Dergiler / Seatific Journal / 2022 / Cilt: 2 - Sayı: 2

Fog collection - materials, techniques and affecting parameters - A review

Sayfa
30–55
Yayın Tarihi
2022-12-30
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Some of the procedures to create the material will also be explained.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Water scarcity has shown a great challenge during the past decades with millions suffering from lack of potable water.
📊
Temel Bulgular & Veri:There are lots of methods to rate the quality of fog water collection.
💡
Sonuç & Katkı:Some of the procedures to create the material will also be explained.
🔬Tür:Literatür & Derleme Çalışması
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Water resources · Fog collection · Hydrophobic

Abstract

Water scarcity has shown a great challenge during the past decades with millions suffering from lack of potable water. Although, people try to benefit from the water naturally existing in air by two sources: fog and humid air. In this paper, we mainly allot the work on fog water. Fog collection is undergone using fog mesh collectors. There are lots of methods to rate the quality of fog water collection. Most used method is the quantity of water collected in kilograms for a one square meter harvester mesh per one hour. However, sometimes water contact angle on a flat surface of the mesh's material is also reliable. Both give an indication of hydrophobicity or water repellency which is significant for high fog collection efficiency. In addition, drop falling velocity and deposition time of water on the harvester measured in seconds are both indications for fog collection efficiency but rarely used. The scope of this article is to make a helpful guide for fog harvesting technology with the parameters that control the efficiency of this water resource. In addition, there is a detailed review in the chemistry of some of the previous researches on fog water collection inspired by natural existing plants and animals that survive in arid zones where only fog or humid air is found. Concerning the fog harvesting surface material, there will be a comparison between different essential parameters as mentioned above or other general indications. Some of the procedures to create the material will also be explained.

🔖

Bu Makaleye Atıf Yap

ELSHENNAWY, A. A., AWAD, M. M., ABDELAAL, M. Y., HAMED, A. M. (2022). Fog collection - materials, techniques and affecting parameters - A review. Seatific Journal, Cilt: 2 - Sayı: 2, 30–55. https://ajindex.com/articles/877230

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (11)

  1. Almasian, A., Chizari Fard, G., Mirjalili, M., & Parvinzadeh Gashti, M. (2018). Fluorinated-PAN nanofibers: Preparation, optimization, characterization and fog harvesting property. Journal of Industrial and Engineering Chemistry, 62, 146–155.
  2. Almasian, A., Chizari Fard, G., Mirjalili, M., & Parvinzadeh Gashti, M. (2018). Fluorinated-PAN nanofibers: Preparation, optimization, characterization and fog harvesting property. Journal of Industrial and Engineering Chemistry, 62, 146–155.
  3. Bai, H., Wang, L., Ju, J., Sun, R., Zheng, Y., & Jiang, L. (2014). Efficient water collection on integrative bioinspired surfaces with star-shaped wettability patterns. Advanced Materials, 26(29), 5025–5030.
  4. Bai, H., Wang, L., Ju, J., Sun, R., Zheng, Y., & Jiang, L. (2014). Efficient water collection on integrative bioinspired surfaces with star-shaped wettability patterns. Advanced Materials, 26(29), 5025–5030.
  5. Batisha, A. F. (2015). Feasibility and sustainability of fog harvesting. Sustainability of Water Quality and Ecology, 6, 1–10.
  6. Batisha, A. F. (2015). Feasibility and sustainability of fog harvesting. Sustainability of Water Quality and Ecology, 6, 1–10.
  7. Bertule, M., Appelquist, L. R., Spensley, J., Traerup, S. L. M., & Naswa, P. (2018). Climate change adaptation technologies for water: a practitioner’s guide to adaptation technologies for increased water sector resilience. (pp. 1–56).
  8. UN Environment-DHI Centre. Bertule, M., Appelquist, L. R., Spensley, J., Traerup, S. L. M., & Naswa, P. (2018). Climate change adaptation technologies for water: a practitioner’s guide to adaptation technologies for increased water sector resilience. (pp. 1–56).
  9. UN Environment-DHI Centre. Bhushan, B. (2013). Introduction to Tribology. In Introduction to Tribology (2nd ed.). Wiley Online Library. Bhushan, B. (2013). Introduction to Tribology. In Introduction to Tribology (2nd ed.). Wiley Online Library. Bhushan, B. (2020). Design of water harvesting towers and projections for water collection from fog and condensation. Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 378(2167), 1–37.
  10. Bhushan, B. (2020). Design of water harvesting towers and projections for water collection from fog and condensation. Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 378(2167), 1–37.
  11. Brown, P. S., & Bhushan, B. (2016). Durable superoleophobic polypropylene surfaces. Philosophical Transactions of the Royal Soci