Journals / Gazi University Journal of Science Part A: Engineering and Innovation / 2022 / Cilt: 9 - Sayı: 4

Effectuality of the Frequency Levels on the C&G/ω–V Data of the Polymer Interlayered Metal-Semiconductor Structure

Pages
554–561
Publication Date
2022-12-31
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

Thus, polarization and Rs stand out as important parameters that should be taken into account when examining the basic parameters of electronic devices.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Voltage and frequency dependent of capacitance and conductivity versus voltage (C&G/ω–V) qualifications of Al/(ZnFe2O4-PVA)/p-Si structure was compared and examined at lower and higher frequencies as 10 kHz and 1 MHz, respectively.
📊
Key Findings & Data:Nss was acquired using the low-high frequency capacitance method (CLF-CHF), and the forward biased C−2 vs V graphs (at 10 kHz to 1 MHz) were used to determine the Fermi level (EF), barrier height (ΦB), and concentration of doped acceptor atoms (NA).
💡
Conclusion & Impact:Thus, polarization and Rs stand out as important parameters that should be taken into account when examining the basic parameters of electronic devices.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Metal-Polymer-Semiconductor Structures · Surface States · Negative Capacitance

Abstract

Voltage and frequency dependent of capacitance and conductivity versus voltage (C&G/ω–V) qualifications of Al/(ZnFe2O4-PVA)/p-Si structure was compared and examined at lower and higher frequencies as 10 kHz and 1 MHz, respectively. The negative capacitance (NC) is a phenomenon that occurs at low frequencies and is primarily caused by minority carrier injection, series resistance (Rs), and surface states (Nss). Because of the specific density distribution and relaxation times of Nss, NC acts different behavior at lower and higher frequency levels and loses its effectiveness with increasing frequency. Also, the fluctuations in C and G/ω were ascribed to doping concentration, surface states loss charges, and interlayer thickness. Nss was acquired using the low-high frequency capacitance method (CLF-CHF), and the forward biased C−2 vs V graphs (at 10 kHz to 1 MHz) were used to determine the Fermi level (EF), barrier height (ΦB), and concentration of doped acceptor atoms (NA). Accordingly, it has been detected that C and G/ω are highly dependence on biases and frequencies. Then again, the polarizations and surface states effect are barely perceptible at extremely higher frequency levels. Thus, polarization and Rs stand out as important parameters that should be taken into account when examining the basic parameters of electronic devices.

🔖

Cite This Article

ALSMAEL, J. A. M., URGUN, N., TAN, S. O., TECİMER, H. (2022). Effectuality of the Frequency Levels on the C&G/ω–V Data of the Polymer Interlayered Metal-Semiconductor Structure. Gazi University Journal of Science Part A: Engineering and Innovation, Cilt: 9 - Sayı: 4, 554–561. https://ajindex.com/articles/859471

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (3)

  1. Alsmael, J. A. M., Tan, S. O., Tecimer, H. U., Altındal, Ş., & Kalandaragh, Y. A. (2022). The Impact of Dopant on the Dielectric Properties of Metal-Semiconductor With ZnFe2O4 Doped Organic Polymer Nanocomposites Interlayer. IEEE Transactions on Nanotechnology, 21, 528-533. doi:10.1109/TNANO.2022.3207900 Ata, D., Altındal Yeriskin, S., Tataroğlu, A., & Balbasi, M. (2022). Analysis of admittance measurements of Al/Gr-PVA/p-Si (MPS) structure. Journal of Physics and Chemistry of Solids, 169, 110861. doi:10.1016/j.jpcs.2022.110861 Aziz, S. B. (2016). Modifying Poly(Vinyl Alcohol) (PVA) from Insulator to Small-Bandgap Polymer: A Novel Approach for Organic Solar Cells and Optoelectronic Devices. Journal of Electronic Materials, 45(1), 736-745. doi:10.1007/s11664-015-4191-9
  2. Bakkaloğlu, Ö. F., Ejderha, K., Efeoğlu, H., Karataş, Ş., & Türüt, A. (2021). Temperature dependence of electrical parameters of the Cu/n-Si metal semiconductor Schottky structures. Journal of Molecular Structure, 1224, 129057. doi:10.1016/j.molstruc.2020.129057 Çetinkaya, H. G., Sevgili, Ö., & Altındal, Ş. (2019). The fabrication of Al/p-Si (MS) type photodiode with (%2 ZnO-doped CuO) interfacial layer by sol gel method and their electrical characteristics. Physica B: Condensed Matter, 560, 91-96. doi:10.1016/j.physb.2019.02.038 Gaaz, T. S., Sulong, A. B., Akhtar, M. N., Kadhum, A. A. H., Mohamad, A. B., Al-Amiery, A. A., & McPhee, D. J. (2015). Properties and applications of polyvinyl alcohol, halloysite nanotubes and their nanocomposites. Molecules, 20(12), 22833-22847. doi:10.3390/molecules201219884 Hou, G., Li, Y., & Wang, X. (2018). Research Progress of Zinc Ferrite as Photocatalyst. Cailiao Daobao/Materials Review, 32(1), 51-57. doi:10.11896/j.issn.1005-023X.2018.01.006 Neamen, D. A. (1992).
  3. Semiconductor Physics and Devices, Basic Principles. McGraw-Hill. Patil, J. Y., Nadargi, D. Y., Gurav, J. L., Mulla, I. S., & Suryavanshi, S. S. (2014). Glycine combusted ZnFe2O4 gas sensor: Evaluation of structural, morphological and gas response properties. Ceramics International, 40(7) Part B, 10607-10613. doi:10.1016/j.ceramint.2014.03.041 Shultz, M. D., Carpenter, E. E., Morrison, S. A., & Calvin, S. (2006). Cation occupancy determination in manganese zinc ferrites using Fourier transform infrared spectroscopy. Journal of Applied Physics, 99(8), 08M901. doi:10.1063/1.2151831 Slavu, L. M., Rinaldi, R., & Di Corato, R. (2021). Application in nanomedicine of manganese-Zinc ferrite nanoparticles.