Dergiler / Gazi University Journal of Science / 2017 / Cilt: 30 - Sayı: 4

Adsorption Study of Kinetics and Equilibrium of Basic Dye on Kola Nut Pod Carbon

Sayfa
86–102
Yayın Tarihi
2017-12-11
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Kola nut pod is a good precursor for producing cheap and highly efficient activated carbon.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:The effect of adsorption parameters such as pH, initial concentration, adsorbent dose and contact time, and adsorption kinetics and isotherm of Fuchsine basic (FB) dye removal by acid activated kola nut pod carbon (KPAC) and base activated kola nut pod carbon (KPBC) was observed in this study.
📊
Temel Bulgular & Veri:Result obtained suggested that the pseudo-second order model fitted the adsorption data than the pseudo-first order model, as gathered from their regression coefficients (R2) and rate constants (K).
💡
Sonuç & Katkı:Kola nut pod is a good precursor for producing cheap and highly efficient activated carbon.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Activated carbon · Adsorption · Fuchsine basic

Abstract

The effect of adsorption parameters such as pH, initial concentration, adsorbent dose and contact time, and adsorption kinetics and isotherm of Fuchsine basic (FB) dye removal by acid activated kola nut pod carbon (KPAC) and base activated kola nut pod carbon (KPBC) was observed in this study. Pseudo-first order model and pseudo-second order model was the selected kinetics model. Result obtained suggested that the pseudo-second order model fitted the adsorption data than the pseudo-first order model, as gathered from their regression coefficients (R2) and rate constants (K). Langmuir isotherm model and Freundlich isotherm model were used in fitting the experimental data, and the regression coefficients (R2) of Langmuir isotherm shows that it better described the adsorption isotherm of FB dye adsorption using the produced activated carbons than the Freundlich isotherm model. Experimental result also showed that the adsorption of FB dye using KPAC and KPBC is dependent on pH, initial concentration, adsorbent dose and contact time. Kola nut pod is a good precursor for producing cheap and highly efficient activated carbon.

🔖

Bu Makaleye Atıf Yap

NWODİKA, C., ONUKWULİ, D. O. (2017). Adsorption Study of Kinetics and Equilibrium of Basic Dye on Kola Nut Pod Carbon. Gazi University Journal of Science, Cilt: 30 - Sayı: 4, 86–102. https://ajindex.com/articles/254867

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (14)

  1. Ahmad, M.A. and Rahman, N.K., “Equilibrium, kinetics and thermodynamic of Remazol Brilliant Orange 3R dye adsorption on coffee husk-based activated carbon”, Chem. Eng. J., 170: 154–161, (2011).
  2. Ahmadpour, A., “The preparation of activated carbon from macadamia nutshell by chemical activation”, Carbon, 35: 1723–1732, (1997).
  3. Aljeboree, A.M., Alshirifi, A.N. and Alkaim, A.F., “Kinetics and equilibrium study for the adsorption of textile dyes on coconut shell activated carbon”, Arabian Journal of Chemistry, http://dx.doi.org/10.1016/j.arabjc.2014.01.020, (2014).
  4. Arivoli, S., Hema, M. and Prasath, P.M.D., “Adsorption of malachite green onto carbon produced from borassus bark”, The Arabian Journal for Science and Engineering, 34(2A): 31–42, (2009).
  5. Armagan, B., and Toprak, F. “Optimum isotherm parameters for reactive azo dye on pistachio nut shells: Comparison of linear and nonlinear methods”, Pol. J. Environ. Stud., 22(4): 1007–1011, (2013).
  6. Ayanda, O.S., Adeyi, O., Durojaiye, B. and Olafisoye, O., “Adsorption kinetics and intra-particulate diffusivities of congo red onto kola nut pod carbon”, Pol. J. Environ. Stud., 21(5): 1147–1152, (2012).
  7. Banat, F. and Al-Bastaki, N., “Treating dye wastewater by an integrated process of adsorption using activated carbon and ultrafiltration”, Desalination, 170: 69–75, (2004).
  8. Bhole, V. and Ramteke, D.S., “Preferential adsorption of heavy metals on activated carbon”, Bangladesh Journal of Sci. and Industrial Research, 46(2): 211–218, (2011).
  9. Burdock, G.A., Carabin, G.I.G. and Crincoli, C.M., “Safety assessment of kola nut extract as a food ingredient”, Food and Chemical Toxicology, 47(8): 1725–1732, (2009).
  10. Chandra, T.C., Mirna, M.M., Sudaryanto, Y. and Ismadji, S., “Adsorption of basic dye onto activated carbon prepared from durian shell: Studies of adsorption equilibrium and kinetics”, Chemical Engineering Journal, 127(1-3): 121–129, (2007).
  11. El-Wakil, A.M., Abou El-Maaty, W.M., Awad, F.S. and Oudah, A.A., “Solid phase extraction and determination of cationic azo dye from aqueous solution using dried papyrus plant”, International Journal of Science and Research (IJSR), 4(2): 2045–2052, (2015).
  12. Figueiredo, J.L., Sousa, P.S., Orge, C.A., Pereira, M.F.R. and Orfao, J.J.M., “Adsorption of dyes on carbon xerogels and templated carbon influence of surface chemistry”, Adsorption, 17(3): 431–441, (2000).
  13. Freundlich, H. and Heller, W., “The adsorption of cis- and transazobenzene”, J. Am. Chem. Soc, 61: 2228–2230, (1939).
  14. Golob, V.,