Dergiler / International Journal of Automotive Science and Technology / 2020 / Cilt: 4 - Sayı: 2

A Comparative Study on the Usage of RON68 and Naphtha in an HCCI Engine

Sayfa
90–97
Yayın Tarihi
2020-06-30
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Maximum ITE was calculated as 45.42% and 46.07% at λ=2 with RON68 and naphtha respectively.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:The depletion of fossil fuels as a result of excessive use and increased environmental pollution brought up the research of environmentally conscious and renewable alternative fuels.
📊
Temel Bulgular & Veri:The alternative fuel to be considered for internal combustion engines should not decrease the performance of the engine too much and positively affect the exhaust emissions.
💡
Sonuç & Katkı:Maximum ITE was calculated as 45.42% and 46.07% at λ=2 with RON68 and naphtha respectively.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:combustion · HCCI · Naphtha

Abstract

The depletion of fossil fuels as a result of excessive use and increased environmental pollution brought up the research of environmentally conscious and renewable alternative fuels. The alternative fuel to be considered for internal combustion engines should not decrease the performance of the engine too much and positively affect the exhaust emissions. It is also important that this fuel should provide some specifications such as easy producibility, low cost, availability and usability in internal combustion engine without modification. Low temperature combustion modes are promising technologies providing nearly zero NOx and soot emissions and currently a lot of researcher has focused on this technology. In this experimental study naphtha was tested in an HCCI engine. In order to examine and understand the effects of the naphtha on HCCI mode a comparison study was also conducted by using RON68. Maximum imep was computed as 3.23 and 3.32 bar with RON68 and naphtha respectively at λ=1.7. SOC was determined 5.4 °CA and 5.76 °CA ATDC with naphtha and RON68 at λ=2. CA50 is far away from TDC fact that net work decreases. Maximum ITE was calculated as 45.42% and 46.07% at λ=2 with RON68 and naphtha respectively.

🔖

Bu Makaleye Atıf Yap

YILMAZ, E. (2020). A Comparative Study on the Usage of RON68 and Naphtha in an HCCI Engine. International Journal of Automotive Science and Technology, Cilt: 4 - Sayı: 2, 90–97. https://ajindex.com/articles/717109

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (12)

  1. Maurya, R. K. (2017) Characteristics and Control of Low Temperature Combustion Engines: Employing Gasoline, Ethanol and Methanol, Cham, Switzerland: Springer Interna-tional Publishing AG, 2-10
  2. International Energy Agency (2010) World energy outlook. International Energy Agency, France. isbn 978-92-64-08624-1. www.iea.org
  3. U.S. Energy Information Administration (2016) International energy outlook
  4. T.S. Uyar, Enerji Sorunu Nedir? Alternatif Enerji Çözüm müdür? NEU-CEE 2001 Electrical, Electronic and Computer Engineering Symposium, 23-26, Lefkoşa TRNC, 2001
  5. Pan, S., Liu, X., Cai, K., Li, X., Han, W., & Li, B. (2020). Experimental study on combustion and emission characteris-tics of iso-butanol/diesel and gasoline/diesel RCCI in a heavy-duty engine under low loads. Fuel, 261, 116434
  6. İpci, D., Yılmaz, E., Aksoy, F., Uyumaz, A., Polat, S., & Solmaz, H. (2015). The Effects of iso-propanol and n-heptane Fuel Blends on HCCI Combustion Characteristics and Engine Performance. Makine Teknolojileri Elektronik Dergisi, 12(1), 49-56
  7. Bastawissi, H. A. E., Elkelawy, M., Panchal, H., & Sa-dasivuni, K. K. (2019). Optimization of the multi-carburant dose as an energy source for the application of the HCCI en-gine. Fuel, 253, 15-24
  8. Solmaz, H., Kocakulak, T. Buji ile Ateşlemeli Motor Kullanılan Seri Hibrit Elektrikli Bir Aracın Modellenmesi. In Proceedings on International Conference on Technology and Science, December, 2018
  9. Kocakulak, T., Solmaz, H., Elektrikli Bir Aracın Modellen-mesi ve Rejeneratif Fren Sisteminin Bulanık Mantık Yöntemi ile Kontrol Edilmesi, International Symposium on Automo-tive Science and Technology, September,2019 [10] Kocakulak, T., Konukseven, E.İ., Çokgünlü, S.A., 6x6 Tak-tik Tekerlekli Askeri Kara Platformu Üzerinde Kullanılacak Hidropnömatik Süspansiyon Sisteminin Modellenmesi ve Sistem Elemanlarının Sönümlemeye Etkisinin İncelen-mesi, International Symposium on Automotive Science and Technology, September,2019
  10. Kıyaklı, A. O., & Solmaz, H. (2018). Modeling of an Electric Vehicle with MATLAB/Simulink. International Journal of Automotive Science And Technology, 2(4), 9-15
  11. Uyumaz, A. (2018). Combustion, performance and emission characteristics of a DI diesel engine fueled with mustard oil biodiesel fuel blends at different engine loads. Fuel, 212, 256-267
  12. Gómez, A., García-Contreras, R., Soriano, J. A., & Mata, C. (2020). Comparative study of the opacity tendency of alterna-tive diesel fuels b