Dergiler / Tekstil ve Konfeksiyon / 2026 / Volume: 27 Issue: 3

SÜRDÜRÜLEBİLİR KISA LİF İPLİK TEKNOLOJİSİ İÇİN GERİ DÖNÜŞÜM PAMUK VE POLYESTER LİFLERİNİN KULLANIMI

USAGE OF RECYCLED COTTON AND POLYESTER FIBERS FOR SUSTAINABLE STAPLE YARN TECHNOLOGY

Sayfa
—
Yayın Tarihi
2017-09-30
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Çal ı ş mada bu kar ı ş ı mlar ile ilgili önemli bulgular elde edilmi ş tir.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Bu çal ı ş mada pamuk lifi (CO), iplik üretimi s ı ras ı nda olu ş an at ı klardan geri dönü ş üm pamuk lifi (r-CO) ve PET ş i ş e at ı klar ı ndan geri dönü ş türülen lif (r-PET) kullan ı larak iplikler üretilmi ş tir.
📊
Temel Bulgular & Veri:Üretilen ipliklere kopma mukavemeti, kopma uzamas ı , düzgünsüzlük ve tüylülük performans testleri uygulanm ı ş t ı r.
💡
Sonuç & Katkı:Çal ı ş mada bu kar ı ş ı mlar ile ilgili önemli bulgular elde edilmi ş tir.
🔬Tür:Literatür & Derleme Çalışması
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Sustainable textiles · Recycling · Recycled fibers

Özet

Bu çal ı ş mada pamuk lifi (CO), iplik üretimi s ı ras ı nda olu ş an at ı klardan geri dönü ş üm pamuk lifi (r-CO) ve PET ş i ş e at ı klar ı ndan geri dönü ş türülen lif (r-PET) kullan ı larak iplikler üretilmi ş tir. Üretilen ipliklere kopma mukavemeti, kopma uzamas ı , düzgünsüzlük ve tüylülük performans testleri uygulanm ı ş t ı r. Çal ı ş mada geri dönü ş üm pamuk ve polyester liflerinin open-end iplik e ğ irme sisteminde olumsuz özelliklerini elimine etmek amaçlanm ı ş t ı r. Literatürde r-CO/r-PET kar ı ş ı mlar ı na dair bir bilgi bulunmamaktad ı r. Çal ı ş mada bu kar ı ş ı mlar ile ilgili önemli bulgular elde edilmi ş tir. Çal ı ş madaki CO/r-CO ve CO/r-PET ikili kar ı ş ı mlar ı ndan elde edilen sonuçlar literatürde yer alan bilgileri do ğ rulamaktad ı r. Ayr ı ca, çal ı ş ma mevcut literatüre katk ı da bulunmaktad ı r. 

Abstract

In this study, yarns were produced from cotton fibers (CO), recycled cotton fibers obtained from yarn wastes (r-CO) and fibers produced from recycled PET bottles (r-PET). Tensile strength, elongation at break, unevenness (CVm), yarn imperfections (IPI) values and hairiness properties of these yarns were measured. The purpose of this study was to eliminate negative characteristics of recycled cotton and polyester fibers with using together by open-end spinning system. There was no study about r-CO/r-PET blends in the literature. This study was also given significant findings related to these blends. This paper obtained results which corroborate the findings of a considerable number of the previous works in CO/r-CO and CO/r-PET binary blends. Furthermore, this study contributes to the extant literature. 

🔖

Bu Makaleye Atıf Yap

Telli, A., Babaarslan, O. (2017). SÜRDÜRÜLEBİLİR KISA LİF İPLİK TEKNOLOJİSİ İÇİN GERİ DÖNÜŞÜM PAMUK VE POLYESTER LİFLERİNİN KULLANIMI. Tekstil ve Konfeksiyon, Volume: 27 Issue: 3. https://ajindex.com/articles/1111390

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (22)

