Dergiler / Gazi Üniversitesi Mühendislik Mimarlık Fakültesi Dergisi / 2026 / Cilt: 18 Sayı: 1

KATI ATIK VE ARITMA ÇAMURLARININ DEĞERLENDİRİLMESİNDE ALTERNATİF TERMAL TEKNOLOJİLER VE UYGULAMALARI

Sayfa
—
Yayın Tarihi
2013-04-11
DOI
—
🏛️Bu makalenin bibliyografik verileri ve tam metin bağlantısı DergiPark üzerinden sağlanmıştır.
DergiPark Kaydı ↗
✨

Yapay Zeka Hızlı Bakış & Çıkarımlar

AI Insight
⚡ TL;DR(1 Cümlede Hızlı Çıkarım)

Bu makalede yeniteknolojiler ve uygulamaları özetlenmektedir.

📌 3 Maddede Bu Makale

🎯
Amaç & Hipotez:Katı atık ve arıtma çamurlarının tek başına veya diğer yakıtlarla birlikte yakılmasınaalternatif teknolojiler araştırmak için iki önemli sebep bulunmaktadır.
📊
Temel Bulgular & Veri:Bunlar, yanmaboyunca oluşan büyük oranlardaki baca gazı emisyonları ve küldür.
💡
Sonuç & Katkı:Bu makalede yeniteknolojiler ve uygulamaları özetlenmektedir.
🔬Tür:Makale
📍Kapsam:Genişletilmiş Akademik Örneklem
⚙️Değişkenler:Katı atık · arıtma çamuru · gerikazanım

Özet

Katı atık ve arıtma çamurlarının tek başına veya diğer yakıtlarla birlikte yakılmasınaalternatif teknolojiler araştırmak için iki önemli sebep bulunmaktadır. Bunlar, yanmaboyunca oluşan büyük oranlardaki baca gazı emisyonları ve küldür. Yanma sonrasıbaşlangıç kuru kütlenin yaklaşık %50’si kül olarak kalmakta ve bir çok toksik ağırmetalleri içermektedir. Böylece külün uzaklaştırılması karmaşık hale gelmektedir.Bu kül miktarını azaltmak için piroliz, yakma ve gazlaştırma işlemlerininkombinasyonu şeklinde bir çok yeni teknoloji geliştirilmiştir. Bu makalede yeniteknolojiler ve uygulamaları özetlenmektedir.

🔖

Bu Makaleye Atıf Yap

Toraman, Ö. Y., Topal, H. (2013). KATI ATIK VE ARITMA ÇAMURLARININ DEĞERLENDİRİLMESİNDE ALTERNATİF TERMAL TEKNOLOJİLER VE UYGULAMALARI. Gazi Üniversitesi Mühendislik Mimarlık Fakültesi Dergisi, Cilt: 18 Sayı: 1. https://ajindex.com/articles/1079183

📄 Tam Metin PDF Okuyucu

📄

PDF görüntüleyici hazırlanıyor...

Kaynakça (91)

