Dergiler / Dokuz Eylül Üniversitesi Mühendislik Fakültesi Fen ve Mühendislik Dergisi / 2019 / Cilt: 21 - Sayı: 63

Farklı Kalınlıkta UYPB Laminelerin Eğilme Kapasitesine Katkısının İncelenmesi

Investigate the Influence of Different UHPC Laminates Thickness to the Flexural Capacity

Sayfa
1015–1026
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

UYPB plaka ile güçlendirilmiş numunelerde yük taşıma kapasitesinde %20 ila %58 arasında değişen oranlarda artış elde edilmiştir.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Çalışmada, ultra yüksek performanslı beton (UYPB) plakalarla güçlendirilmiş eğilme dayanımı yetersiz betonarme kirişlerin davranışı deneysel olarak incelenmiştir.
📊
Temel Bulgular & Veri:Güçlendirme amacıyla kullanılacak plakaların imalatı için %3 fiber hacmine sahip UYPB kullanılmıştır.
💡
Sonuç & Katkı:UYPB plaka ile güçlendirilmiş numunelerde yük taşıma kapasitesinde %20 ila %58 arasında değişen oranlarda artış elde edilmiştir.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Ultra Yüksek Performanslı Beton · Betonarme Kiriş · Güçlendirilmiş Kirişte Eğilme Davranışı

Özet

Çalışmada, ultra yüksek performanslı beton (UYPB) plakalarla güçlendirilmiş eğilme dayanımı yetersiz betonarme kirişlerin davranışı deneysel olarak incelenmiştir. Güçlendirme amacıyla kullanılacak plakaların imalatı için %3 fiber hacmine sahip UYPB kullanılmıştır. Bir tanesi kontrol numunesi olmak üzere, kalınlık değişiminin eğilme davranışı üzerindeki etkilerini gözlemlemek amacıyla 3 farklı kalınlıkta UYPB plaka üretilmiş (30 mm, 50 mm ve 70 mm) ve plakalar betonarme kirişlere uygulanmıştır. Kirişler, dört noktalı eğilme yükleri altında test edilmiştir. UYPB plaka ile güçlendirilmiş numunelerde yük taşıma kapasitesinde %20 ila %58 arasında değişen oranlarda artış elde edilmiştir.

Abstract

The aim of this study is to investigate behavior of reinforced concrete beams with insufficient flexural strength which are reinforced by ultra high performance concrete (UHPC) were examined experimentally. UYPC with 3% fiber volume was used for manufacturing laminates which will be used for reinforcing. UHPC having three different thickness (30 mm, 50 mm and 70 mm) where one of them will be control sample was used for observing effect of change in thickness over flexural behavior were manufactured and applied over reinforced concrete beams. RC Beams were tested under four -point bending loads. Increase in load carrying capacity varying with 20%-58% rates were obtained in samples which were reinforced with UHPC.

🔖

Bu Makaleye Atıf Yap

SAĞIR, E. G., TANARSLAN, H. M., JAHANGİRİ, R., YALÇINKAYA, Ç. (2019). Farklı Kalınlıkta UYPB Laminelerin Eğilme Kapasitesine Katkısının İncelenmesi. Dokuz Eylül Üniversitesi Mühendislik Fakültesi Fen ve Mühendislik Dergisi, Cilt: 21 - Sayı: 63, 1015–1026. https://ajindex.com/articles/166951

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (10)

  1. Tanarslan H.M., Alver N., Jahangiri R., Yalçınkaya Ç., Yazıcı H. 2017. Flexural strengthening of RC beams using UHPFRC laminates: Bonding techniques and rebar addition. Construction and Building Materials DOI:155 (2017) 45–55 Tanarslan H.M. 2017, Flexural strengthening of RC beams with prefabricated ultra high performance fibre reinforced concrete laminates, Engineering Structures DOI:151 (2017) 337–348
  2. Oehlers D.J., Reinforced concrete beams with plates glued to their soffits, J.Struct. Eng. 118 (1992) 2023–2038, http://dx.doi.org/10.1061/(ASCE)0733-9445(1992) 118:8(2023).
  3. Souza R.H.F., Appleton J., Flexural behaviour of strengthened reinforced concrete beams, Mater. Struct. 30 (1997) 154–159, http://dx.doi.org/10.1007/BF02486387.
  4. Yurdakul Ö., Avsar Ö., Strengthening of substandard reinforced concrete beamcolumn joints by external post-tension rods, Eng. Struct. 107 (2016) 9–22, http://dx.doi.org/10.1016/j.engstruct.2015.11.004.
  5. Altun F., An experimental study of the jacketed reinforced-concrete beams under bending, Constr. Build. Mater. 18 (2004) 611–618, http://dx.doi.org/10.1016/j.conbuildmat.2004.04.005.
  6. Alhadid M.M.A., Youssef M.A., Analysis of reinforced concrete beams strengthened using concrete jackets, Eng. Struct. 132 (2017) 172–187, http://dx.doi.org/10.1016/j.engstruct.2016.11.014.
  7. Tetta Z.C., Koutas L.N., Bournas D.A., Textile-reinforced mortar (TRM) versus fiber-reinforced polymers (FRP) in shear strengthening of concrete beams, Compos. Part B Eng. 77 (2015) 338–348, http://dx.doi.org/10.1016/j.compositesb.2015.03.055.
  8. Spadea G., Bencardino F., Swamy R.N., Structural behavior of composite rc beams with externally bonded CFRP, J. Compos. Constr. 2 (1998) 132–137, http://dx.doi.org/10.1061/(ASCE)1090-0268(1998) 2:3(132). Lamanna A.J., Bank L.C., Scott D.W., Flexural strengthening of reinforced concrete beams by mechanically attaching fiber-reinforced polymer strips, J. Compos. Constr. 8 (2004) 203–210, http://dx.doi.org/10.1061/(ASCE)1090-0268(2004) 8:3(203). Al-Saidy A.H., Saadatmanesh H., El-Gamal S., Al-Jabri K.S., Waris B.M., Structural behavior of corroded RC beams with/without stirrups repaired with CFRP sheets, Mater. Struct. 49 (2016) 3733–3747, http://dx.doi.org/10.1617/s11527-015-0751-y.
  9. Brühwiler, E. Rehabilitation and strengthening of concrete structures using Ultra-High Performance Fibre Reinforced Concrete, Concrete Repair, Rehabilitation and Retrofi tting III – Alexander et al. (eds), 2008.
  10. Kang S.-T., Ryu G.-S., The effect of s