Dergiler / Journal of Thermal Engineering / 2018 / Cilt: 4 - Sayı: 5

EXERGO-ECONOMIC ANALYSIS OF MICROCHANNELS IN SINGLE-PHASE FLOW

Sayfa
2371–2380
Yayın Tarihi
2022-10-18
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Moreover, the exergo-economic performance of test section 2 (β = 4.94) was found to be greater than the exergo-economic performances of test sections 1 and 3 (β = 0.5 and 2.56) at fixed flow rate and fixed net heat input case.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:With the increase of energy demand, many researchers tried to develop scientific approaches in order to design more efficient and environmentally friendly energy systems.
📊
Temel Bulgular & Veri:The exergo-economic performance was evaluated based on the relative cost difference and unit cost per product exergy tools.
💡
Sonuç & Katkı:Moreover, the exergo-economic performance of test section 2 (β = 4.94) was found to be greater than the exergo-economic performances of test sections 1 and 3 (β = 0.5 and 2.56) at fixed flow rate and fixed net heat input case.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Exergo-Economic Performance · Microchannels · Thermo-Economics

Abstract

With the increase of energy demand, many researchers tried to develop scientific approaches in order to design more efficient and environmentally friendly energy systems. Exergo-economic (thermoeconomic) analysis of a system or device is an efficient tool for evaluating the system in terms of the thermodynamic and economic aspects. In this parametric study, exergo-economic analysis of rectangular copper plain microchannels under single-phase flow conditions were investigated using de-ionised water. The exergo-economic performance was evaluated based on the relative cost difference and unit cost per product exergy tools. The channel aspect ratio effect on the unit cost per product exergy and relative cost difference was examined using three microchannel test sections with the same channel hydraulic diameter (Dh = 0.56 mm) and length (L = 62 mm) but different aspect ratios (β = 0.5, 2.56 and 4.94) under single-phase flow conditions. The results showed that the exergo-economic performances of the three microchannel test sections decreased as the net heat input increased over the experimental range. Moreover, the exergo-economic performance of test section 2 (β = 4.94) was found to be greater than the exergo-economic performances of test sections 1 and 3 (β = 0.5 and 2.56) at fixed flow rate and fixed net heat input case.

🔖

Bu Makaleye Atıf Yap

YILMAZ, M., SÖZBİR, Ö. R., ÖZDEMİR, M. R. (2022). EXERGO-ECONOMIC ANALYSIS OF MICROCHANNELS IN SINGLE-PHASE FLOW. Journal of Thermal Engineering, Cilt: 4 - Sayı: 5, 2371–2380. https://ajindex.com/articles/566820

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (14)

  1. Lee, J., Mudawar, I. (2009). Low-temperature two-phase microchannel cooling for high-heat-flux thermal management of defense electronics. IEEE transactions on components and packaging technologies, 32(2), 453-465
  2. Ali, R. (2010). Phase Change Phenomena During Fluid Flow in Microchannels (Doctoral dissertation, KTH)
  3. Kadam, S. T., & Kumar, R. (2014). Twenty first century cooling solution: Microchannel heat sinks. International Journal of Thermal Sciences, 85, 73-92
  4. Xu, S., Guo, Z., Hu, G., Chen, W., Lewis, R., Wong, C. N. (2014). Thermal and flow fields in single board computer cabin systems using CFD analysis. Engineering Applications of Computational Fluid Mechanics, 8(4), 574-585
  5. Dix, J., Jokar, A., Martinsen, R. (2008). A microchannel heat exchanger for electronics cooling applications. In ASME 2008 6th International Conference on Nanochannels, Microchannels, and Minichannels (pp. 1935-1936). American Society of Mechanical Engineers
  6. Bulut, M., Sozbir, N. (2015). Analytical investigation of a nanosatellite panel surface temperatures for different altitudes and panel combinations. Applied Thermal Engineering, 75, 1076-1083
  7. Tabeling, P. (2007). Introduction to microfluidics. New York: Oxford University Press
  8. Tuckerman, D. B., & Pease, R. F. W. (1981). High-performance heat sinking for VLSI. IEEE Electron device letters, 2(5), 126-129
  9. Kumar, R. (2016). A critical review on energy, exergy, exergoeconomic and economic (4-E) analysis of thermal power plants. Engineering Science and Technology, an International Journal
  10. Pavelka, M., Klika, V., Vágner, P., Maršík, F. (2015). Generalization of exergy analysis. Applied Energy, 137, 158-172
  11. Şöhret, Y. (2018). Exergo-sustainability analysis and ecological function of a simple gas turbine aero-engine. Journal of Thermal Engineering (JTEN), 4(4), 2083-2095
  12. Koroglu, T., Sogut, O.S. (2017). Advanced exergy analysis of an organic rankine cycle waste heat recovery system of a marine power plant. Journal of Thermal Engineering (JTEN), 3(2), 1136-1148
  13. Okure, M. A., Musinguzi, W. B., Sebbit, A., Løvås, T. (2014). Exergoeconomic analysis of a novel small‐scale CHP system for rural electrification in Uganda. International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics
  14. Villa, A. A. O., Dutra, J. C. C., Guerrero, J. R. H., dos Santos, C. A. C. (2016). Techno-economic and exergoeconomic analysis of a micro cogeneration system for a residential