KaydedilenlerDerginizi ekleyin

Dergiler / Turkish Journal of Engineering and Environmental Sciences / 1999 / Cilt: 23 - Sayı: 5

Mathematical Modeling of Fractionation During the Mold Filling of Semi-Solid Metal Slurries

Mahmut D. MAT
Kemal ALTINIŞIK
FERİDUN KARAKOÇ
Yüksel KAPLAN
Sayfa
381–388
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

The fractionation is reduced with a cylindrical mold, high inflow velocity and low fraction of solid.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Mold filling and fractionation of semi-solid slurries are numerically investigated.
📊
Temel Bulgular & Veri:A tin lead alloy (Sn-15%Pb) is employed to fill the mold under a range of processing conditions including inflow velocity, mold geometry, nozzle diameter and fraction of the solid.
💡
Sonuç & Katkı:The fractionation is reduced with a cylindrical mold, high inflow velocity and low fraction of solid.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Semi-solid slurries · fractionation · mold filling

Özet

Mold filling and fractionation of semi-solid slurries are numerically investigated. A tin lead alloy (Sn-15%Pb) is employed to fill the mold under a range of processing conditions including inflow velocity, mold geometry, nozzle diameter and fraction of the solid. Fractionation is identified from the trajectories of the particles that introduced at the mold inlet. The results showed that phase segregation or fractionation is promoted by the flow and the processing conditions. The fractionation is reduced with a cylindrical mold, high inflow velocity and low fraction of solid.

Abstract

Mold filling and fractionation of semi-solid slurries are numerically investigated. A tin lead alloy (Sn-15%Pb) is employed to fill the mold under a range of processing conditions including inflow velocity, mold geometry, nozzle diameter and fraction of the solid. Fractionation is identified from the trajectories of the particles that introduced at the mold inlet. The results showed that phase segregation or fractionation is promoted by the flow and the processing conditions. The fractionation is reduced with a cylindrical mold, high inflow velocity and low fraction of solid.

🔖

Bu Makaleye Atıf Yap

MAT, M. D., ALTINIŞIK, K., KARAKOÇ, F., KAPLAN, Y. (1999). Mathematical Modeling of Fractionation During the Mold Filling of Semi-Solid Metal Slurries. Turkish Journal of Engineering and Environmental Sciences, Cilt: 23 - Sayı: 5, 381–388. https://ajindex.com/articles/369391

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...