SavedAdd your journal

Journals / Journal of Scientific Reports-A / 2022 / Sayı: 050

DEVELOPMENT of an ANFIS BASED CONTROL ALGORITHM for MAXIMUM POWER POINT TRACKING in ON-GRID DOUBLE STAGE SINGLE PHASE PV INVERTER

Yasemin ÖNAL
Ümit Çiğdem TURHAL
Pages
150–168
Publication Date
2022-09-30
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

The comparison simulation results with the PandO algorithm confirm the superiority of the developed ANFIS algorithm.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In recent years, interest in solar energy has increased due to the increase in power consumption, the inadequacy of fossil resources and the damage it causes to the environment, as it is a natural energy source and is sustainable.
📊
Key Findings & Data:Electricity is generated from solar energy using photovoltaic (PV) panel systems, and PV systems can be easily installed anywhere.
💡
Conclusion & Impact:The comparison simulation results with the PandO algorithm confirm the superiority of the developed ANFIS algorithm.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Adaptive Neuro-Fuzzy Inference System Controller ANFIS · Maximum Power Point Tracking · DC/DC Boost Converter

Abstract

In recent years, interest in solar energy has increased due to the increase in power consumption, the inadequacy of fossil resources and the damage it causes to the environment, as it is a natural energy source and is sustainable. Electricity is generated from solar energy using photovoltaic (PV) panel systems, and PV systems can be easily installed anywhere. In the PV panel systems, the power obtained at the panel output decreases and the efficiency decreases due to geographical conditions, environmental factors and system design. Maximum Power Point (MPP) tracking algorithm is used to obtain maximum output power from the PV panel system and to increase system efficiency. In this study, an Adaptive Network Based Fuzzy Inference System (ANFIS) based MPP tracking algorithm has been developed to obtain maximum power continuously from on-grid double stage 2 kW single phase PV inverter. The ANFIS algorithm uses an adaptive neural network to optimize the parameters of the membership function, and is a combination of artificial intelligence and fuzzy logic. In the algorithm, Direct Quadrant (dq) synchronous reference frame transform is used to generate PWM signals of active switches in on-grid single phase PV inverter. In this algorithm, dq control is performed by converting the grid current and its component obtained by 90° time delay from the stationary axis to the synchronous rotating axis. The algorithm developed based on dq and ANFIS provides the power demanded by the AC grid in a stable and continuous, while following the MPP, increasing the power obtained from the PV panel and inverter, providing maximum efficiency. The validity of the developed algorithm was tested using the Matlab/Simulink simulation program. The comparison simulation results with the PandO algorithm confirm the superiority of the developed ANFIS algorithm.

🔖

Cite This Article

ÖNAL, Y., TURHAL, Ü. Ç. (2022). DEVELOPMENT of an ANFIS BASED CONTROL ALGORITHM for MAXIMUM POWER POINT TRACKING in ON-GRID DOUBLE STAGE SINGLE PHASE PV INVERTER. Journal of Scientific Reports-A, Sayı: 050, 150–168. https://ajindex.com/articles/778936

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (4)

  1. Hu X., Zou Y., Yang Y., (2016), Greener plug-in hybrid electric vehicles incorporating renewable energy and rapid system optimization, Energy, 111: 971-980
  2. Xue Y., Chang L., Kjær S.B., Bordonau J., and Shimizu T., (2004), Topologies of Single-Phase Inverters for Small Distributed Power Generators: An Overview, IEEE Transactions on Power Electronics,19, 1305-1314
  3. Fei, J., and Zhu, Y., (2017), Adaptive fuzzy sliding control of single-phase PV grid-connected inverter, Plos one, 12(8), e0182916
  4. Jubaer, A., and Zainal, S., (2015), An improved perturb and observe (PandO) maximum power point tracking (MPPT) algorithm for higher efficiency, Appl. Energy, 150, 97–108. doi:10.1016/j.apenergy.2015.04.006 [5] Saharia, B. J., and Saharia, K. K., (2016), Simulated study on nonisolated DC-DC converters for MPP tracking for photovoltaic power systems, Journal of Energy Engineering, 142(1), 04015001. doi: 10.1061/(ASCE)EY.1943-7897.0000261 [6] Safari, A., and Mekhilef, S., (2010), Simulation and hardware implementation of incremental conductance MPPT with direct control method using cuk converter, IEEE T. Ind. Electr., 58(4), 1154-1161. doi:10.1109/TIE.2010.2048834 [7] Tey, K.S. and Mekhilef, S. (2014), Modified Incremental Conductance Algorithm for Photovoltaic System Under Partial Shading Conditions and Load Variation, IEEE Trans. Ind. Electron., 61, 5384–5392. doi:10.1109/TIE.2014.2304921 [8] Mei, Q., Shan, M., Liu, L., and Guerrero, J. M., (2010), A novel improved variable step-size incremental-resistance MPPT method for PV systems, IEEE T. Ind. Electr., 58(6), 2427-2434. doi:10.1109/TIE.2010.2064275 [9] Rezk, H., Fathy, A., and Abdelaziz, A. Y., (2017), A comparison of different global MPPT techniques based on meta-heuristic algorithms for photovoltaic system subjected to partial shading conditions. Renew. Sust. Energy Rev., 74, 377-386. doi:10.1016/j.rser.2017.02.051 [10] Daraban, S., Petreus, D., and Morel, C., (2014), A novel MPPT (maximum power point tracking) algorithm based on a modified genetic algorithm specialized on tracking the global maximum power point in photovoltaic systems affected by partial shading, Energy, 74, 374-388. doi:10.1016/j.energy.2014.07.001 [11] Ahmed, J., and Salam, Z. A., (2014), Maximum Power Point Tracking (MPPT) for PV system using Cuckoo Search with partial shading capability, Appl. Energy, 119, 118-130. doi:10.1016/j.apenergy.2013.12.062 [12] Babu, T. S., Ram, J. P., Dragičević, T., Miyatake, M., Blaabjerg, F., a