  1. Tarakcioğlu, I., 2008, Organic Cotton and Textile Industry. Istanbul Chamber of Commerce. Istanbul, 247 s.
  2. Carmichael, A., 2015, Polyester Continues to Lead Growth. ITMF Annual Conference, Sep, 10–12, San Francisco, USA.
  3. Altun, Ş., 2012. Prediction of Textile Waste Profile and Recycling Opportunities in Turkey. FIBRES & TEXTILES in Eastern Europe, 20(94): 16-20.
  4. Swinker, M.E., and Hines, J.D., 1997. Consumers’ Selection of Textile Products Made from Recycled Fibres. Journal of Consumer Studies and Home Economics, 21: 307-313.
  5. Wulfhorst, B., 1984. The Technological and Economic Aspects of the Recycling of Wastes in Modern Cotton Mills. Textile Praxis International, 8: 741-743.
  6. Duru, N.P., and Babaarslan, O., 2003. Determining an Optimum Opening Roller Speed for Spinning Polyester/Waste Blend Rotor Yarns. Textile Research Journal, 73 (10): 907-911.
  7. Merati, A.A., and Okamura, M., 2004. Producing Medium Count Yarns from Recycled Fibers with Friction Spinning. Textile Research Journal, 74 (7): 640- 645.
  8. Halimi, M.T., Hassen, M.B., Azzouz, B., and Sakli, F., 2007. Effect of Cotton Waste and Spinning Parameters on Rotor Yarn Quality. Journal of the Textile Institute, 98 (5): 437-442.
  9. Halimi, M.T., Hassen, M.B., Azzouz, B., and Sakli, F., 2009. Influence of Spinning Parameters and Recovered Fibers from Cotton Waste on the Uniformity and Hairiness of Rotor Spun Yarn. Journal of Engineered Fibers and Fabrics, 4(3): 36-44.
  10. Hasani, H., Semnani, D., and Tabatabaei, S., 2010. Determining the Optimum Spinning Conditions to Produce the Rotor Yarns from Cotton Wastes. Industria Textile, 61(6): 59-64.
  11. Hasani, H., and Tabatabaei, S.A., 2011. Optimizing Spinning Variables to Reduce the Hairiness of Rotor Yarns Produced from Waste Fibers Collected from the Ginning Process. Fibres & Textiles in Eastern Europe, 19 (86): 21-25.
  12. Kurtoglu Necef, O., Seventekin, N. and Pamuk, M., 2013. A Study on Recycling the Fabric Scraps in Apparel Manufacturing Industry. Tekstil ve Konfeksiyon, 23(3): 286-289.
  13. Demiroz Gun, A., Akturk, H.N., Sevkan Macit, A. and Alan, G., 2014. Dimensional and Physical Properties of Socks Made from Rreclaimed Fibre. The Journal of the Textile Institute, 105(10): 1108-1117.
  14. Khan, R.K., Hossain, M.M., and Sarker, R.C., 2015. Statistical Analyses and Predicting the Properties of Cotton/Waste Blended Open-End Rotor Yarn Using Taguchi OA Design. International Journal of Textile Science, 4(2): 27-35.
  15. Khan, R.K., and Rahman, H., 2015. Study of Effect of Rotor Speed, Combing-Roll Speed and Type of Recycled Waste on Rotor Yarn Quality Using Response Surface Methodology, IOSR Journal of Polymer and Textile Engineering, 2 (1): 47-55.
  16. Frounchi, M., Mehrabzadeh, M., and Ghiaee, R., 1997. Studies on Recycling of Poly(ethylene terephthalate) Beverage Bottles. Iranian Polymer Journal, 6 (4): 269-272.
  17. Elamri, A., Lallam, A., Harzallah, O., and Bencheikh, L., 2007. Mechanical Characterization of Melt Spun Fibers from Recycled and Virgin PET blends. Journal of Material Science, 42:8271–8278.
  18. Abbasi, M., Mojtahedi, M.R.M., and Khosroshahi, A., 2007. Effect of Spinning Speed on the Structure and Physical Properties of Filament Yarns Produced from Used PET Bottles. Journal of Applied Polymer Science, 103: 3972–3975.
  19. Telli, A., and Özdil, N., 2013. Properties of the Yarns Produced from r-PET Fibers and Their Blends. Tekstil ve Konfeksiyon, 23(1): 3-10.
  20. Ruzzante, M., Fatarella, E., Coll, T., and Romei, M., 2014. Partially Oriented Recycled Polyester Yarns: A Benefit for the Environment. 14th AUTEX World Textile Conference. May, 26-28, Bursa, Turkey.
  21. Telli, A., and Özdil, N., 2015. Effect of Recycled PET Fibers on the Performance Properties of Knitted Fabrics. Journal of Engineered Fibers and Fabrics, 10(2): 47-60.
  22. He, S., Wei, M., Liu, M., and Xue, W., 2015. Characterization of virgin and recycled polyethylene terephthalate (PET) fibers. The Journal of the Textile Institute, 106 (8): 800-806.