| Investigation surface roughness and characterization of cutting front side geometry in the cutting of AISI 1030 material with abrasive water jet | ADNAN AKKURT | 1–11 |
| The fuzzy logic based power injection into rotor circuit for instantaneous high torque and speed control in induction machines | SELAMİ KESLER,A. Sefa AKPINAR,ALİ SAYGIN | 13–23 |
| An intelligent decision support system based on image processing for evaluating of the endoscopic images | Abdulkadir SENGUR,İBRAHİM TÜRKOĞLU,M. Cevdet İNCE | 33–42 |
| The effect of heat variation on different brake disk braking forces | MESUT DÜZGÜN | 43–48 |
| Experimental and numerical investigation of flexible buried pipe deformation behavior under various backfill conditions | Niyazi Uğur TERZİ,Sönmez YILDIRIM | 49–58 |
| Investigation of tracking of voltage signal containing harmonics and spike by using recursive least squares method | H. Hüseyin SAYAN,İlhan KOŞALAY,Cemal YILMAZ | 59–68 |
| Arsenic contamination in drinking water: An assessment for Turkey | MELTEM BİLİCİ BAŞKAN,AYŞEGÜL PALA | 69–79 |
| Investigation of elastic pendulum oscillations by simulation technique | Ersin DEMİR, Zekeriya GİRGİN | 81–86 |
| A compensator application using synchronous motor with a PI controller based on PIC | RAMAZAN BAYINDIR,ALPER GÖRGÜN | 87–99 |
| Investigation of international engineering licensure systems | SELİM BARADAN,GÜLBEN ÇALIŞ | 107–117 |
| Investigation of a laterally loaded model pile behaviour in sand by means of experimental and numerical methods | Niyazi Uğur TERZİ,HAVVANUR KILIÇ,Sami GÜLTEKİN | 119–127 |
| The utilization technologies of methane produced from undergraund coal seams | Gökhan AYDIN,İZZET KARAKURT | 129–136 |