  1. Liptak B.G., Bouis P.,A., Hazardous Waste and Solid Waste, Lewis
  2. Publishers, CRC Press LLC, 2000.
  3. Sebastian F., Environmental Engineers Handbook, Edited by Liptak B.G.,
  4. Chilton Book Company, 1974.
  5. Henmi M., Okazawa K., and Sota K., “Energy Saving in Sewage Sludge
  6. Incineration with Indirect Heat Drier”, National Waste Processing Conference,
  7. Denver, 1986.
  8. Otero M., Diez C., Calvo L.F., Garcia A.I., “Analysis of the Co-Combustion of
  9. Sewage Sludge and Coal by TG-MS”, Biomass and Bioenergy, Vol 22, 2002.
  10. Vesilind P.A, Ramsey T.B., “Effect of Drying Temperature on Fuel Value of
  11. Wastewater Sludge”. Wastewater Management and Reseaech, Vol 14, p.189-, 1992.
  12. Römer R., “Thermal Treatment of Sewage Sludge-Combustion, Drying Energy
  13. Recovery, Emissions”, In: Klarschlamm Entssorgung 1, Daten-Dioxine,
  14. Entwasserung, Verwetung, Entsorgungsvorschlage, Düsseldorf: VDI GmbH,
  15. p.250-271, 1991.
  16. Albertson O.E., Bruno J.M., “Sludge Incineration: Thermal Destruction of
  17. Residues”, Proceedings of the Symposium: Water Environment Federation,
  18. Alexandria, USA, 1992.
  19. Werther J., Ogada T., “Sewage Sludge Combustion”, Progress in Energy and
  20. Combustion Science, 25; p. 55-116., 1999.
  21. Lungwitz H., Werther J., “Alternative Processes for Thermal Treatment and Use
  22. of Sewage Sludge”, Thome-Kozmiensky K.J. Editor. Abfallwirtschaft am
  23. Wendepunkt. TK, Neuruppin, p. 717-742, 1997.
  24. Ogada T., Combustion and Emission Characteristics of Sewage Sludge in a
  25. Bubling Fluidized Bed Combustor, Ph.D. Dissertation, Technical University of
  26. Hamburg, Hamburg, 1995.
  27. Spliethoff H., ve ark., Ber. Dtsch. Wiss.Ges. Erdoel, Eredgas Kohle, Tagungsber,
  28. Lu G.Q., Low J.C.F., Liu C.Y., Lua A.C., “Surface Area Development of
  29. Sewage Sludge During Pyrolysis”, Fuel, Vol 74 No.3, p.344-348, 1995.
  30. Piskorz J., Scott D.S., Westerberg I.B., Ind.Eng.Chem. Process Des. Dev. Vol, 1986.
  31. Bridge T.R., Environ. Tech. Lett. Vol 3, 1982.
  32. Storm C., ve ark., DGMK Tagungsber, Proceedings ICCS’97, Volume 2, p.721-, 1997.
  33. Bridge T.R., “Sludge Derived Oil-Wastewater Treatment Implications”,
  34. Environ. Technol. Lett. Vol 3, 151-156, 1982.
  35. Lu G.Q., Low J.C.F., Liu C.Y., “Surface Area Development of Sewage Sludge
  36. During Pyrolysis”, Fuel, Vol 3, p.344-348, 1995.
  37. Piskorz J., Scott D.S., Westerberg I.B., “Flash Pyrolysis of Biomass”, Ind. Eng.
  38. Chem. Proc. Design Develop, Vol 25, p.265-270, 1986.
  39. Rumphorst M.P., Ringel H.D., “Pyrolysis of Sewage Sludge and Use of
  40. Pyrolysis Coke”, J. Anal and Applied Pyrolysis, 28:p.137-155. 1994.
  41. Lendormi T., Prevot C., Doppenbe F., Foussard J.N., “Supercritical Wet
  42. Oxidation of Municipal Sewage Sludge Comparison of Batch and Continuous
  43. Experiments”, Water Science and Technology, Vol 44, 5, p.161-169, 2001.
  44. Lendormi T., Prevot C., Doppenbe F., Sperandio M., “Wet Oxidation of
  45. Domestic Sludge and Process Integration”, Water Science and Technology,
  46. Vol 44, 10, p.163-169, 2001.
  47. Hall J.E., “Sewage Sludge Production Treatment and Disposal in the European
  48. Union”, J CIWEM, Vol 9, p.335-342, 1995.
  49. Boon A., Thomas V., “Resource of Rubbish”, The Chemical Engineer, 25-30,
  50. Van Voorneburg F., “Treatment and Disposal of Municipal Sludge in the
  51. Nederland”, J CIWEM, Vol. 7, p.116-121, 1993.
  52. Kaminsky W., Augustin T., Bellmann U., Krüger-Betz M., “Pyrolisis of
  53. Industrial and Municipal Sewage Sludges”, Recycling von Klarschlamm 1.
  54. Berlin: EF für Energie-und Umwelttechnik GmbH, p.309-316, 1987.
  55. Kaminsky W., Ying Y., “Chemicals from Biomass Pyrolisis in a Fluidised Bed”,
  56. Advances in Thermochemical Biomass Conversion, Brigdwater A.V., editor,
  57. Vol.2
  58. Caballero J.A., Front R., “Characterisation of Sewage Sludges by Primary and
  59. Secondary Pyrolysis”, J. Anal. And Applied Pyrolysis, 4041, 1997.
  60. Loll U., “Sewage Sludge”, ATV Handbuch, 4th edn., Berlin, 1996.
  61. Kyriakos M., “Flash Pyrolsis of Wood and Dried Sewage Sludge for Liquid Fuel
  62. Production”, Grass G., Gosse G., editors, Biomass for Energy and Industry, 5th
  63. EC Conference, Vol. 2, Conversion and Utilisation of Biomass, p.2611-2615,
  64. Campbell H.W., “Converting Sludge to Fuel-a Status Report”, Hogan et al.,
  65. editor, Biomass thermal Processing, Proceedings of the 1st Canada/European
  66. Community R. And D. Contructors Meeting, Ottawa, Canada, 78-85, 1990.
  67. Inguanzo M., Dominguez J.A., Menendez C.G., Blanco J.J., “On the Pyrolysis
  68. of Sewage Sludge: The Influence of Pyrolysiconditions on Solid, Liquid and Gas
  69. Fraction”, Journal of Analytical and Applied Prolysis, Vol 63, p.209-222,
  70. Hudson J.A., Lowe P., “Current Technologies for Sludge Treatment and
  71. Disposal”, J CIWEWM, 10:p.436-440, 1996.
  72. Shiota T.,“Economical Evaluation of a System for Making a Fuel from Sludge”,
  73. Recycling von Klarschlom. Berlin. EF für Energie, p.223-239. 1987.
  74. Bress D.F., Greenfield B.S., Haug R.T.,“Energy from Sludge Derived Fuels”
  75. Energy From Biomass and Wastes, Instiştute of Gas Technology. p.1173-, 1987.
  76. Lohse U., “Pelleting and Gasification of Sewage Sludge”, Umwelt Bd, 26 (5),
  77. Lungwitz H., “Thermal Treatment of Sewage Sludge – New Trends for the
  78. Treatment and Disposal of Industrial and Municipal Sludges”, Darmstadt
  79. Schriftreihe WAR, 1997.
  80. Company Information Booklet-Krupp Uhde PreCon Process, Germany
  81. Wolfgang K., Langer R., Kilian R., Wieling N.,“The Siemens-
  82. Pyrolysis/Combustion Plant Process and Material Concept”, Umwelt Bd,
  83. :p.361-363, 1991.
  84. Berwein H.J., “Siemens-Pyrolysis/Combustion Process for Wastes and Sewage
  85. Sludge”, Ensorgungspraxis, No 5, p.227-234, 1991.
  86. Company Information Booklet-Schwel-Brenn Process Siemens, Germany.
  87. Company Information Booklet-Recycled Clean Products von Roll GmbH,
  88. Germany.
  89. Company Information Booklet-Noell Conversion Process Noell, Germany.
  90. Company Information Booklet-Recycled Clean Products, Germany.
  91. Company Information Booklet-Thermoselect Process-Thermoselect, Germany.