KaydedilenlerDerginizi ekleyin

Dergiler / International Advanced Researches and Engineering Journal / 2026 / Volume: 3 Issue: 2

Production of bioplastic from potato peel waste and investigation of its biodegradability

Ezgi Bezirhan Arıkan(Faculty of Engineering, Department of Environmental Engineering, Mersin University, Mersin, 33343, Turkey)0000-0003-4203-165X
H. Duygu Bilgen(Faculty of Engineering, Department of Environmental Engineering, Mersin University, Mersin, 33343, Turkey)0000-0002-9510-8131
Sayfa
—
Yayın Tarihi
2019-08-15
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

In this way, petroleum-based plastic pollution may be decreased both in Turkey and the world.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Recently, environmental problems caused by petroleum-based plastics have been increasing.
📊
Temel Bulgular & Veri:Biodegradability tests showed that PPB biodegraded at about 71% in moist soil and 100% in vermicompost within four weeks.
💡
Sonuç & Katkı:In this way, petroleum-based plastic pollution may be decreased both in Turkey and the world.
🔬Tür:Research Article
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Biodegradability · Bioplastic · Food Industry

Abstract

Recently, environmental problems caused by petroleum-based plastics have been increasing. Therefore, researchers have begun to investigate new materials that may be alternatives to plastics. Bioplastics are considered as green materials alternatives to plastics and they are produced from renewable resources such as corn and potatoes, or microorganisms under certain conditions. In addition, most researchers are concerned with renewable resources for non-food using, such as bioplastic production. For this reason, researchers have been focusing on the utilization of the wastes as bioplastic products. In this study, the bioplastic was produced from potato peel as the food industry waste. Also, some properties of the produced bioplastic such as water absorption capacity and biodegradability were analyzed. Furthermore, water absorption capacity and biodegradability of a commercial bioplastic were also determined in order for the comparison with the one produced from potato peel waste in different conditions. It was found that the produced potato peel bioplastic (PPB) had higher water absorption capacity than commercial bioplastic (CB). Therefore, PPB may not be used in the food service industry but can be used as packing material. Biodegradability tests showed that PPB biodegraded at about 71% in moist soil and 100% in vermicompost within four weeks. On the other hand, it was determined that CB was not degraded in the soil or in the compost in four weeks. Therefore, as a food industry waste, potato peel can be used in biodegradable bioplastic production. In this way, petroleum-based plastic pollution may be decreased both in Turkey and the world.

🔖

Bu Makaleye Atıf Yap

Arıkan, E. B., Bilgen, H. D. (2019). Production of bioplastic from potato peel waste and investigation of its biodegradability. International Advanced Researches and Engineering Journal, Volume: 3 Issue: 2. https://doi.org/10.35860/iarej.420633

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (29)

