Dergiler / International Journal of Automotive Engineering and Technologies / 2016 / Cilt: 5 - Sayı: 4

Drag Force Estimation of a Truck Trailer Model Using Artificial Neural Network

Sayfa
168–175
Yayın Tarihi
2022-10-18
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

For spoiler position cases, while minimum drag coefficient acting on truck trailer with spoiler is seen at - 2mm offset, maximum drag coefficient is seen at -9 mm offset

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Prediction of the drag forces acting on a truck trailer with/without spoiler is carried out by using artificial neural network (ANN).
📊
Temel Bulgular & Veri:ANN model data set include the experiments of spoiler positions which have zero level to trailer front corner, -2 mm, -4.5 mm, -9 mm, +4.5 mm and +9 mm and truck trailer without spoiler.
💡
Sonuç & Katkı:For spoiler position cases, while minimum drag coefficient acting on truck trailer with spoiler is seen at - 2mm offset, maximum drag coefficient is seen at -9 mm offset
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri

Abstract

Prediction of the drag forces acting on a truck trailer with/without spoiler is carried out by using artificial neural network (ANN). ANN model data set include the experiments of spoiler positions which have zero level to trailer front corner, -2 mm, -4.5 mm, -9 mm, +4.5 mm and +9 mm and truck trailer without spoiler. The experiments were carried out in the wind tunnel in the range of the free stream velocity between 4.6 m/s and 19.3 m/s, corresponding the Re number range, 1.0×105 -5.0×105. Mean absolute percentage error (MAPE) for training, validation and testing is 2.24%, 3.75% and 4.58% in the prediction of the drag forces, respectively. Prediction performance of the developed ANN model has a very good accuracy. According to the drag coefficients results, Reynolds number independence for truck trailer model is obtained at Reynolds number between 1.97×105 and 4.89×105. For spoiler position cases, while minimum drag coefficient acting on truck trailer with spoiler is seen at - 2mm offset, maximum drag coefficient is seen at -9 mm offset

🔖

Bu Makaleye Atıf Yap

SEYHAN, M., SARIOĞLU, M., AKANSUB, Y. E. (2022). Drag Force Estimation of a Truck Trailer Model Using Artificial Neural Network. International Journal of Automotive Engineering and Technologies, Cilt: 5 - Sayı: 4, 168–175. https://ajindex.com/articles/540367

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (14)

  1. M. Amitay, D.R. Smith, V. Kibens, D.E. Parekh, A. Glezer, "Aerodynamic flow control over an unconventional airfoil using synthetic jet actuators", AIAA J. Vol. 39, pp. 361-370, 2001
  2. M. El-Alti, V. Chernoray, P. Kjellgren, L. Hjelm, L. Davidson, "Computations and fullscale tests of active flow control applied on a VOLVO truck-trailer in Aerodyn. Heavy Veh. III ", Springer International Publishing, Vol. 79, pp. 253-267, 2016
  3. Y.E. Akansu, E. Fırat, "Control of flow around a square prism by slot jet injection from the rear surface", Exp. Therm. Fluid Sci., Vol. 34, pp. 906-914, 2010
  4. Y.E. Akansu, F. Karakaya, A. Şanlısoy, "Active control of flow around naca 0015 airfoil by using DBD plasma actuator", EPJ Web Conf., Vol. 45, pp. 1008, 2013
  5. Y.E. Akansu, M. Sarioglu, T. Yavuz, "Flow around a rotatable circular cylinderplate body at subcritical Reynolds numbers", AIAA J., Vol. 42, pp. 1073-1080, 2004
  6. M. Sarioglu, Y.E. Akansu, T. Yavuz, "Flow around a rotatable square cylinderplate body", AIAA J., Vol. 44, pp. 1065- 1072, 2006
  7. P. Gilliéron, A. Kourta, "Aerodynamic drag reduction by vertical splitter plates", Exp. Fluids., Vol.48, pp. 1-16, 2010
  8. M. Özel, E. Aygün, Y.E. Akansu, C. Bayındırlı, M. Seyhan, The passive flow control around a truck-trailer model / Bir kamyon römork modeli etrafındaki pasif akış kontrolü, Int. J. Automot. Eng. Technol., Vol. 4, Issue 4, pp. 185-192, 2016
  9. Y.E. Akansu, C. Bayindirli, M. Seyhan, "The improvement of drag force on a truck trailer vehicle by passive flow control methods", Journal Therm. Sci. Technol., Vol. 36, pp. 133-141, 2016
  10. M. El-Alti, V. Chernoray, M. Jahanmiri, L. Davidson, "Experimental and computational studies of active flow control on a model truck-trailer", EPJ Web Conf., Vol. 25, pp. 01012, 2012
  11. G.M.R. Van Raemdonck, M.J.L. Van Tooren, "Numerical and Wind Tunnel Analysis Together with Road Test of Aerodynamic Add-Ons for Trailers in Aerodyn. Heavy Veh. III", Springer International Publishing, Vol. 79, pp. 237- 252, 2016
  12. G. Fourrié, L. Keirsbulck, L. Labraga, P. Gilliéron, "Bluff-body drag reduction using a deflector", Exp. Fluids., Vol. 50, pp. 385- 395, 2011
  13. W.R. Lanser, J.C. Ross, A.E. Kaufman, "Aerodynamic Performance of a Drag Reduction Device on a Full-Scale Tractor/Trailer", SAE Technical Paper, 1991
  14. B. Khalighi, S. Zhang, C. Koromilas, S.R. Balkanyi, L.P. Bernal, G. Iaccarino, P. Moin, "Experimental and Computational Study of Unsteady Wake