KaydedilenlerDerginizi ekleyin

Dergiler / Middle East Journal of Science / 2026 / Volume: 12 Issue: 1

EFFECTIVE CHARGE AND SPECIFIC HEAT RATIO CALCULATIONS FOR N, O, Ne, Ar, Kr, AND Xe GASES IN PLASMA FOCUS

Yaşar Ay(DİCLE ÜNİVERSİTESİ)0000-0002-9888-8700
Sayfa
—
Yayın Tarihi
2026-06-29
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

These tables can be used in plasma research for the equations of the desired temperature and gases for the effective charge number and specific heat ratio calculations.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:The effective charge number and specific heat ratio are considered as two important thermodynamic parameters for the plasma focus calculations.
📊
Temel Bulgular & Veri:In this work, both of them are calculated with respect to plasma temperature ranging from 0 eV to 107 eV by using the corona model for N, O, Ne, Ar, Kr, and Xe gases.
💡
Sonuç & Katkı:These tables can be used in plasma research for the equations of the desired temperature and gases for the effective charge number and specific heat ratio calculations.
🔬Tür:Modelleme & Sayısal Simülasyon
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Effective charge · Plasma · Plasma focus

Abstract

The effective charge number and specific heat ratio are considered as two important thermodynamic parameters for the plasma focus calculations. In this work, both of them are calculated with respect to plasma temperature ranging from 0 eV to 107 eV by using the corona model for N, O, Ne, Ar, Kr, and Xe gases. Calculated effective charges and specific heat ratios are plotted separately for each gas. Every single plot from these calculations is carefully examined in order to divide the whole temperature range calculations into small temperature ranges so that the best curve-fitting can be achieved for more accurate calculations. The 4th order polynomials are well fitted for curve-fitting, and the corresponding equations with respect to small temperature intervals are found so that these equations can be used in the future calculations of the effective charge and specific heat ratio of the plasma for N, O, Ne, Ar, Kr, and Xe gases. The coefficients from the curve-fittings for each gas are given in the tables. These tables can be used in plasma research for the equations of the desired temperature and gases for the effective charge number and specific heat ratio calculations.

🔖

Bu Makaleye Atıf Yap

Ay, Y. (2026). EFFECTIVE CHARGE AND SPECIFIC HEAT RATIO CALCULATIONS FOR N, O, Ne, Ar, Kr, AND Xe GASES IN PLASMA FOCUS. Middle East Journal of Science, Volume: 12 Issue: 1. https://doi.org/10.51477/mejs.1938978

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (23)

