Yapay Zeka Hızlı Bakış & Çıkarımlar
AI InsightTherefore in order to utilize electrospray injection in practical power conversion devices manufacturing of high nozzle density multiplexed emitter arrays are needed
📌 3 Maddede Bu Makale
Abstract
The use of liquid hydrocarbons as a chemical energy source is promising for the actualization of high energy density power sources in the near future. Electrospray injection method is a unique technique that provides equal droplet size distribution at very low flow rates. Therefore it is quite suited for the atomization of liquid hydrocarbon fuels in miniature energy conversion devices. This study reports the design and characterization of an electrospray system. First, the electrospray phenomenon is briefly discussed from an historical perspective. An experimental test rig is built and a proof-of-concept demonstration is provided. For the experiments methanol is used as the liquid fuel. Flow visualization is performed to identify the electrospray mode. Results suggest that a Taylor cone is cone formed when voltage is applied to the system. After a certain voltage threshold electrostatic forces overcome the surface tension forces and droplets begin to separate from the Taylor cone. For voltage values higher than 6 kV certain instabilities are observed. Starting voltage for the current configuration is measured to be 2.2 kV. This value is in close agreement the theoretical calculations which suggest that the starting voltage would be 2.5 kV. This 12% discrepancy can be attributed to experimental uncertainty. Flow rate from a single injector is found to be on the order of 2 ml/h. Therefore in order to utilize electrospray injection in practical power conversion devices manufacturing of high nozzle density multiplexed emitter arrays are needed