Dergiler / Electrica / 2006 / Cilt: 6 Sayı: 1

STUDY ON THE DRIVING MODEL OF ULTRASONIC MOTOR

Sayfa
1–6
Yayın Tarihi
2012-01-02
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

And then the effects of the motor's parameters on its performance are investigated, which will be helpful to the design of the ultrasonic motor.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:The interface contact model between the stator and the rotor of traveling wave ultrasonic motor is presented, assuming that the rigid stator contacts the flexible rotor over an area, and the frictional material is regarded as distributed linear spring and without shearing deformation, from which the mechanical characteristic of the motor and the interface transmission efficiency are derived.
📊
Temel Bulgular & Veri:The interface contact model between the stator and the rotor of traveling wave ultrasonic motor is presented, assuming that the rigid stator contacts the flexible rotor over an area, and the frictional material is regarded as distributed linear spring and without shearing deformation, from which the mechanical characteristic of the motor and the interface transmission efficiency are derived.
💡
Sonuç & Katkı:And then the effects of the motor's parameters on its performance are investigated, which will be helpful to the design of the ultrasonic motor.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Ultrasonic motor · Driving model

Abstract

The interface contact model between the stator and the rotor of traveling wave ultrasonic motor is presented, assuming that the rigid stator contacts the flexible rotor over an area, and the frictional material is regarded as distributed linear spring and without shearing deformation, from which the mechanical characteristic of the motor and the interface transmission efficiency are derived. And then the effects of the motor's parameters on its performance are investigated, which will be helpful to the design of the ultrasonic motor.

🔖

Bu Makaleye Atıf Yap

HUAFENG, L., CHUNSHENG, Z., CHENGLIN, G. (2012). STUDY ON THE DRIVING MODEL OF ULTRASONIC MOTOR. Electrica, Cilt: 6 Sayı: 1, 1–6. https://ajindex.com/articles/1017612

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (5)

  1. R. F. Fung, C. M. Yao, D. G. Chang. “Dynamic and Contact Analysis of a Bimodal Ultrasonic Motor”. IEEE Trans. on Ultrasonics, Ferroelectrics, and Frequency Control, 1999(1): 47-60
  2. Lu F, Lee H.P, Lim S.P. “Contact modeling of viscoelastic friction layer of traveling wave ultrasonic motors”. Smart Materials and Structures, 2001(2): 314 Takashi Maeno, David B. Bogy. “Effect of the Rotor/Stator Interface Condition Including Contact Type, Geometry, and Material on the Performance of Ultrasonic Motors”. Journal of Tribology, October: 726-732
  3. Takashi Maeno, Takayuki Tsukimoto. “Finite-element analysis of the rotor/stator contact in a ring-type ultrasonic motor”. IEEE. Ultrasonics, Ferroelectrics and Frequency Ccontrol. 1992(6): 668-674
  4. Takashi Maeno, David B. Bogy. “Effect of the hydrodynamic bearing on rotor/stator contact in a ring-type ultrasonic motor”. IEEE. Ultrasonics, Ferroelectrics and Frequency Ccontrol. 1992(6): 675-682
  5. Takashi Maeno, David B. Bogy. “FE Analysis and LDA Measurement of the Dynamic Rotor/Stator Contact in a Ring- Type Ultrasonic Motor”. Journal of Tribology, October 1993: 625-631 Wen shizhu. Tribology. Press of Peking university, 1990 Li Huafeng, a postdoctoral at Nanjing University of Aeronautics And Astronautics, nanjing, China. He was born in 1974 and obtained his Bachelor’s Degree and Doctor’s Degree of Engineering at HUST, June 1997 and June 2002 respectively. His research field is ultrasonic motor and its control system. Tel:+86-025-84893901 E-mail: [email protected] Zhao Chunsheng, Professor, University of Aeronautics And Astronautics, nanjing, China. He was