  1. J. O. Pouzo and M. M. Milanese, “Applications of the dense plasma focus to nuclear fusion and plasma astrophysics,” IEEE Trans. Plasma Sci., vol. 31, no. 6, pp. 1237–1242, 2003.
  2. U. Jager and H. Herold, “Fast ion kinetics and fusion reaction mechanism in the plasma focus,” Nucl. Fusion, vol. 27, pp. 407–423, 1987.
  3. E. J. Lerner, S. M. Hassan, I. Karamitsos-Zivkovic, and R. Fritsch, “Focus Fusion: Overview of Progress Towards p-B11 Fusion with the Dense Plasma Focus,” J. Fusion Energy, vol. 42, no. 7, Art. no. 7, 2023.
  4. M. Scholz, B. Bienkowska, I. M. Ivanova-Stanik, L. Karpinski, M. Paduch, K. Tomaszewski, E. Zielinska, J. Kravarik, P. Kubes, A. Banaszak, L. Jakubowski, M. Sadowski, A. Szydlowski, H. Schmidt, and S. Vitulli, “Correlation between pinch dynamics, neutron and X-ray emission from megajoule plasma focus device,” Vacuum, vol. 76, nos. 2–3, pp. 361–364, 2004.
  5. C. Goyon, A. J. Link, O. B. Drury, A. E. Youmans, J. Angus, S. Jiang, S. Rocco, S. F. Chapman, C. M. Cooper, M. McMahon,
  6. A. Jibodu, D. Max, R. Anaya, P. C. Campbell, J. Park, B. Shaw, J. Sin, and A. E. Schmidt, “Neutron generation dynamics inside a MA-class dense plasma focus Z-pinch,” Phys. Plasmas, vol. 32, Art. no. 033105, 2025.
  7. S. L. Yap, L. H. Muhammad, H. Y. Tan, L. K. Lim, S. Lee, and H. P. Wante, “Neutron Yield Enhancement Through Gas Admixture and Cathode Radius Variation in a Plasma Focus Device,” IEEE Trans. Plasma Sci., vol. 53, no. 7, pp. 1747–1757, 2025.
  8. M. Zakaullah, K. Alamgir, M. Shafiq, M. Sharif, and A. Waheed, “Scope of plasma focus with argon as a soft X-ray source,” IEEE Trans. Plasma Sci., vol. 30, no. 6, pp. 2089–2094, 2002.
  9. A. Hosseinzadeh, N. Vosoughi, T. D. Mahabadi, and D. Piriaei, “The Investigation of Pre-ionization Effect on the Improvement of Pinch Quality and Increased Hard X-ray Radiation in a Dense Plasma Focus Device,” J. Fusion Energy, vol. 43, Art. no. 20, 2024.
  10. H. S. Poh, M. C. Lee, S. S. Yap, S. Y. Teow, D. A. Bradley, and S. L. Yap, “Potential use of plasma focus radiation sources in superficial cancer therapy,” Jpn. J. Appl. Phys., vol. 59, Art. no. SHHB06, 2020.
  11. L. Isolan, D. Laghi, I. Zironi, M. Cremonesi, C. Garibaldi, F. Buontempo, and M. Sumini, “Compact and very high dose-rate plasma focus radiation sources for medical applications,” Radiat. Phys. Chem., vol. 200, Art. no. 110296, 2022.
  12. R. S. Rawat, “Dense Plasma Focus—From Alternative Fusion Source to Versatile High Energy Density Plasma Source for Plasma Nanotechnology,” J. Phys. Conf. Ser., vol. 591, Art. no. 012021, 2015.
  13. F. M. Aghamir, A. R. Momen-Baghdadabad, and B. Shamsi, “Synthesis of nitrogenized iron thin film at different angular positions in a plasma focus device,” Vacuum, vol. 238, Art. no. 114250, 2025.
  14. M. Akel, S. Ismael, S. Lee, S. H. Saw, and H. J. Kunze, “Effects of Power Terms and Thermodynamics on the Contraction of Pinch Radius in Plasma Focus Devices Using the Lee Model,” J. Fusion Energy, vol. 35, pp. 807–815, 2016.
  15. H. Barati and M. Habibi, “Gas mixture effects on ion-beam flux characteristics from dense plasma focus device: Investigation by the Vlasov–Maxwell equations and experiments,” Contrib. Plasma Phys., vol. 59, no. 10, Art. no. e201800174, 2019.
  16. N. A. Rashid, S. N. Mohamed, K. T. Chaudhary, S. Lee, S. H. Saw, and J. Ali, “Effects of Approximation and Close-Fitting Technique of Corona Model on Neon Soft X-Ray Emission in 3-kJ Plasma Focus,” IEEE Trans. Plasma Sci., vol. 43, no. 7, pp. 2146–2154, 2015.
  17. M. A. Abd Al-Halim, “Estimation of the plasma sheath thickness and particle number density in the axial phase of plasma coaxial accelerator,” Vacuum, vol. 138, pp. 80–86, 2017.
  18. M. Akel, S. Al-Hawat, and S. Lee, “Numerical Experiments on Soft X-ray Emission Optimization of Nitrogen Plasma in 3 kJ Plasma Focus SY-1 Using Modified Lee Model,” J. Fusion Energy, vol. 28, pp. 355–362, 2009.
  19. B. L. Bures, M. Krishnan, and Y. Eshaq, “Controlling the Neutron Yield from a Small Dense Plasma Focus using Deuterium-Inert Gas Mixtures,” AIP Conf. Proc., vol. 1088, pp. 195–198, 2009.
  20. M. A. Mohammadi, S. Sobhanian, and R. S. Rawat, “Neutron production with mixture of deuterium and krypton in Sahand Filippov type plasma focus facility,” Phys. Lett. A, vol. 375, no. 33, pp. 3002–3006, 2011.
  21. S. H. Saw, P. L. Chong, R. S. Rawat, C. T. Li Ching, P. Lee, A. Talebitaher, and S. Lee, “The Effect of Specific Heat Ratio on Neutron Yield,” IEEE Trans. Plasma Sci., vol. 42, no. 1, pp. 99–104, 2014.
  22. A. Talaei and S. M. Sadat Kiai, “Influence of Admixture Gas on the Enhancement of Neutron Production in Plasma Focus Devices,” J. Fusion Energy, vol. 29, pp. 427–435, 2010.
  23. C. S. Wong and R. Mongkolnavin, Elements of Plasma Technology. Singapore: Springer, 2016. S. Lee, “Plasma Focus Radiative Model: Review of the Lee Model Code,” J. Fusion Energy, vol. 33, pp. 319–335, 2014.