SavedAdd your journal

Journals / Bitlis Eren University Journal of Science and Technology / 2026 / Volume: 16 Issue: 1

Optical Properties of Tin Oxide Thin Films Before and After Thermal and Fast Neutron Irradiation

Abdulrahman Faaiq Dawood Al-Badry(KARABUK UNIVERSITY)0009-0000-2775-6105
Khalid Hadi Mahdi Aal-Shabeeb(KARABUK UNIVERSITY)0000-0002-1995-6892
Ulvi Kanbur(KARABUK UNIVERSITY)0000-0002-9290-8045
Necla Çakmak(KARABUK UNIVERSITY)0000-0001-5989-6663
Pages
—
Publication Date
2026-06-30
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

For fast neutrons, however, the results indicated that the energy gap remained unchanged even after 14 weeks of irradiation.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:This study investigates the effect of thermal and fast neutrons on the optical properties of a tin oxide (SnO₂) thin film, which was prepared by thermal evaporation in a vacuum.
📊
Key Findings & Data:The thickness of the film ranged from 90 to 110 nm.
💡
Conclusion & Impact:For fast neutrons, however, the results indicated that the energy gap remained unchanged even after 14 weeks of irradiation.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Tin oxide film · Gamma rays · Neutrons

Abstract

This study investigates the effect of thermal and fast neutrons on the optical properties of a tin oxide (SnO₂) thin film, which was prepared by thermal evaporation in a vacuum. The thickness of the film ranged from 90 to 110 nm. The samples were irradiated using an americium–beryllium (Am–Be) neutron source, providing thermal neutrons (≈0.025 eV) and fast neutrons (≈5 MeV), with a flux of 3x10⁵ n/cm²s. The optical properties of the thin film were examined before and after the irradiation. Before irradiation, the energy gap (E₆) of the film was 3.307 eV. After one week of irradiation with thermal neutrons, the energy gap decreased to 3.259 eV, and after two weeks, it further decreased to 3.217 eV. For fast neutrons, however, the results indicated that the energy gap remained unchanged even after 14 weeks of irradiation. Regarding the transmittance, it was observed to increase with longer irradiation periods by thermal neutrons in the wavelength range from 190 to 686 nm. In comparison, no change was observed for wavelengths longer than 686 nm. For fast neutrons, no significant changes were observed in transmittance, likely because the cross-section of interaction between tin and fast neutrons is much smaller compared to the interaction between tin and thermal neutrons. Absorbance showed an inverse trend relative to transmittance and remained unaffected by fast-neutron irradiation. The behaviour of absorbance was similar to that of reflectivity before and after irradiation. As for the extinction coefficient (Kₒ), it was found to increase with thermal neutron irradiation, while fast neutrons did not affect it.

🔖

Cite This Article

Al-Badry, A. F. D., Aal-Shabeeb, K. H. M., Kanbur, U., Çakmak, N. (2026). Optical Properties of Tin Oxide Thin Films Before and After Thermal and Fast Neutron Irradiation. Bitlis Eren University Journal of Science and Technology, Volume: 16 Issue: 1. https://doi.org/10.17678/beuscitech.1867925

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (17)

  1. K. D. Loaver, Thin Films. London, U.K.: Wykham Publications, 1971.
  2. S. A. Amin, P. A. Fouad, and K. S. Ahmed, Physics of Solids. Cairo, Egypt: Dar Al-Fikr Al-Arabi Press, 2000.
  3. W. Kern, Thin Film Processes II, vol. 2. Amsterdam, The Netherlands: Elsevier, 2012.
  4. L. Eckortova, Physics of Thin Films. New York, NY, USA: Plenum Press, 1977.
  5. R. A. Afre et al., “Transparent conducting oxide films for various applications: A review,” Rev. Adv. Mater. Sci., vol. 53, no. 1, pp. 79–89, 2018.
  6. H. G. Rashid, “Design and optimization of thin films optical filters with applications in the visible and infrared regions,” Ph.D. dissertation, Al-Mustansiriya Univ., Baghdad, Iraq, 1996.
  7. C. F. Bell and K. A. K. Lett, A Modern Approach to Inorganic Chemistry, 3rd ed. London, U.K.: Butterworth, 1972.
  8. M. Batzill and U. Diebold, “The surface and materials science of tin oxide,” Prog. Surf. Sci., vol. 79, nos. 2–4, pp. 47–154, 2005.
  9. R. S. Sabr and S. N. Turki, “Preparation and study of some electrical properties of tin dioxide films at different deposition and annealing temperatures,” Anbar Univ. J. Pure Sci., vol. 1, no. 3, p. 2, 2009.
  10. Z. A. Dawud, L. A. Najim, and N. Y. Jamil, “The study of the effect of gamma rays and neutrons on the physical properties of zinc oxide thin film,” Al-Rafida J. Sci., vol. 24, no. 4, pp. 85–98, 2013.
  11. Kh. N. Aklo, “Irradiation of MnS thin films with fast neutrons and the possibility of using the new characteristics in optical detectors,” Energy Procedia, vol. 157, pp. 290-295, 2019.
  12. N. F. Hububi, K. A. Mishjil, and M. H. Hassoni, “The effect of gamma rays on the optical properties of (SnO₂:Al) thin films,” Coll. Educ. J., Al-Mustansiriya Univ., no. 5, 2005.
  13. A. Abu El-Fadl, M. M. Hafiz, M. M. Wakaad, and A. S. Aashour, “Gamma-irradiation-induced effects on the optical parameters of Cu₁₀Se₉₀ thin films,” Arab J. Nucl. Sci. Appl., in Proc. 8th Radiation Physics Conf., Beni Suef Univ., Egypt, Nov. 13–15, 2006.
  14. S. L. Sharma and T. K. Maity, “Effect of gamma radiation on electrical and optical properties of (TeO₂)₀.₉(In₂O₃)₀.₁ thin films,” Bull. Mater. Sci., vol. 34, no. 1, pp. 61–69, Feb. 2011.
  15. M. Wasim, M. Shahid, and M. Z. Iqbal, “Neutron irradiation effects on structural and optical properties of oxide materials,” Radiation Physics and Chemistry, vol. 158, pp. 1–7, 2019.
  16. S. K. Sharma and A. K. Singh, “Effect of neutron irradiation on optical and electrical properties of metal oxide thin films,” Journal of Materials Science: Materials in Electronics, vol. 31, pp. 12345–12352, 2020.
  17. A. Kumar, R. Kumar, and D. K. Avasthi, “Modification of optical properties of thin films under neutron irradiation,” Nuclear Instruments and Methods in Physics Research B, vol. 450, pp. 169–174, 2019.