Dergiler / Electrica / 2020 / Cilt: 20 - Sayı: 2

A 1GS/s, 9-bits DAC Interleaved (2+1)-bit Then 2-bit per Cycle SAR ADC

Sayfa
153–158
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

The proposed design achieved an effective number of bits (ENOB) of 8.2 bits at Nyquist with power consumption of 12mW, resulting in a Figure of Merit (FoM) of 38.37 fJ/conversion-step

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:This paper presents a high speed Successive Approximation Register Analog to Digital Converter (SAR ADC) for low-noise low-power satellite transceiver applications.
📊
Temel Bulgular & Veri:The system is a (2+1) then 2-bit per cycle SAR ADC of 1GS/s sampling rate, 9-bits resolution designed in a 65nm standard CMOS technology.
💡
Sonuç & Katkı:The proposed design achieved an effective number of bits (ENOB) of 8.2 bits at Nyquist with power consumption of 12mW, resulting in a Figure of Merit (FoM) of 38.37 fJ/conversion-step
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Alan Parametreleri

Özet

This paper presents a high speed Successive Approximation Register Analog to Digital Converter (SAR ADC) for low-noise low-power satellite transceiver applications. The system is a (2+1) then 2-bit per cycle SAR ADC of 1GS/s sampling rate, 9-bits resolution designed in a 65nm standard CMOS technology. The system resolves 9 bits with a special switching scheme in a total of 4 cycles per sample. This is achieved by interleaving 4 Capacitive Digital to Analog Converter (C-DACs) of unit capacitance 1fF. Since the interleaving is limited to the DACs only which match well, the design does not suffer from the drawbacks of full interleaving. Hence, better power efficiency and performance metrics were obtained in comparison to regular interleaved ADCs. A special timing with an extra first bit comparator is optimized to leave proper timing margins for every step from a single 4-GHz low noise clock source which is readily available in the 8-GHz direct conversion front-end. This comparator is reused as all the other active comparators in the both interleaving phases. The proposed design achieved an effective number of bits (ENOB) of 8.2 bits at Nyquist with power consumption of 12mW, resulting in a Figure of Merit (FoM) of 38.37 fJ/conversion-step

🔖

Bu Makaleye Atıf Yap

EL-SAWY, S., TEKİN, A. (2020). A 1GS/s, 9-bits DAC Interleaved (2+1)-bit Then 2-bit per Cycle SAR ADC. Electrica, Cilt: 20 - Sayı: 2, 153–158. https://ajindex.com/articles/153714

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (13)

  1. C. Liu, S. Chang, G. Huang, Y. Lin, “A 10-bit 50-MS/s SAR ADC with a Monotonic Capacitor Switching Procedure”, IEEE Journal of Solid-State Circuits, vol. 45, no. 4, pp. 731-740, 2010
  2. T. V. Cao, S. Aunet, T. Ytterdal, “A 9-bit 50MS/s Asynchronous SAR ADC in 28nm CMOS”, NORCHIP 2012, Cpenhagen, 2012, pp. 1-6
  3. Q. Fan, J. Chen, “A 10-bit 400 MS/s Asynchronous SAR ADC Using Dual-DAC Architecture for Speed Enhancement,” 2017 IEEE 60th International Midwest Symposium on Circuits and Systems (MWSCAS), Boston, MA, 2017, pp. 583-586
  4. A. Ashraf, S. Ashraf, N. Z. Rizvi, S. A. Dar, “Low Power Design of Asynchronous SAR ADC,” 2016 International Conference on Electrical, Electronics, and Optimization Techniques (ICEEOT), Chennai, 2016, pp. 4214-4219
  5. J. Zhao, N. Mei, Z. Zhang, L. Meng, “Vaq-Based Tri-level Switching Scheme for SAR ADC,” Electronics Letters, vol. 54, no. 2, pp. 66-68, 2018
  6. C. Chan, Y. Zhu, W. Zhang, S. P. U, R. P. Martins, “A Two-Way Interleaved 7-b 2.4-GS/s 1-Then-2 b/Cycle SAR ADC with Background Offset Calibration,” IEEE Journal of Solid-State Circuits, vol. 53, no. 3, pp. 850-860, March 2018
  7. C. Lin, Y. Wei and T. Lee, “A 10-bit 2.6-GS/s Time-Interleaved SAR ADC With a Digital-Mixing Timing-Skew Calibration Technique,” in IEEE Journal of Solid-State Circuits, vol. 53, no. 5, pp. 1508-1517, 2018
  8. W. Kim, H. Kong, Y. Roh, H. Kang, S. Hwang, D. Jo, D. Chang, M. Seo, S. Ryu, “A 0.6 V 12 b 10 MS/s Low-Noise Asynchronous SAR-Assisted Time-Interleaved SAR (SATI-SAR) ADC,” IEEE Journal of Solid-State Circuits, vol. 51, no. 8, pp. 1826-1839, 2016
  9. D. Stepanovic and B. Nikolic, “A 2.8 GS/s 44.6 mW Time-Interleaved ADC Achieving 50.9 dB SNDR and 3 dB Effective Resolution Bandwidth of 1.5 GHz in 65 nm CMOS,” IEEE Journal of Solid-State Circuits, vol. 48, no. 4, pp. 971-982, 2013
  10. G. Dai, C. Chen, S. Ma, F. Ye, J. Ren, “A 400-MS/s 8-b 2-b/cycle SAR ADC with Shared Interpolator and Alternative Comparators,” 2014 IEEE International Symposium on Circuits and Systems (ISCAS), Melbourne VIC, 2014, pp. 2365-2368
  11. J. Song, X. Tang, N. Sun, “A 10-b 2b/cycle 300MS/s SAR ADC with a Single Differential DAC in 40nm CMOS,” 2017 IEEE Custom Integrated Circuits Conference (CICC), Austin, TX, 2017, pp. 1-4
  12. Y. Lien, “A 4.5-mW 8-b 750-MS/s 2-b/step Asynchronous Subranged SAR ADC in 28-nm CMOS technology,” 2012 Symposium on VLSI Circuits (VLSIC), Honolulu, HI, 2012, pp. 88-89
  13. C. Chan, Y. Zhu, I. Ho, W. Zhang, S. U, R. P. Martins, “16.4