Journals / Eskişehir Osmangazi Üniversitesi mühendislik ve mimarlık fakültesi dergisi (online) / 2021 / Cilt: 29 - Sayı: 3

THE INFLUENCE OF STIRRING SPEED AND TIME ON THE DETERMINATION OF CALCITE SURFACE MODIFICATION USING THE ACTIVE RATIO TEST

AKTİVE ORANI TESTİ KULLANILARAK KALSİT YÜZEY MODİFİKASYONUNUN BELİRLENMESİNDE KARIŞTIRMA HIZI VE SÜRESİNİN ETKİSİ

Pages
277–285
DOI
—

Abstract

In this study, active ratio tests were carried out with a kinetic approach on calcite samples, which were surface-modified with stearic acid in the laboratory and on an industrial scale. Also, product properties were supported by particle size and FTIR analysis. According to the results, the highest active ratios were achieved at 0.1 kWh-1% SA condition. When the particle size distributions were evaluated, the products with the finest particle size distribution were measured in the test obtained under the condition of 0.1 kWh (1% SA) and in the sample taken from the pin mill process. It was observed that stearic acid was adsorbed onto the ground + surface-modified particle surfaces by FTIR measurements. On the other hand, within the scope of this study, the application of the active ratio test procedure depending on the time and the stirrer speed increased the test reliability and gave an idea about the changes in the hydrophobicity of the particles depending on the time.

Özet

Bu çalışmada, laboratuvar ortamında ve endüstriyel ölçekte stearik asit (SA) ile yüzeyi modifiye edilmiş kalsit numunelerine kinetik bir yaklaşımla aktive oranı testleri gerçekleştirilmiştir. Ayrıca ürün özellikleri tane boyutu ve FTIR analizleri ile desteklenmiştir. Elde edilen sonuçlara göre 0,1 kWsa-%1 SA koşulunda en yüksek aktive oranlarına ulaşılmıştır. Tane boyutu sonuçları incelendiğinde en ince tane boyuna sahip ürünler 0,1 kWsa (%1 SA) koşulunda elde edilen testte ve pimli değirmen prosesinden alınan numunede ölçülmüştür. FTIR ölçümleri ile stearik asidin öğütülmüş+yüzeyi modifiye edilmiş tane yüzeylerine adsorbe olduğu gözlemlenmiştir.Öte yandan, bu çalıma kapsamında aktive oranı test prosedürünün zamana ve karıştırma hızına bağlı olarak uygulanması test güvenilirliğini arttırırken, tanelerin zamana bağlı olarak hidrofobikliklerindeki değişimleri hakkında da fikir vermiştir.