KaydedilenlerDerginizi ekleyin

Dergiler / Journal of Engineering Technology and Applied Sciences / 2026 / Cilt: 6 Sayı: 1

Comparison of Gamma Sources (Cobalt and Cesium) for Density Measurement of Metals and Alloys via Using Transmission Technique

Muttalip Ergun Turgay(Yalova Üniversitesi)0000-0003-1708-8283
Sayfa
37–43
Yayın Tarihi
2021-04-30
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

It could be said that, these differences are still in acceptable limits.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:One of the solutions for density measurement is to make use of gamma-ray transmission technique.
📊
Temel Bulgular & Veri:We studied by this technique, using by Co-60 and Cs-137.
💡
Sonuç & Katkı:It could be said that, these differences are still in acceptable limits.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Co-60/Cs-137 · metal/alloy · Co-60/Cs-137

Abstract

One of the solutions for density measurement is to make use of gamma-ray transmission technique. We studied by this technique, using by Co-60 and Cs-137. Each source, without materials in geometry, was counted and noted intensities as (I0). All materials were counted and noted intensities as (I). [I/I0] rates were calculated. Now, density of materials could be determined via using Beer-Lambert Equation. Experimental application was performed on industrial metals or metal alloys like lead&copper and steel&brass. Given densities and obtained densities were compared. Differences or deviations for lead, stell copper and brass are -5.07; 0.26; 1.11; -5.73 (Co-60) and 1.07; 3.08; -0.22; 2.34 (Cs-137) consequently. It could be said that, these differences are still in acceptable limits.

🔖

Bu Makaleye Atıf Yap

Turgay, M. E. (2021). Comparison of Gamma Sources (Cobalt and Cesium) for Density Measurement of Metals and Alloys via Using Transmission Technique. Journal of Engineering Technology and Applied Sciences, Cilt: 6 Sayı: 1, 37–43. https://doi.org/10.30931/jetas.891679

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (17)

  1. Mix, P.E., “Introduction to non-destructive testing”, John Wiley, New York, (1987).
  2. Turgay, M.E., “Density assessment of different metals and alloys by gamma-ray transmission technique via using Co-60 radioactive source”, Journal of Physical Science and Application 7(1) (2017): 39–42.
  3. Földiak, G., “Industrial application of radioisotopes”, Institute of Isotopes of the Hungarian Academy of Sciences, Budapest, (1986).
  4. Buyuk, B., “Gamma attenuation behavior of some stainless and boron steels”, Acta Physica Polonica A 127(4) (2015): 1342-1345.
  5. Buyuk, B., Tugrul, A.B., “An investigation on gamma attenuation behaviour of titanium diboride reinforced boron carbide–silicon carbide composites”, Radiation Physics and Chemistry 97 (2014): 354-359.
  6. Moreira, A.C., Appoloni, C.R., Fernandes, C.P., “Gamma ray transmission technique applied to porous phase characterization of low-porosity ceramic samples”, Materials and structures 46(4) (2013): 629-637.
  7. Karagoz, B., et al. “Determination of Gamma Transmittance and Density Assessment for Al Doped ZnO Thin Films by Using Gamma Transmission Technique”, Defect and Diffusion Forum 312–315 (2011): 830–835, https://doi.org/10.4028/www.scientific.net/ddf.312-315.830.
  8. Bjoernstad, T., Stamatakis, E., “Scaling studies with gamma transmission technique”, Conference: Oil Field Chemistry, At: Geilo, Norway, (2006).
  9. Course Notes, Radiation Detectors, Chapter 18, Oregon State University.
  10. Gardner, R.P., Ely, R.L., “Radioisotopes Measurement Applications in Engineering”, Reinhold Publishing Co., New York, (1967).
  11. Bilge, A.N., Tuğrul, A.B., “Bases of Industrial Radiography”, I.T.U. Publishing, Istanbul, (1990).
  12. Turgay, M.E., “Density measurement for different metals by gamma-ray transmission technique used by radioactive isotopes”, M.Sc. Thesis, Istanbul Technical University, Istanbul, (2005).
  13. Turgay, M.E., “Density assessment of different metals and alloys by gamma-ray transmission technique via using Co-60 radioactive source”, Journal of Physical Science and Application 7(1) (2017): 39–42.
  14. Buyuk, B., “Gamma attenuation behavior of some stainless and boron steels”, Acta Physica Polonica A 127(4) (2015): 1342-1345.
  15. Buyuk, B., Tugrul, A.B., “An investigation on gamma attenuation behaviour of titanium diboride reinforced boron carbide–silicon carbide composites”, Radiation Physics and Chemistry 97 (2014): 354-359.
  16. Moreira, A.C., Appoloni, C.R., Fernandes, C.P., “Gamma ray transmission technique applied to porous phase characterization of low-porosity ceramic samples”, Materials and structures 46(4) (2013): 629-637.
  17. Karagoz, B., et al. “Determination of Gamma Transmittance and Density Assessment for Al Doped ZnO Thin Films by Using Gamma Transmission Technique”, Defect and Diffusion Forum 312–315 (2011): 830–835, https://doi.org/10.4028/www.scientific.net/ddf.312-315.830.