Journals / Çukurova Üniversitesi Mühendislik-Mimarlik Fakültesi Dergisi / 2008 / Cilt: 23 - Sayı: 2

mechanical properties of concrete beams strengthened made with polyesteyrene fibers

Polyester liflerle güçlendirilmiş beton kirişlerin mekanik özellikleri

Pages
25–33
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

However, the compressive strength of the concrete slightly decreased by the addition of fibers.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Huge amounts of textile wastes are disposed from countries all over the world.
📊
Key Findings & Data:A significant improvement in the flexural and tensile properties of the beams was obained by addition of polyesteyrene fibers.
💡
Conclusion & Impact:However, the compressive strength of the concrete slightly decreased by the addition of fibers.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Abstract

Huge amounts of textile wastes are disposed from countries all over the world. The majority of cotton wastes and textile wastes are disposed and cause serious environmental problems. This paper presents a parametric experimental study; the effect of polyesteyrene fibers on the mechanical properties of concrete beams was studied. A significant improvement in the flexural and tensile properties of the beams was obained by addition of polyesteyrene fibers. The flexural strength of the strengthened beams were compared with those of the control ones and a significant increase was observed.The increase obtained was 41,43 and 45% with the addition of 0.01, 0.02 and 0.03% wt., respectively. However, the compressive strength of the concrete slightly decreased by the addition of fibers.

Özet

Dünyanın birçok bölgesinde çok miktarda tekstil atıkları bulunmaktadır. Bu atıkların büyük bir kısmı çevre kirliliği yapmaktadır. Bu çalısmada Kahramanmaras Tekstil Fabrikalarından elde edilen polyester lif katkılı betonla üretilen kirislerin mekanik özellikleri arastırılmıstır. Polyester liflerinin beton matrisine ilavesi ile kirisin, eğilme ve çekme özelliklerinde önemli bir iyilesmenin meydana geldiği gözlenmistir. Beton kirisin eğilme mukavemetindeki artısın, tek eksenli çekme mukavemeti ile karsılastırıldığı zaman daha önemli olduğu görülmüstür. Liflerin %0.01, 0.02 ve 0.03 oranlarında ilavesi ile beton kirisin eğilme mukavemetinde sırasıyla %41, 43 ve 45’e kadar artıslar meydana gelmistir. Bununla birlikte lif takviyesiyle betonun basınç dayanımı bir miktar azalmıstır.

🔖

Cite This Article

BİNİCİ, H., GEMCİ, R., TÜRKÖZER, C. D., AKSOĞAN, O., KOÇ, G. (2008). mechanical properties of concrete beams strengthened made with polyesteyrene fibers. Çukurova Üniversitesi Mühendislik-Mimarlik Fakültesi Dergisi, Cilt: 23 - Sayı: 2, 25–33. https://ajindex.com/articles/350349

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (16)

  1. Esen,Y., “Poliakrilonitril Katkılı Lifli Betonların Özellikleri ve Kullanılabilirliğinin Arastırılması”, Yüksek Lisans Tezi, Fırat Üniversitesi Fen Bilimleri Enstitüsü, Elazığ, 1996
  2. Tasdemir,M.A., Lydon,F.D. ve Barr,B.I.G., “The Tensile Strain Capacity of Concrete”, Magazine of Concrete Research, 48, 211-218, 1996
  3. Altun,F., Yılmaz,C., Durmus,A., Arı,K., “Çelik Lif Katkılı ve Katkısız Betonarme Kirislerin Basit Eğilme ve Patlama Yüklemesi ile Davranıslarının incelenmesi”, Erciyes Üniversitesi Fen Bilimleri Enstitüsü Dergisi, 22(1-2) 112-120, 2006
  4. Çivici,F., “Çelik Lif Donatılı Betonun Eğilme Tokluğu”, Pamukkale Üniv. Mühendislik Bil. Dergisi, 12, ( 2), 183–188, 2006
  5. Yeğinobalı,A., “Silis Dumanı ve Çimento ile Betonda Katkı Maddesi Olarak Kullanılması”, TÇMB/AR-GE/Y01.01 3. Baskı, Ankara, 2003
  6. Arslan,A. ve Ulucan,Z., “Çelik Liflerin Erken Yastaki Betonarme Kirislerin Göçmesine Etkisi”, ĐMO Teknik Dergisi, 8(4), 1507-1515, 1997
  7. Wong,C., “Use of Short Fibers in Structural Concrete to Enhance Mechanical Properties”, University of Southern Queensland Faculty of Engineering and Surveying, 1,178-182, 2004
  8. Esen,Y., “Poliakrilonitril Lif Takviyeli Betonların Mekanik Özelliklerinin ve Kullanılabilirliğinin Arastırılması”, F.Ü. Fen ve Mühendislik Bilimleri Dergisi, 15 (1),47-54, 2003
  9. Simsek,O., Erdal,M. ve Sanca,E., “Silis Dumanının Çelik Lifli Betonun Eğilme Dayanımına Etkisi”,Gazi Üniv. Müh. Mim. Fak. Dergisi, 20( 2), 211–215, 2005
  10. Esen,Y., Yılmazer,B, “Poliakrilonitril Lifli Betonda Kullanımının Arastırılması”, Beton 2008, Uluslararası Hazır Beton Kongresi, 19-21 Haziran, 645-651, İstanbul, 2008
  11. Do,M.T., Chaal,O. and Aitcin,P.C., “Fatigue Behavior of High-Performance Concrete”, ASCE JM. 1, 96–111, 1993
  12. Gao,L. and Hsu,C.T.T., “Fatigue of Concrete under Uniaxial Compression Cyclic Loading”, ACI Mater J, Sept.–Oct, 575–581,1998
  13. Hordijk,D.A., Wolsink,G.M. and Vries,J., “Fracture and Fatigue Behaviour of High Strength Limestone Concrete as Compared to Gravel Concrete”, HERON, 40(2):125–146, 1995
  14. Hsu,T.C., “Fatigue of Plain Concrete”, ACI Journal, 78, 292–305,1981
  15. Otter,D.E. and Naaman,A.E., “Properties of Steel Fiber Reinforced Concrete under Cyclic Loading”. ACI Material Journal, July-Aug. 254–261, 1988
  16. Ramakrishnan,V., Meyer,C., Naaman,A., Zhao,G. and Fang,L,. “Cyclic Behavior”, Fatigue Strength, Endurance Limit and Models for Fatigue Behavior of FRC, In: Naaman A, Reinhardt, editors. High performan