  1. Mekonnen, T., P. Mussone, H. Khalil, D. Bressler, Progress in bio-based plastics and plasticizing modifications. Journal of Material Chemistry A, 2013. 43(1): p.13379-13398.
  2. Zarate-Ramirez, L.S., A. Romero, I. Martinez, C. Bengoeche, P. Partal, A. Guerrero, Effect of aldehydes on thermomechanical properties of gluten-based bioplastics. Food and Bioproducts Processing, 2014. 92: p.20–29.
  3. Philp, J.C., R.J. Ritchie, K. Guy, Biobased plastics in a bioeconomy. Trends in Biotechnology, 2013. 31(2): p.65-67.
  4. Barker, T., In Climate Change 2007: Mitigation. Contribution of Working Group III to the Fourth Assessment, Report of the Intergovernmental Panel on Climate Change. 2010, USA: Cambridge University Press.
  5. El Kadi, S., Bioplastic production form inexpensive sources bacterial biosynthesis, cultivation system, production and biodegrability. 2010, USA: VDM Publishing House.
  6. Peelman, N., P. Ragaert, B. De Meulenaer, D. Adons, R. Peeters, L. Cardon, F.V. Impe, F. Devlieghere, Application of bioplastics for food packaging. Trends in Food Science and Technology, 2013. 32(2):p. 128-141.
  7. Mirel. [cited 2017 03 March]; Available from: https://pdfs.semanticscholar.org/fa36/d6c497ea7d4d9830682a671ee11cd2746d30.pdf
  8. Karana, E., Characterization of ‘natural’ and ‘high-quality’ materials to improve perception of bioplastics. Journal of Cleaner Production, 2012. 37: p. 316-325.
  9. Sarasa, J., J. M. Gracia, C. Javierre, Study of the biodisintegration of a bioplastic material waste. Bioresource Technology, 2008. 100(15): p.3764-3768
  10. Luengo, J. M., B. Garcia, A. Sandoval, G. Naharro, E. R. Olivera, Bioplastics from microorganisms. Current Opinion in Microbiology, 2003. 6(3): p.251–260.
  11. Alvarez-Chavez, C.R., S. Edward, R. Moure-Eraso, K. Geiser, Sustainability of bio-based plastics: general comparative analysis and recommendations for improvement. Journal of Cleaner Production, 2012. 23(1): p.47–56.
  12. Schulze, C., M. Juraschek, C. Herrmann, S. Thiede, Energy Analysis of Bioplastics Processing. Procedia CIRP 2017. 61: p. 600-605.
  13. Kaith, B.S., R. Jindal, A.K. Jana, M. Maiti, Development of corn starch based green composites reinforced with Saccharum spontaneum L fiber and graft copolymers – Evaluation of thermal, physico-chemical and mechanical properties. Bioresource Technology, 2009. 101(17): p. 6843–6851.
  14. Anjum, A., M. Zuber, K.M. Zia, A. Noreen, M. Naveed Anjum, S. Tabasum, Microbial production of polyhydroxyalkanoates (PHAs) and its copolymers: A review of recent advancements. International Journal of Biological Macromolecules, 2016. 89: p.161–174.
  15. Roldán-Carrillo, T., R. Rodríguez-Vazqáuez, D. Díaz-Cervantes, H. Vázquez-Torres, A. Manzur-Guzmán, A. Torres-Domínguez, Starch-based plastic polymer degradation by the white rot fungus Phanerochaete chrysosporium grown on sugarcane bagasse pith: enzyme production. Bioresource Technology, 2003. 86(1): p.1-5.
  16. Ma, X., P. R. Chang, J. Yu, M. Stumborg, Properties of biodegradable citric acid-modified granular starch/thermoplastic pea starch composites. Carbohydrate Polymers, 2008. 75(1): p.1–8.
  17. Naik, S. N., V. V. Goud, P.K. Rout, A.K. Dalai, Production of first and second generation biofuels: A comprehensive review. Renewable and Sustainable Energy Reviews, 2010. 14(2): p.578–597.
  18. Tupa, M., L. Maldonado, A. Vazquez, M. L. Foresti, Simple organocatalytic route for the synthesis of starch esters. Carbohydrate Polymers 2013. 98(1): p.349– 357.
  19. [cited 2017 03 March]; Available from: http://www.carboncommentary.com/2011/09/02/2061
  20. Lagaron, J. M., A. Lopez-Rubio, Nanotechnology For Bioplastics: Opportunities, Challenges and Strategies. Trends in Food Science & Technology, 2011. 22(11): p.611-617.
  21. Singh, S. and A.K. Mohanty, Wood fiber reinforced bacterial bioplastic composites: Fabrication and performance evaluation. Composites Science and Technology, 2007. 67(9): p.1753–1763.
  22. Paetau, I., C. Zue Chen, and J. lin Jane, Biodegradable Plastic Made from Soybean Products. 1. Effect of Preparation and Processing on Mechanical Properties and Water Absorption. Ind. Eng. Chem. Res. 1994. 33(7): p.1821-1827.
  23. Liu, W., M. Misra, P. Askeland, L. T. Drzal, A. K. Mohanty, Green composites from soy based plastic and pineapple leaf fiber: fabrication and properties evaluation. Polymer, 2005. 46(8): p.2710–272.
  24. Maran, J. P., V. Sivakumar, K. Thirugnanasambandham, R. Sridhar, Degradation behavior of biocomposites based on cassava starch buried under indoor soil conditions. Carbohydrate polymers, 2014. 30(101): p.20-28.
  25. Spaccini, R., D. Todisco, M. Drosos, A. Nebbioso, A. Piccolo, Decomposition of bio-degradable plastic polymer in a real on farm composting process. Chemical and Biological Technologies in Agriculture, 2016. 3(4) DOI 10.1186/s40538-016-0053-9.
  26. Ashok A., R. Abhijith, C. R. Rejeesh, Material characterization of starch derived bio degradable plastics and its mechanical property estimation. Materials Today: Proceedings, 2018. 5(1): p.2163–2170.
  27. Mahalakshmi V., Evaluation of Biodegradation of Plastics. International Journal Of Innovative Research & Development, 2014. 3(7): p.185-190.
  28. Ismail, N. A., S. M. Tahir, N. Yahya, M. F.A. Wahid, N. E. Khairuddin, I. Hashim, N. Rosli, M. A. Abdullah, Synthesis and Characterization of Biodegradable Starch-based Bioplastics. Materials Science Forum, 2016. 846: p. 673-678.
  29. Guohua, Z., L. Ya, F. Cuilan, Z. Min, Z. Caiqiong, C. Zongdao, Water resistance, mechanical properties and biodegradability of methylated-cornstarch/poly(vinyl alcohol) blend film. Polymer Degradation and Stability, 2006. 91(4): p.703–711.