Dergiler / Eskişehir Osmangazi Üniversitesi Mühendislik ve Mimarlık Fakültesi Dergisi / 2003 / Cilt: 16 - Sayı: 1

The Effect Of Liquids On Mechanical Strength And Abrasiveness Of Rocks

Sayfa
1–15
Yayın Tarihi
2003-06-30
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Compared with their dry values, the point load strength of the rock samples decreased when saturated with different liquids.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Many methods of determining the abrasiveness of rocks were developed by a number of researchers.
📊
Temel Bulgular & Veri:The liquids having 4, 7.5 and 10-pH degrees were used in the experiments, representing acidic, alkaline and neutral conditions respectively.
💡
Sonuç & Katkı:Compared with their dry values, the point load strength of the rock samples decreased when saturated with different liquids.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Abrasiveness · Point Load Strength · pH degree

Özet

Many methods of determining the abrasiveness of rocks were developed by a number of researchers. Although the effect of liquids on the mechanical properties of rocks has been investigated by some authors, the effect of liquids on the abrasivity of rocks has not been published. In this paper, the effect of different liquids on the abrasivity and mechanical strength of rocks was investigated. To achieve this goal; samples of sandstone, limestone and tuff were tested under laboratory conditions. The liquids having 4, 7.5 and 10-pH degrees were used in the experiments, representing acidic, alkaline and neutral conditions respectively. It was observed that the liquid which has a pH degree of 4 significantly increased the abrasivity of the above mentioned rocks. Compared with their dry values, the point load strength of the rock samples decreased when saturated with different liquids.

Abstract

Many methods of determining the abrasiveness of rocks were developed by a number of researchers. Although the effect of liquids on the mechanical properties of rocks has been investigated by some authors, the effect of liquids on the abrasivity of rocks has not been published. In this paper, the effect of different liquids on the abrasivity and mechanical strength of rocks was investigated. To achieve this goal; samples of sandstone, limestone and tuff were tested under laboratory conditions. The liquids having 4, 7.5 and 10-pH degrees were used in the experiments, representing acidic, alkaline and neutral conditions respectively. It was observed that the liquid which has a pH degree of 4 significantly increased the abrasivity of the above mentioned rocks. Compared with their dry values, the point load strength of the rock samples decreased when saturated with different liquids.

🔖

Bu Makaleye Atıf Yap

İPHAR, M., GÖKTAN, R. (2003). The Effect Of Liquids On Mechanical Strength And Abrasiveness Of Rocks. Eskişehir Osmangazi Üniversitesi Mühendislik ve Mimarlık Fakültesi Dergisi, Cilt: 16 - Sayı: 1, 1–15. https://ajindex.com/articles/755207

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (16)

  1. İphar, M., “Sıvıların Kayaçların Mekanik Dayanımları ve Aşındırıcılıkları Üzerindeki Etkisi”, Yüksek Lisans Tezi, Osmangazi Üniversitesi Fen Bilimleri Enstitüsü, Eskişehir, 49s., 1996
  2. West, G., “A review of rock abrasiveness testing for tunneling”, Proceedings of the International Symposium on Weak Rock, 21-24 September 1981. Tokyo. pp. 585-594
  3. Roxborough, F.F., Rispin, A., “A laboratory investigation into the application of picks for mechanized tunnel boring in the lower chalk”, The Mining Engineer, Vol.133, pp. 1-13, October 1973
  4. Ojo, O. and Brook, N., “The effect of moisture on some mechanical properties of rock”, Mining Science and Technology, 10: 145-156, 1990
  5. Colback, P.S.B. and Wiid, B.L., “The influence of moisture content on the compressive strength of rocks”, Proc. 3rd Can. Rock Mech. Symp., 1965. Toronto. pp. 65-83
  6. Boretti-Onyszkiewicz, W., “Joints in the flysch sandstones on the ground of strength examinations”, Proc. 1st Cong. Int. Soc. Rock Mech., 1966. Lisbon. Vol.1, pp.153-157
  7. Street, N. and F.-D.-Wang, “Surface potentials and rock strength”, Proc. 1st Cong. Int. Soc. Rock Mech., 1966. Lisbon. Vol. 1, pp. 451-456
  8. Burshtein, L.S., “Effect of moisture on the strength and deformability of sandstone”, Sov. Min. Sci. No. 5, pp. 573-576, Sept.-Oct., 1969
  9. Dube, A.K. and Singh, B., “Determination of tensile strength of rocks by disc test method”, J. Mines, Metals and Fuels, Vol. 17, No. 9, pp. 305- 307,Sept., 1969, [10] Obert, L., Windes, S.L., and Duvall, W.I., “Standardized tests for determining the physical properties of mine rock”, U.S.B.M.R.I. 3891, 67 p., 1946
  10. Price, N.J., “The compressive strength of coal measure rocks”, Coll. Eng., Vol. 37, pp.283-292, 1960
  11. Kjaernsli, B., Sande, A., “Compressibility of some coarse-grained materials”, Proc. European Conf. Soil Mech. Found. Eng., 1963. Wiesbaden. Vol. 1, pp.245-251
  12. Zaruba, Q., “Geology of the Orlik dam site”, Water Power, Vol. 17, pp. 273- 279, 1965
  13. Salustowicz, A., “Zarys mechaniki gorotworu, Katowice”, Wydawnictwo Slask, 1965
  14. Feda, J., “The influence of water content on the behaviour of subsoil formed by highly weathered rocks”, Proc. 1st Cong. Int. Soc. Rock Mech., 1966. Lisbon. Vol. 1, pp.283-288
  15. Simpson, D.R. and Fergus, J.H., “The effect of water on the compressive strength of diabase”, J. Geophys. Res., Vol. 73, No. 20, pp. 6591-6594, 15 Oct., 1968
  16. Vutukuri, V.S., “Effect of aluminium chloride solutio