Dergiler / Gümüşhane Üniversitesi Fen Bilimleri Dergisi / 2020 / Cilt: 10 - Sayı: 3

Atık Baraj Yerindeki Kaya Kütlelerinin Mühendislik Özelliklerinin Değerlendirilmesi: Gümüşhane Örneği

Evaluation of Engineering Properties of Rock Masses in Waste Dam Site: The Example of Gumushane

Sayfa
569–580
Yayın Tarihi
2022-10-18
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Bu değerler oldukça küçük değerler olup, yine de olası bir sızmanın olabileceğini göstermektedir.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Bu çalışmada Gümüştaş Atık Depolama Barajı II eksen yeri kaya kütlelerinin kazılabilirlik, taşıma kapasitesi ve geçirimlilik özellikleri değerlendirilmiştir.
📊
Temel Bulgular & Veri:Baraj eksen yeri temel kayası olan andezitlerin taşıma kapasitesi ampirik eşitlikler yardımıyla belirlenmiş olup, nihai taşıma kapasitesi 31.07MPa, izin verilebilir taşıma kapasitesi ise 10.44MPa olarak belirlenmiştir.
💡
Sonuç & Katkı:Bu değerler oldukça küçük değerler olup, yine de olası bir sızmanın olabileceğini göstermektedir.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Atık Barajı · Sızıntı Analizi · Geçirimlilik

Özet

Bu çalışmada Gümüştaş Atık Depolama Barajı II eksen yeri kaya kütlelerinin kazılabilirlik, taşıma kapasitesi ve geçirimlilik özellikleri değerlendirilmiştir. Atık depolama alanı hacminin arttırılmasına yönelik yapılacak kazı için, kaya kütlelerinin kazılabilirlik sınıfları andezitik breş için kırma yöntemi, andezit için ise kırma ve patlatma yöntemi olarak belirlenmiştir. Baraj eksen yeri temel kayası olan andezitlerin taşıma kapasitesi ampirik eşitlikler yardımıyla belirlenmiş olup, nihai taşıma kapasitesi 31.07MPa, izin verilebilir taşıma kapasitesi ise 10.44MPa olarak belirlenmiştir. Andezit ve andezitik breş kaya kütlelerinde açılmış olan temel sondaj kuyularında yapılan basınçlı su deneyleri ve sonlu elemanlar yöntemi kullanılarak yapılan sızıntı analizi ile geçirimlilik değerlendirmesi yapılmış olup, temel kaya kütlesinin az geçirimli özellikte olduğu belirlenmiştir. Bu durum atık barajı rezervuar alanında biriktirilecek kimyasal atıkların yeraltı suyuna karışmasına sebep olacaktır. Bu sızmayı önlemek için baraj eksen yeri ve rezervuar alanına 35-40cm kalınlığında geçirimsiz doğal kil malzeme serilip sıkıştırılacaktır. Yapılan bu uygulama sonlu elemanlar yöntemi kullanılarak modellenmiş ve rezervuar alanı tamamen atık su ile dolduğu durum için yapılan sızma analizi sonucunda geçirimlilik değeri 5x10-11m/s olarak belirlenmiştir. Ayrıca, temel kazısından 10m derinlikte belirlenen deşarj kesitinde meydana gelen su kaçakları 1.69x10-17m3/s ile 3.44x10-16m3/s arasında değişmektedir. Bu değerler oldukça küçük değerler olup, yine de olası bir sızmanın olabileceğini göstermektedir. Bu muhtemel sızmayı ortadan kaldırmak için serilecek doğal kil tabakanın üzerine, jeotekstil malzemeler (jeosentetik kil membran, jeomembran ve drenaj jeokompozit) serilerek rezervuar alanı tamamen geçirimsiz duruma getirilmelidir. Böylece atık barajı rezervuar alanında flotasyon sonrası biriktirilecek olan kimyasal atık suyun yeraltı suyuna karışması önlenmiş olacaktır.

