AI Summary & Key Takeaways
AI InsightFinally, the friction angle due to suction was calculated to be 1.7 degrees from the results of dry and saturated shear strength parameters.
📌 3 Key Takeaways
Abstract
A sudden slope failure occurred in Manisa possibly due to the effect of water infiltration because of a slightly damaged sewage pipe. Considering that there was no other evidence such as rainfall or any loading conditions to trigger the slope failure, a laboratory investigation on the soil’s unsaturated hydro-mechanical properties was initiated. Slopes are naturally unsaturated soils, and they may lose their stability with increased saturation degrees with water infiltration. Thus, for a proper investigation, the unsaturated hydro-mechanical properties of soils should be determined. The results presented in this study are focused on determining the key parameters to evaluate the slope failure for unsaturated soil conditions. In this regard, hydraulic conductivity and suction characteristics and the shear strength parameters were determined as well as the classical geotechnical properties of the soil. Classification of soil was determined as silty sand which is known to have slight to moderate suction stresses and mostly affected suddenly by water infiltration. A flexible-wall permeability test was run with a falling head procedure and the saturated hydraulic conductivity of the soil sample was measured as 1x10-7 m/s. Suction characteristics were detected by filter paper method, besides, the soil water retention curve of the soil was constructed. The maximum matric suction of the soil was measured as 2887 kPa for an air-dried sample. Following, the shear strength parameters were measured by conventional direct shear test for both dry and soaked conditions. Finally, the friction angle due to suction was calculated to be 1.7 degrees from the results of dry and saturated shear strength parameters.