SEM and EDS analyzes of fractured surfaces were performed from the broken samples after the three point bending test.
📌 3 Maddede Bu Makale
🎯
Amaç & Hipotez:This study was carried out to determine the microstructure and mechanical properties of S49 rail steel.
📊
Temel Bulgular & Veri:For this purpose, firstly, three samples of S49 rail steel material were prepared by cutting by wire erosion method for three point bending test.
💡
Sonuç & Katkı:SEM and EDS analyzes of fractured surfaces were performed from the broken samples after the three point bending test.
🔬Tür:Araştırma Makalesi
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:S49 rail steel · Mechanical properties · Three point bending
Abstract
This study was carried out to determine the microstructure and mechanical properties of S49 rail steel. For this purpose, firstly, three samples of S49 rail steel material were prepared by cutting by wire erosion method for three point bending test. Microstructural analyzes of S49 rail steel were examined by scanning electron microscopy (SEM). Energy dispersion spectrometer (EDS) analysis was performed to determine the chemical composition of the S49 rail steel material. Hardness test and three point bending test were performed to determine the mechanical properties of the samples. SEM and EDS analyzes of fractured surfaces were performed from the broken samples after the three point bending test.
Rıdvanoğulları, A., Çetin, T., Akkaş, M. (2021). EXPERIMENTAL INVESTIGATION OF THE MECHANICAL AND MICROSTRUCTURE PROPERTIES OF S49 RAIL STEEL. European Journal of Technique, Cilt: 11 Sayı: 1, 43–46. https://doi.org/10.36222/ejt.812142
Referans1: Vural, D., Gencer, C. and Karadoğan, D. (2014). Ulaştırma uygulamalarına yönelik çok modlu model önerisi. Savunma Bilimleri Dergisi, 13(1), pp. 75-105.
Referans2: Çetin, T. and Akkaş, M. (2020). Effect of WC Reinforced on Microstructure and Mechanical Properties of CuAlMn Alloys Produced by Hot Pressing Method. European Journal of Technique, 10(1), pp. 173-183.