KaydedilenlerDerginizi ekleyin

Dergiler / Annals of Medical Research / 2020 / Cilt: 27 - Sayı: 12

Comparison of translucency and flexural strength of fiberreinforced composite resin materials

Nurcan ÖZAKAR İLDAY
Özcan KARATAŞ
Rabia BİLGİÇ
Pınar GÜL
Sayfa
3254–3259
Yayın Tarihi
2022-10-12
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Results: Ribbond group showed similar translucency parameter values with the control group in all composite materials, but the EverStick group showed significantly lower than the control group (p

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Aim: The purpose of this study was to compare translucency values and flexural strength of composite resin materials reinforced with two different fibers.
📊
Temel Bulgular & Veri:Thirty specimens were obtained from the entire composites with dimensions of 25×2×2mm³.
💡
Sonuç & Katkı:Results: Ribbond group showed similar translucency parameter values with the control group in all composite materials, but the EverStick group showed significantly lower than the control group (p
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri

Abstract

Aim: The purpose of this study was to compare translucency values and flexural strength of composite resin materials reinforced with two different fibers. Materials and Methods: In this study, two direct composites (Clearfil Majesty Esthetic and Posterior) and an indirect composite (Tescera) used with a non-fiber control group and two fiber-reinforced (EverStick glass fiber and Ribbond polyethylene fiber) composite groups. Thirty specimens were obtained from the entire composites with dimensions of 25×2×2mm³. Translucency parameter values of the specimens were obtained using a spectrophotometer. The flexural strength (MPa) of the specimens was then determined by a three-point bending test at a rate of 1 mm/min until fracture occurred in the specimen using a universal tester. Data were analyzed by Two Way ANOVA and Tukey HSD multiple comparison test (α=0.05). Results: Ribbond group showed similar translucency parameter values with the control group in all composite materials, but the EverStick group showed significantly lower than the control group (p

🔖

Bu Makaleye Atıf Yap

İLDAY, N. Ö., KARATAŞ, Ö., BİLGİÇ, R., GÜL, P. (2022). Comparison of translucency and flexural strength of fiberreinforced composite resin materials. Annals of Medical Research, Cilt: 27 - Sayı: 12, 3254–3259. https://ajindex.com/articles/446522

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (14)

  1. Tsujimoto A, Barkmeier WW, Takamizawa T, et al. Mechanical properties, volumetric shrinkage and depth of cure of short fiber-reinforced resin composite. Dent Mater J 2016;35:418-24
  2. Gul P, Harorli OT, Ocal IB, et al. Color recovery effect of different bleaching systems on a discolored composite resin. Niger J Clin Pract 2017;20:1226-32
  3. Doozandeh M, Alavi AA, Karimizadeh Z. Flexural Strength Comparison of Silorane- and MethacrylateBased Composites with Pre-impregnated Glass Fiber. J Dent (Shiraz) 2016;17:105-11
  4. Sagsoz O, Ilday NO, Karatas O, et al. The bond strength of highly filled flowable composites placed in two different configuration factors. J Conserv Dent 2016;19:21-5
  5. Gao BT, Lin H, Zheng G, et al. Comparison between a silorane-based composite and methacrylate-based composites: shrinkage characteristics, thermal properties, gel point and vitrification point. Dent Mater J 2012;31:76-85
  6. Souza RO, Ozcan M, Mesquita AM, et al. Effect of different polymerization devices on the degree of conversion and the physical properties of an indirect resin composite. Acta odontologica latinoamericana: AOL 2010;23:129-35
  7. Goldberg AJ, Burstone CJ, Hadjinikolaou I, et al. Screening of matrices and fibers for reinforced thermoplastics intended for dental applications. J Biomed Mater Res 1994;28:167-73
  8. Bohlsen F, Kern M. Clinical outcome of glass-fiberreinforced crowns and fixed partial dentures: a three-year retrospective study. Quintessence Int 2003;34:493-6
  9. Dos Santos SG, Moyses MR, Alcantara CE, et al. Flexural strength of a composite resin light cured with different exposure modes and immersed in ethanol or distilled water media. Journal of conservative dentistry: JCD 2012;15:333-6
  10. Ozakar Ilday N, Celik N, Bayindir YZ, et al. Effect of water storage on the translucency of silorane-based and dimethacrylate-based composite resins with fibres. J Dent 2014;42:746-52
  11. Johnston WM, Ma T, Kienle BH. Translucency parameter of colorants for maxillofacial prostheses. The International journal of prosthodontics 1995;8:79- 86
  12. Del Mar Perez M, Saleh A, Pulgar R, et al. Light polymerization-dependent changes in color and translucency of resin composites. Am J Dent 2009;22:97-101
  13. Lee YK. Influence of filler on the difference between the transmitted and reflected colors of experimental resin composites. Dental materials: official publication of the Academy of Dental Materials 2008;24:1243-7
  14. Tuncdemir AR, Guven ME. Effect