KaydedilenlerDerginizi ekleyin

Dergiler / International Journal of Intelligent Systems and Applications in Engineering / 2020 / Cilt: 8 - Sayı: 4

Hardware-in-the-Loop Based State of Charge Estimation for Li-Ion Batteries using Multilayer Perceptron

Süleyman ÇEVEN
RAİF BAYIR
Sayfa
195–205
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

After creating the multilayer perceptron model, the real-time battery state of charge the was estimated at different discharge currents in the experimental setup and the results obtained were evaluated.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:In this study, hardware-in-the-loop based real-time state of charge estimation was performed in Li-Ion batteries, which are widely used in hybrid and battery electric vehicles.
📊
Temel Bulgular & Veri:The state of charge is estimated on the Li-Ion battery cell that forms the electric vehicle battery system.
💡
Sonuç & Katkı:After creating the multilayer perceptron model, the real-time battery state of charge the was estimated at different discharge currents in the experimental setup and the results obtained were evaluated.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri

Özet

In this study, hardware-in-the-loop based real-time state of charge estimation was performed in Li-Ion batteries, which are widely used in hybrid and battery electric vehicles. The state of charge is estimated on the Li-Ion battery cell that forms the electric vehicle battery system. Multi-layer perceptron approach has been preferred as a method for estimating the battery state of charge. Discharge experiments based on different electrical loads were applied to the Li-Ion battery cell to be used in multilayer perceptron learning processes. An experimental setup has been prepared to perform the discharge process under different electrical loads. In each discharge experiment, battery open circuit voltage, battery discharge current and battery cell temperature parameters were measured and were recorded. By using the data obtained from the experiments on the battery cell, a multilayer perceptron model was created in MATLAB environment. After creating the multilayer perceptron model, the real-time battery state of charge the was estimated at different discharge currents in the experimental setup and the results obtained were evaluated.

🔖

Bu Makaleye Atıf Yap

ÇEVEN, S., BAYIR, R. (2020). Hardware-in-the-Loop Based State of Charge Estimation for Li-Ion Batteries using Multilayer Perceptron. International Journal of Intelligent Systems and Applications in Engineering, Cilt: 8 - Sayı: 4, 195–205. https://ajindex.com/articles/200281

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (9)

  1. J.-R. Riba, C. López-Torres, L. Romeral, and A. Garcia, “Rare-earth-free propulsion motors for electric vehicles: A technology review,” Renew. Sustain. Energy Rev., vol. 57, pp. 367–379, 2016
  2. A. Emadi, Y. J. Lee, and K. Rajashekara, “Power Electronics and Motor Drives in Electric, Hybrid Electric, and Plug-In Hybrid Electric Vehicles,” IEEE Trans. Ind. Electron., vol. 55, no. 6, pp. 2237–2245, 2008
  3. C. C. Chan, “The state of the art of electric and hybrid vehicles,” Proc. IEEE, vol. 90, no. 2, pp. 247–275, 2002
  4. J. A. P. Lopes, F. J. Soares, and P. M. R. Almeida, “Integration of Electric Vehicles in the Electric Power System,” Proc. IEEE, vol. 99, no. 1, pp. 168–183, 2011
  5. A. Poullikkas, “Sustainable options for electric vehicle technologies,” Renew. Sustain. Energy Rev., vol. 41, pp. 1277–1287, 2015
  6. S. Ould Amrouche, D. Rekioua, T. Rekioua, and S. Bacha, “Overview of energy storage in renewable energy systems,” Int. J. Hydrogen Energy, vol. 41, no. 45, pp. 20914–20927, 2016
  7. C. Capasso and O. Veneri, “Experimental analysis on the performance of lithium based batteries for road full electric and hybrid vehicles,” Appl. Energy, vol. 136, pp. 921–930, 2014
  8. A. F. Moghaddam, M. Mnati, H. Sun, and A. V d. Bossche, “Electric Vehicles Charging Concepts for Lithium Based Batteries,” in 2018 7th International Conference on Renewable Energy Research and Applications (ICRERA), 2018, pp. 397–401
  9. S. M. A. S. Bukhari, J. Maqsood, M. Q. Baig, S. Ashraf, and T. A. Khan, “Comparison of Characteristics -- Lead Acid, Nickel Based, Lead Crystal and Lithium Based Batteries,” in 2015 17th UKSim-AMSS International Conference on Modelling and Simulation (UKSim), 2015, pp. 444–450. [10]V. Pop, H. J. Bergveld, D. Danilov, P. P. L. Regtien, and P. H. L. Notten, “State-of-the-art of battery state-of-charge determination,” Batter. Manag. Syst. Accurate State-of-Charge Indic. Batter. Appl., pp. 11–45, 2008. [11]S. Pang, J. Farrell, J. Du, and M. Barth, “Battery state-of-charge estimation,” in Proceedings of the 2001 American control conference.(Cat. No. 01CH37148), 2001, vol. 2, pp. 1644–1649. [12]M. A. Hannan, M. S. H. Lipu, A. Hussain, and A. Mohamed, “A review of lithium-ion battery state of charge estimation and management system in electric vehicle applications: Challenges and recommendations,” Renew. Sustain. Energy Rev., vol. 78, pp. 834–854, 2017. [13]Z. Chen, L. Yang, X. Zhao, Y. Wang, and Z. He, “Online state of charge estimation of Li-