KaydedilenlerDerginizi ekleyin

Dergiler / International Journal of Automotive Engineering and Technologies / 2017 / Cilt: 6 - Sayı: 2

Improvement of the Vehicle Stability Using Suspension Optimization Methods

Emre SERT
Sayfa
70–84
Yayın Tarihi
2022-10-18
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

In addition, the statistical t-test and Anova analysis were performed in order to compare means of two or three groups.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:The number of studies that are supported suspension parameters with statistical methods is very small.
📊
Temel Bulgular & Veri:However, many studies have been made on the dynamics of vehicle handling.
💡
Sonuç & Katkı:In addition, the statistical t-test and Anova analysis were performed in order to compare means of two or three groups.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri

Abstract

The number of studies that are supported suspension parameters with statistical methods is very small. However, many studies have been made on the dynamics of vehicle handling. For this reason, in this study, sensitivity analysis was performed using different stiffness values of the leaf spring and roll bar in the front suspension. The effects of the parameters on both static and dynamic analyzes were interpreted. In addition, the statistical t-test and Anova analysis were performed in order to compare means of two or three groups.

🔖

Bu Makaleye Atıf Yap

SERT, E. (2022). Improvement of the Vehicle Stability Using Suspension Optimization Methods. International Journal of Automotive Engineering and Technologies, Cilt: 6 - Sayı: 2, 70–84. https://ajindex.com/articles/540355

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (14)

  1. Karayolları Genel Müdürlüğü, 2014, "Trafik Kazaları Özeti"
  2. Xiaobin Ning, Cuiling Zhao, Jisheng Shen "Dynamic Analysis of Car Suspension Using ADAMS/Car for Development of a Software Interface for Optimization"
  3. P. Ponticel, 2003, "Dynamic testing rollover on the way." Automot. Eng. Int., pp. 26-28
  4. Spring Design Manual, SAE Spring Committee, (1996)
  5. Sert, E., Boyraz, P., "Enhancement of Vehicle Handling Based on Rear Suspension Geometry Using Taguchi Method," SAE 10.4271/2015-01-9020, 2016
  6. J. Darling, R. E. Dorey ve T. J. RossMartin, 1990, "Low cost active anti-roll suspensionfor passenger cars." In Proc. ASME Winter Annual Meeting, DynamicSystems and Control Division, Dallas, TX, USA 7. Ooi Jong Boon, "Analysis and Optimization of Portal Axle Unit Using Finite Element Modelling and Simulation".2013 8. "A Tilt Table Procedure for Measuring the Static Rollover Threshold for Heavy Trucks," 1998, SAE J2180
  7. Sert, E., Yaman, M., Yıldız, V., Dileroğlu, S., Yılmaz, A., S., "A Case Study for a Bus Body Design Improvement Using Virtual Analysis Methods," 4th International Symposium on Innovative Technologies in Engineering and Science, 2016 10. Gillespie, Thomas D., "Fundamentals of Vehicle Dynamics," SAE, 1992
  8. C., B., Winkler, R., D., Ervin, "Rollover of Heavy Commercial Vehicles," August, 1999
  9. K., M., Cohen, "A Comparative Analyses of Static and Dynamic Transit Bus Rollover Testing Using Computer Simulation," The Pennsylvania State University, 2006
  10. James R., Wilde, Gary J., Heydinger and Dennis A., Guenther, "ADAMS Simulation of Ride and Handling Performance of the Kinetic Suspension System," SAE 2006-01-1972, 2006
  11. T., Shim, C., Velusamy, "Improvement of vehicle roll stability by varying suspension properties," The University of Michigan, 2010
  12. Sert, E., "Improving Rollover Dynamics Characteristics of the Bus using Parameter Optimization and Controller Design," ITU, July 2014
  13. Sert, E., Boyraz, P., "Optimization of suspension system and sensitivity analysis for improvement of stability in a midsize heavy vehicle," Engineering Science and Technology, an International Journal, Elsevier, 2017
  14. Sert, E., Yaman, M., Yıldız, V., Dileroğlu, S., Yılmaz, A., S., "A Case Study for a Bus Body Design Improvement Using Virtual Analysis Methods," 4th International Symposium on Innovative Technologies in Engineering and Science, 2016.