Dergiler / Pamukkale Üniversitesi Mühendislik Bilimleri Dergisi / 2020 / Cilt: 26 - Sayı: 6

Effect of lead rubber bearing on seismic response of regular and irregular frames in elevation

Sayfa
1076–1085
Yayın Tarihi
2020-11-13
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

It was found that the seismic response of the regular and irregular frames in elevation could be improved up to a certain degree by implementing LRB.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Base isolations are acknowledged as an effective seismic protective system for structural systems of buildings.
📊
Temel Bulgular & Veri:To this aim, 12-storey regular and irregular steel frames in elevation upgraded with LRB were studied by evaluating the local and global deformations.
💡
Sonuç & Katkı:It was found that the seismic response of the regular and irregular frames in elevation could be improved up to a certain degree by implementing LRB.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Base isolation · Frame · Irregular in elevation

Abstract

Base isolations are acknowledged as an effective seismic protective system for structural systems of buildings. This study investigates the effectiveness of lead rubber bearing (LRB) on the nonlinear response of the steel moment resisting frames subjected to real ground motions. To this aim, 12-storey regular and irregular steel frames in elevation upgraded with LRB were studied by evaluating the local and global deformations. LRB was modeled by considering three key parameters of isolation period, effective damping ratio, and stiffness ratio. Two-dimensional model of the base isolated frames were created and a series of time-history analyses were carried out by different earthquake ground motions. The seismic behaviour of the bare and isolated frames was measured by the variation of isolator displacement, acceleration, interstorey drift ratio, relative displacement, roof drift ratio, normalized base shear, base moment, and hysteretic curve. The supremacy of the base-isolated frames over the bare frames was discussed accordingly. It was found that the seismic response of the regular and irregular frames in elevation could be improved up to a certain degree by implementing LRB.

🔖

Bu Makaleye Atıf Yap

DERİNGÖL, A. H., GÜNEYİSİ, E. M. (2020). Effect of lead rubber bearing on seismic response of regular and irregular frames in elevation. Pamukkale Üniversitesi Mühendislik Bilimleri Dergisi, Cilt: 26 - Sayı: 6, 1076–1085. https://ajindex.com/articles/92770

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (12)

  1. Fujita T. “Seismic isolation of civil buildings in Japan”. Progress in Structrutal Engineering and Materials, 1(3), 295-300, 1998
  2. Matsagar VA, Jangid RS. “Influence of isolator characteristics on the response of base-isolated structures”. Engineering Structures, 26(12), 1735-1749, 2004
  3. Dezfuli FH, Alam MS. “Performance-based assessment and design of FRP-based high damping rubber bearing incorporated with shape memory alloy wires”. Engineering Structures, 61, 166-183, 2014
  4. Dezfuli FH, Alam MS. “Effect of different steel-reinforced elastomeric isolators on the seismic fragility of a highway bridge”. Structural Control and Healt Monitoring, 24(2), 1-15, 2017
  5. Makris N, Chang S. “Effects of damping mechanisms on the response of seismically isolated structures”. PEER report 1998/06. Berkeley (CA): Pacific Earthquake Engineering Research Center, College of Engineering, University of California, 1998 [6] Kelly JM, Hodder SB. “Experimental study of lead and elastomeric dampers for base isolation system in laminated neoprene bearings”. Bulletin of New Zealand National Society for Earthquake Engineering, 15, 53-67, 1982
  6. Providakis CP. "Pushover analysis of base-isolated steel-concrete composite structures under near-fault excitations". Soil Dynamics and Earthquake Engineering, 28(4), 293-304, 2008
  7. ASCE. “Evaluation findings for skellerup base isolation elastomeric bearings”. Technical Evaluation Report, (CERF Report: HITEC 98-12), Prepared by the Highway Innovative Technology Evaluation Center, 1998
  8. Hameed A, Koo MS, Jeong JH. “Effect of lead rubber bearing characteristics on the response of seismic-isolated bridges”. KSCE Journal of Civil Engineering, 12(3), 187-196, 2008
  9. Hashemi S, Aghashiri MH. “Seismic responses of base-isolated flexible rectangular fluid containers under horizontal ground motion”. Soil Dynamics and Earthquake Engineering, 100, 159-168, 2017 [11] Jangid RS. "Optimal lead-rubber isolation bearings for near-fault motions". Engineering Structures, 29(10), 2503-2513, 2007
  10. Bhandari M, Bharti SD, Shrimali MK, Datta TK. “Assessment of proposed lateral load patterns in pushover analysis for base isolated frames”. Engineering Structures, 175, 531-548, 2018
  11. Liang B, Shishu X, Jiaxiang T. "Wind effects on habitability of base-isolated buildings". Journal of Wind Engineering and Industrial Aerodynamics, 90(12-15), 1951-1958, 2002
  12. Kulkarni JA, Jangid RS. "Effects of superstructure flexibility on t