KaydedilenlerDerginizi ekleyin

Dergiler / International Advanced Researches and Engineering Journal / 2018 / Cilt: 2 - Sayı: 3

On the effect of nano particle inclusion in fiber reinforced composite tensile and flexural behavior

Nurettin Furkan DOĞAN
Ahmet ERKLİĞ
Sayfa
240–244
Yayın Tarihi
2022-10-19
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Higher contents of GnPs were resulted as agglomeration in matrix mixture lead to impurities and stress concentrations, thus lower strength values were obtained in composite.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:This study aimed to investigate the effect of graphene nanoplatelets (GnPs) on the tensile and flexural properties of fiber reinforced composite material.
📊
Temel Bulgular & Veri:For this purpose; an experimental study was conducted using composite materials which were manufactured with [(0/90)6]s glass fiber and epoxy matrix by vacuum assisted resin transfer method.
💡
Sonuç & Katkı:Higher contents of GnPs were resulted as agglomeration in matrix mixture lead to impurities and stress concentrations, thus lower strength values were obtained in composite.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Composite · Epoxy · Glass

Abstract

This study aimed to investigate the effect of graphene nanoplatelets (GnPs) on the tensile and flexural properties of fiber reinforced composite material. For this purpose; an experimental study was conducted using composite materials which were manufactured with [(0/90)6]s glass fiber and epoxy matrix by vacuum assisted resin transfer method. Glass fiber reinforced (GFR) epoxy composite plates were manufactured with various graphene nanoplatelets content such 0, 0.1, 0.25 and 0.5 wt% inclusion. Maximum tensile and flexural strength values were obtained in 0.1 wt% GnPs filled composites. After this weight content, decreasing trend in the strength values was observed. When fractured specimens were examined, failure modes were supported the test results also. Higher contents of GnPs were resulted as agglomeration in matrix mixture lead to impurities and stress concentrations, thus lower strength values were obtained in composite.

🔖

Bu Makaleye Atıf Yap

DOĞAN, N. F., ERKLİĞ, A. (2022). On the effect of nano particle inclusion in fiber reinforced composite tensile and flexural behavior. International Advanced Researches and Engineering Journal, Cilt: 2 - Sayı: 3, 240–244. https://ajindex.com/articles/539383

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (11)

  1. Kostagiannakopoulou, C., Loutas, T. H., Sotiriadis, G., Markou, A., & Kostopoulos, V. (2015). On the interlaminar fracture toughness of carbon fiber composites enhanced with graphene nano-species. Composites Science and Technology, 118: 217-225
  2. S. Tsantzalis, P. Karapappas, A. Vavouliotis, P. Tsotra, V. Kostopoulos, K. Friedrich, Enhancement of the mechanical performance of an epoxy resin and fiber reinforced epoxy resin composites by the introduction of CNF and PZT particles at the microscale, Compos. A Appl. Sci. Manuf. 2007. 38: 1076-1081
  3. Jarukumjorn, K., & Suppakarn, N. Effect of glass fiber hybridization on properties of sisal fiber–polypropylene composites. Composites Part B: Engineering, 2009. 40(7): 623-627
  4. Sarasini, F., Tirillò, J., Valente, M., Valente, T., Cioffi, S., Iannace, S., & Sorrentino, L. Effect of basalt fiber hybridization on the impact behavior under low impact velocity of glass/basalt woven fabric/epoxy resin composites. Composites Part A: Applied Science and Manufacturing, 2013. 47: 109-123
  5. V. Kostopoulos, P. Karapappas, P. Tsotra, A. Paipetis, A. Vavouliotis, Enhanced fracture properties of carbon reinforced composites by the addition of multiwall carbon nanotubes, J. Compos. Mater. 2009. 43: 977-985
  6. Alsaadi, M., Erkliğ, A., & Albu-khaleefah, K. Effect of Pistachio Shell Particle Content on the Mechanical Properties of Polymer Composite. Arabian Journal for Science and Engineering, 2018: 1-8
  7. R.J. Sager, P.J. Klein, D.C. Davis, D.C. Lagoudas, G.L. Warren, H. Sue, Interlaminar fracture toughness of woven fabric composite laminates with carbon nanotube/interleaf films, J. Appl. Polym. Sci. 2011. 121(4): 2394-2405
  8. Bunch JS, van der Zande AM, Verbridge SS, Frank IW, Tanenbaum DM, Parpia JM, et al. Electromechanical resonators from graphene sheets. Science 2007. 315(5811): 490
  9. Xia, F., Mueller, T., Lin, Y. M., Valdes-Garcia, A., & Avouris, P. Ultrafast graphene photodetector. Nature nanotechnology, 2009. 4(12): 839
  10. Jeevananda, T., Kim, N. H., Lee, J. H., Basavarajaiah, S., Urs, D., & Ranganathaiah, C. Investigation of multi‐walled carbon nanotube‐reinforced high‐density polyethylene/carbon black nanocomposites using electrical, DSC and positron lifetime spectroscopy techniques. Polymer International, 2009. 58(7): 775-780
  11. Geng, Y., Liu, M. Y., Li, J., Shi, X. M., & Kim, J. K. Effects of surfactant treatment on mechanical and electrical properties of CNT/epoxy nanocomposites. Composites Part A: