The excess power dumped in resistance can be used for heating purposes.
📌 3 Maddede Bu Makale
🎯
Amaç & Hipotez:In remote location/ far off areas where transmission cost is very high, harnessing of electrical energy from localresources are very much in use.
📊
Temel Bulgular & Veri:In this paper modeling, analysis and simulation of Self Excited induction generator atvariable loads with Electronic Load Controller is discussed.
💡
Sonuç & Katkı:The excess power dumped in resistance can be used for heating purposes.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri
Abstract
In remote location/ far off areas where transmission cost is very high, harnessing of electrical energy from localresources are very much in use. In this paper modeling, analysis and simulation of Self Excited induction generator atvariable loads with Electronic Load Controller is discussed. The modeling and simulation has been done in simpowersystemblock set of MATLAB/ SIMULINK environment. The power in surplus of the consumer load is dumped in a resistancethrough an ELC. The excess power dumped in resistance can be used for heating purposes.
🔖
Bu Makaleye Atıf Yap
TARİQ, M., YUVARAJAN, S. (2022). Simulink based modeling, analysis and simulation of self excited induction generator for use in remote areas. Istanbul University Journal of Electrical and Electronics Engineering, Cilt: 13 - Sayı: 1, 1623–1628. https://ajindex.com/articles/543667
M. Begovic, A. Pregelj, A. Rohatgi and C. Honsberg, “Green power: status and perspectives”, Proceedings of the IEEE, Vol. 89 Issue: 12, pp. 1734 -1743, Dec. 2001
I. Serban, C. Marinescu, Hybrid Power System based on Micro-Hydro and Wind Turbine Generation, 10th International Conference on Optimization of Electrical and Electronic Equipments, OPTIM’06, Brasov, Romania, 18- 19 May, 2006
Mohd Tariq and Yuvarajan S, “Modeling and Analysis of Self Excited Induction Generator with Electronic Load Controller Supplying Static Loads”, Canadian Journal on Electrical and Electronics Engineering, Vol. 4, No. 1, pp-9- 13, Feb. 2013
I. Serban, C. Ion, C. Marinescu, M.N.Cirstea “Electronic Load Controller for Stand-Alone Generating Units with Renewable Energy Sources” IEEE Industrial Electronics, IECON 2006 - 32nd Annual Conference, pp 4309 – 4312, Nov.2006
E. D. Basset and F.M. Potter, “Capacitive excitation of induction generators”, Trans. of the Amer. Inst. Electr, Eng., Vol. 54, No. 5, pp. 540-545, May 1935
C. F. Wagner, “Self-excitation of induction Motors”, Trans. of the Amer. Inst. Electr, Eng., Vol.58, pp. 47-51, Feb. 1939
J. M. Elder, J.T. Boys and J.L. Woodward, “Self-excited induction machine as a small low-cost generator”, IEE Proc. C, Vol.131, No. 2, pp. 33-41, March 1984
D. W. Novotny, D. J. Gritter and G. H. Studtmann, “Selfexcitation in inverter driven induction machines”, IEEE Transactions on Power Apparatus and Systems, Vol. PAS- 96, no.4, pp. 1117-1125, July/August 1977
A. S. Mostafa, A. L. Mohamadein, E. M. Rashad, “Analysis of series-connected wound-rotor self excited induction generator”, IEE Proceedings-B, Vol. 140, No. 5, pp. 329-336, September 1993
J. L. Bhattacharya and J. L. Woodward, “Excitation balancing of a self-excited induction generator for maximum power output”, IEE Proceedings, Vol. 135, Pt. C, No. 2, pp. 88-97, March 1988
Y.H.A. Rahim, “Excitation of isolated three-phase induction generator by a single capacitor”, IEE Proceedings-B, Vol. 140, No. 1, pp. 44-50, January 1993
B. Singh, S.S. Murthy and S. Gupta “Analysis and implementation of an electronic load controller for a selfexcited induction generator”,IEE Proceedings, Generation, Transmission and Distributions pp 51-60, Vol. 151, 2008
B. Singh, S. S. Murthy and S. Gupta “Transient Analysis of Self-Excited Induction Generator With Electronic Load Controller (ELC) Supplying Static and Dynamic Loads” IEEE Tran