Abstract

In this study, excavatability, bearing capacity and permeability characteristics of rock masses along the Gümüştaş Waste Storage Dam II site were evaluated. For the excavations to be carried out to increase the volume of the waste storage area, the excavation classes of the rock masses were determined as “Hammer “for andesitic breccia and “Hammer&Blasting” for andesite. The bearing capacity of andesite (bedrock) has been determined with the help of empirical equations and, allowable bearing capacity and ultimate bearing capacity were calculated as 10.44MPa and 31.07MPa, respectively. The permeability has been assessed by the Lugeon Tests conducted in the geotechnical drill holes located in the andesite and andesitic breccia rock masses and with the aid of the seepage analysis based on the finite element method and, the bedrock mass has been defined as low permeable. Low permeable rock masses would possibly cause the chemical wastes to be collected in the waste dam reservoir area to pollute the groundwater. To prevent the seepage, impermeable natural clay material of 35-40cm thickness should be laid and compressed along the dam axis and reservoir area. This suggestion was modeled with the aid of the finite element method, for the case that the reservoir area was completely filled with wastewater and, the permeability value was determined as 5x10-11m/s as a result of the seepage analysis. In addition, seepage values in the discharge section at a depth of 10m from the foundation vary between 1.69x10-17m3/s and 3.44x10-16m3/s. These values ​​are quite small but, are indicators of a possible seepage. To eliminate this possible seepage, the geotextile materials (geosynthetic clay membrane, Geomembrane, and drainage geocomposite) should be laid over the compressed natural clay layer, and thus mixing of the chemical wastewater, which collected after flotation, into the groundwater will be prevented.

🔖

Bu Makaleye Atıf Yap

KANIK, M., ALEMDAĞ, S. (2022). Atık Baraj Yerindeki Kaya Kütlelerinin Mühendislik Özelliklerinin Değerlendirilmesi: Gümüşhane Örneği. Gümüşhane Üniversitesi Fen Bilimleri Dergisi, Cilt: 10 - Sayı: 3, 569–580. https://ajindex.com/articles/526910

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (12)

  1. Alemdag, S., Gurocak, Z., Solanki, P., Zaman, M., 2008. Estimation of Bearing Capacity of Basalts at Atasu Dam Site, Turkey. Bulletin of Engineering Geology and the Environment, 67, 79–85.
  2. Alemdag, S., 2015. Assessment of Bearing Capacity and Permeability of Foundation Rocks at the Gumustas Waste Dam Site, (NE Turkey) Using Empirical and Numerical Analysis, Arabian Journal of Geosciences, 8, 1099–1110.
  3. Arslan, M., Aliyazıcıoğlu, I., 2001. Geochemical and Petrological Characteristics of the Kale (Gumushane) Volcanic Rocks: Implications for the Eocene Evolution of Eastern Pontide Arc Volcanism, Northeast Turkey. International Geology Review, 43, 595–610.
  4. Bostanci, H.T., Alemdag, S., Gurocak, Z. ve Gokceoglu, C., 2018. Combination of Discontinuity Characteristics and GIS for Regional Assessment of Natural Rock Slopes in a Mountainous Area (NE Turkey), CATENA, 165, 487-502.
  5. Bowles, J.E., 1996.
  6. Foundation Analysis and Design, Fifth Ed. New York, McGraw-Hill Inc. 1230p Bieniawski, Z.T., 1989. Engineering Rock Mass Classification. New York: Wiley Interscience, 251p Ersoy, H., Bulut, F., Ersoy, A.F., Berkün, M., 2008. Municipal Solid Waste Management and Practices in Coastal Cities of the Eastern Black Sea: A Case Study of Trabzon City, NE Turkey. Bulletin of Engineering Geology and the Environment, 67(3), 321–333.
  7. Ersoy, H., Karahan, M., Gelişli, K., Akgün, A., Anılan, T., Sünnetci, M. O. ve Yahşi B. K., 2019. Modelling of the Landslide-Induced Impulse Waves in the Artvin Dam Reservoir by Empirical Approach and 3D Numerical Simulation. Engineering Geology, 249, 112–128.
  8. Foyo, A., Sanchez, M. A., Tomillo, C., 2005. A Proposal for a Secondary Permeability Index Obtained from Water Pressure Tests in Dam Foundations. Engineering Geology, 77, 69–82.
  9. Gurocak, Z., Alemdag, S., Zaman, M., 2008. Rock Slope Stability and Excavatability Assessment of Rocks at the Kapikaya Dam Site, Eastern Turkey. Engineering Geology, 96, (1-2), 17-27.
  10. Gurocak, Z. ve Alemdag, S., 2012. Assessment of Permeability and Injection Depth at the Atasu Dam Site (Turkey) Based on Experimental and Numerical Analyses. Bulletin of Engineering Geology and the Environment, 71, 221–229.
  11. Gurocak, Z., Alemdag, S., Bostanci, H.T. ve Gokceoglu, C., 2017. Discontinuity Controlled Slope Failure Zoning for a Granitoid Complex: A fuzzy Approach. Rock Mechanics and Engineering, Volume 5: Surface and Underground Projects, CRC Press Taylor & Francis Group, eBook ISBN: 978-1-317-48188-1, Pages 1-25.
  12. Hoek, E., Carranz