KaydedilenlerDerginizi ekleyin

Dergiler / Türkiye Teknoloji ve Uygulamalı Bilimler Dergisi / 2017 / Cilt: 1 - Sayı: 2

The Influence of Layer Number on Properties of Cu2ZnSnS4 Films

Güven TURGUT
Eyüp Fahri KESKENLER
Sayfa
79–85
Yayın Tarihi
2017-10-31
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

This result indicates that 7 layered film is very suitable for solar cell as an absorber layer.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:In present study, Cu2ZnSnS4 thin films were deposited via single-step sol-gel spin coating process.
📊
Temel Bulgular & Veri:XRD results showed that 7 layered film had crystal structure but other films had amorphous structure. 7 layered film grown at (112) preferential orientation and it had another peak of (200).
💡
Sonuç & Katkı:This result indicates that 7 layered film is very suitable for solar cell as an absorber layer.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Cu2ZnSnS4 · Sol-gel · Optical Properties

Özet

In present study, Cu2ZnSnS4 thin films were deposited via single-step sol-gel spin coating process. The effect of layer number on the structural, morphological and optical properties was investigated. XRD results showed that 7 layered film had crystal structure but other films had amorphous structure. 7 layered film grown at (112) preferential orientation and it had another peak of (200). AFM analysis indicated that any particle on surface of 3, 4 and 5 layered films was not observed and the particle structure was observed for 6 and 7 layer films. The crystallite sizes for 6 layer films were very small, but 7 layer films had both small and big particles on its surface. This particle structure was not homogenous for the film surfaces. From UV-VIS studies, optical band gap of 3, 4, 5, 6 and 7 layered films were found to be 1.88 eV, 1.82 eV, 1.73 eV, 1.68 eV and 1.48 eV, respectively. This result indicates that 7 layered film is very suitable for solar cell as an absorber layer.

🔖

Bu Makaleye Atıf Yap

TURGUT, G., KESKENLER, E. F. (2017). The Influence of Layer Number on Properties of Cu2ZnSnS4 Films. Türkiye Teknoloji ve Uygulamalı Bilimler Dergisi, Cilt: 1 - Sayı: 2, 79–85. https://ajindex.com/articles/813166

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (13)

  1. Araki, H., Kubo, Y., Mikaduki, A., Jimbo, K., Maw, W.S., Katagiri, H., Yamazaki, M., Oishi, K., Takeuchi, A., 2009. Preparation of Cu2ZnSnS4 thin films by sulfurizing electroplated precursors. Solar Energy Materials & Solar Cells, 93: 996-999.
  2. Chory, C., Zutz, F., Witt, F., Borchert, H., Parisi, J., 2010. Synthesis and characterization of Cu2ZnSnS4. Phys. Status Solidi C, 7: 1486-1488.
  3. Fernandes, P.A., Salomé, P.M.P., Cunha, A.F.da., 2009. Growth and Raman scattering characterization of Cu2ZnSnS4 thin films. Thin Solid Films, 517: 2519-2523.
  4. Fischereder, A., Rath, T., Haas, W., Amenitsch, H., Albering, J., Meischler, D., Larissegger, S., Edler, M., Saf, R., Hofer, F., Trimme, G., 2010. Investigation of Cu2ZnSnS4 Formation from Metal Salts and Thioacetamide. Chemical Materials, 22: 3399-3406.
  5. Ito, K. and Nakazawa, T., 1988. Electrical and optical properties of stannite-type quaternary semiconductor thin films. Japanese Journal of Applied Physics, 27: 2094.
  6. Jeon, M., Shimizu, T., Shingubara, S., 2011. Cu2ZnSnS4 thin films and nanowires prepared by different single-step electrodeposition method in quaternary electrolyte. Materials Letters, 65: 2364-2367.
  7. Kamoun, N., Bouzouita, H., Rezig, B., 2007. Fabrication and characterization of Cu2ZnSnS4 thin films deposited by spray pyrolysis technique. Thin Solid Films, 515: 5949-5952.
  8. Kumar, Y.B.K., Bhaskar, P.U, Babu, G.S., Raja, V.S., 2010. Effect of copper salt and thiourea concentrations on the formation of Cu2ZnSnS4 thin films by spray pyrolysis. Phys. Status Solidi A, 207: 149-156.
  9. Maeda, K., Tanaka, K., Fukui, Y., Uchiki, H., 2011. Influence of H2S concentration on the properties of Cu2ZnSnS4 thin films and solar cells prepared by sol–gel sulfurization. Solar Energy Materials & Solar Cells, 95: 2855-2860.
  10. Minlin, J., Yong, L., Rabin, D., Prem, T., Michael, M., Joshua, C., Fritz, K., Xingzhong, Y., 2011. Cu2ZnSnS4 polycrystalline thin films with large densely packed grains prepared by sol-gel method. Journal of Photonics for Energy, 1: 019501-(1-6).
  11. Moholkar, A.V., Shinde, S.S., Babar, A.R., Sim, K.-U., Kwon, Y., Rajpure, K.Y., Patil, P.S., Bhosale, C.H., Kim, J.H., 2011. Development of CZTS thin films solar cells by pulsed laserdeposition: Influence of pulse repetition rate. Solar Energy, 85: 1354-1363.
  12. Moritake, N., Fukui, Y., Oonuki, M., Tanaka, K., Uchiki, H., 2009. Preparation of Cu2ZnSnS4 thin film solar cells under non-vacuum condition. Phys. Status Solidi C, 6: 1233-1236.
  13. Nakayama, N. and Ito, K., 1996.