Dergiler / European Mechanical Science / 2020 / Cilt: 4 - Sayı: 4

A Detailed Analysis of Daily, Seasonal and Yearly Performance Values of Photovoltaic Modules Using by a Simplified Method

Sayfa
142–151
Yayın Tarihi
2022-10-12
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

The highest unit energy generation was achieved with thin film PV technology.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:The performance of panels for PV system design is determined according to the performance values in standard test conditions specified in the panel catalog, without knowing the performance under actual operating conditions.
📊
Temel Bulgular & Veri:However, the operating performance of the PV panel depends on meteorological characteristics of place where the PV system is installed.
💡
Sonuç & Katkı:The highest unit energy generation was achieved with thin film PV technology.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:performance ratio · PV panel efficiency · energy generation

Abstract

The performance of panels for PV system design is determined according to the performance values in standard test conditions specified in the panel catalog, without knowing the performance under actual operating conditions. However, the operating performance of the PV panel depends on meteorological characteristics of place where the PV system is installed. Especially, if outside temperature values are above test conditions, the efficiency of the PV panel decreases and generation losses are observed. In this study, performance parameters of photovoltaic panel were calculated for four different PV panel technologies only by using their catalogue values like NOCT temperature, power-temperature coefficient etc. For this purpose, real working conditions were simulated using 3-year climate data for the meteorological conditions of Sanliurfa, Turkey. In the end, PV panel efficiency, electricity generation values and performance ratios were calculated in accordance with the temperature. According to the results obtained, the PV panels’ performance ratios decreased up to 0.75 during the summer months. The highest unit energy generation was achieved with thin film PV technology.

🔖

Bu Makaleye Atıf Yap

Aktacir, M. A., Yıldırım, E., Işıker, Y. (2022). A Detailed Analysis of Daily, Seasonal and Yearly Performance Values of Photovoltaic Modules Using by a Simplified Method. European Mechanical Science, Cilt: 4 - Sayı: 4, 142–151. https://ajindex.com/articles/512435

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (9)

  1. Gedik, E. (2016). Experimental investigation of module temperature effect on photovoltaic panels’ efficiency, Journal of Polytechnic, 19 (4): 569-576.
  2. Jerez, S., Tobin, I., Vautard, R., Montávez, J. P., López-Romero, J. M., Thais, F.,., Nikulin, G. (2015). The impact of climate change on photovoltaic power generation in Europe. Nature communications, 6(1), 1-8.
  3. Skoplaki, E., Palyvos, J. A. (2009). On the temperature dependence of photovoltaic module electrical performance: A review of efficiency/power correlations. Solar energy, 83(5), 614-624.
  4. Makrides, G. et al. (2012). Performance of Photovoltaics Under Actual Operating Conditions, Third Generation Photovoltaics. Dr. Vasilis Fthenakis (Ed.), Intechopen. Razak, A., Irwan, Y. M., Leow, W. Z., Irwanto, M., Safwati, I., Zhafarina, M. (2016). Investigation of the effect temperature on photovoltaic (PV) panel output performance. International Journal on Advanced Science, Engineering and Information Technology, 6(5): 682-688.
  5. Hasanuzzaman, M., Malek, A. B. M. A., Islam, M. M., Pandey, A. K., Rahim, N. A. (2016). Global advancement of cooling technologies for PV systems: a review. Solar Energy, 137, 25-45.
  6. Kandeal, A. W., Thakur, A. K., Elkadeem, M. R., Elmorshedy, M. F., Ullah, Z., Sathyamurthy, R., Sharshir, S. W. (2020). Photovoltaics performance improvement using different cooling methodologies: A State-of-Art Review. Journal of Cleaner Production, 122772. Piotrowski, L. J., Simões, M. G., Farret, F. A. (2020). Feasibility of water-cooled photovoltaic panels under the efficiency and durability aspects. Solar Energy, 207: 103-109.
  7. Ma, T., Li, Z., Zhao, J. (2019). Photovoltaic panel integrated with phase change materials (PV-PCM): technology overview and materials selection. Renewable and Sustainable Energy Reviews, 116, 109406. Thaib, R., Rizal, S., Mahlia, T. M. I., Pambudi, N. A. (2018). Experimental analysis of using beeswax as phase change materials for limiting temperature rise in building integrated photovoltaics. Case studies in thermal engineering, 12, 223-227.
  8. Huld, T., Amillo, A. M. G. (2015). Estimating PV Module Performance over Large Geographical Regions: The Role of Irradiance, Air Temperature, Wind Speed and Solar Spectrum, Energies, 8: 5159-5181.
  9. Ali, M., Iqbal, M. H., Sheikh, N. A., Ali, H. M., Shehryar Manzoor, M., Khan, M. M., Tamrin, K. F. (2017). Performance investigation of air velocity effects on pv modules under controlled conditions. International Journal of Photoenergy, 2017. Sc