiO2 compared to CuO, the higher thermo-hydraulic performance was obtained.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri

Özet

This study presents a numerical investigation of volume fraction effect of water based hybrid CuO-SiO2 nanofluid in a horizontal tube on thermal performance. Uniform heat flux was applied onto the outer surface of the test tube. Fully developed turbulent flow was ensured with adjusting solution domain. k-epsilon turbulent model was chosen to simulate turbulent flow, and analyses were implemented for Reynolds number ranging from 10,000 to 50,000. The nanofluid flow was assumed as single phase, and properties of nanoparticles and water are concerned as independent in temperature. Thermo-physical properties of nanofluid were calculated with commonly used equations and correlations in literature. Nanoparticle volume fractions in water were employed as 5, 4, 3, and 2% in which each volume fraction is different value of CuO and SiO2. As a result, since CuO is more effective thermal properties than SiO2, it is observed that greater volume fraction of CuO than SiO2 shows better heat transfer performance. Moreover, the highest Nusselt number is obtained for 1%CuO-4%SiO2 water based nanofluid for Reynolds number of 50,000. However, due to better hydraulic properties of SiO2 than CuO, the higher volume fraction of SiO2 compared to CuO, the higher thermo-hydraulic performance was obtained.

🔖

Bu Makaleye Atıf Yap

DAGDEVİR, T., KEKLİKÇİOĞLU, O., ÖZCEYHAN, V. (2018). Thermo-hydraulic performance analyses of water based CuO-SiO2 hybrid nanofluid flow in a horizontal straight tube. Research on Engineering Structures and Materials, Cilt: 4 - Sayı: 2, 91–102. https://ajindex.com/articles/302664

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (8)

  1. B.C. Pak and Y.I. Choi, "Hydrodynamic and Heat Transfer Study of Dispersed Fluids with Submicron Metallic Oxide Particles" Exp. Heat Transfer, 2016;11: 151–170. https://doi.org/10.1080/08916159808946559
  2. N. Bozorgan, K. Krishnakumar, N. Bozorgan, "Numerical Study on Application of CuOwater Nanofluid in Automotive Diesel Engine Radiator" Modern Mechanical Engineering, 2012; 2: 130-136. https://doi.org/10.4236/mme.2012.24017 W. Duangthongsuk and S. Wongwises, "An Experimental Study on the Heat Transfer Performance And Pressure Drop of Tio2-Water Nanofluids Flowing Under a Turbulent Flow Regime," Int. Journal of Heat and Mass Transfer, 2010; 53: 334-344. https://doi.org/10.1016/j.ijheatmasstransfer.2009.09.024
  3. B. Sahin, G. G. Gultekin, E. Manay, S. Karagoz, "Experimental Investigation of Heat Transfer and Pressure Drop Characteristics of Al2O3-water nanofluid," Experimental Thermal and Fluid Science, 2013; 50: 21–28. https://doi.org/10.1016/j.expthermflusci.2013.04.020
  4. A. Celen, N. Kayaci, A. Cebi, H. Demir, A. S. Dalkilic, S. Wongwises "Numerical Study on Application of CuO-water Nanofluid in Automotive Diesel Engine Radiator" Modern Mechanical Engineering, 2012; 2: 130-136. https://doi.org/10.4236/mme.2012.24017
  5. A. Moghadassi, E. Ghomi, F. Parvizian, "A Numerical Study of water based Al2O3 and Al2O3-Cu Hybrid Nanofluid Effect on Forced Convective Heat Transfer" Int. Journal of Thermal Sciences, 2015; 92: 50-57. https://doi.org/10.1016/j.ijthermalsci.2015.01.025
  6. H. K. Dawood, H.A. Mohammed, N. A. C. Sidik, K.M. Munisamy, "Numerical Investigation of Heat Transfer and Fricition Factor Characteristics of Laminar and Turbulent Flow in anElliptic Annulus Utilizing Nanofluid "Int. Comm. In Heat and Mass Transfer,2015; 66: 148157. O. A. Akbari, M.R. Safaei, M. Goodarzi, N.S. Akbar, M. Zarringhalam, G.A.S. Shabani, M. Dahari, "A modified two-phase mixture model of nanofluid flow and heat transfer in a 3-D curved microtube" Advanced Powder Technology, 2016; 27 (5): 2175-2175. https://doi.org/10.1016/j.apt.2016.08.002
  7. H. Alipour, A. Karimipour, M.R. Safaei, D.T. Semiromi, O.A. Akbari, "Influence of T-semi attached rib on turbulent flow and heat transfer parameters of a silver-water nanofluid with different volume fractions in a three-dimensional trapezoidal microchannel", Physica E: Low-dimensional Systems and Nanostructures, 2017; 88: 60-76 https://doi.org/10.1016/j.physe.2016.11.021
  8. Z. Nikkhah, A. Karimipour, M. R. Safaei, P.Forghani-Tehrani, M. Goodarzi, M. Dahari,