Journals / Journal of Anatolian Environmental and Animal Sciences / 2023 / Cilt: 8 Sayı: 3

Synthesis of Environmentally Friendly Carbon Nano Fibers with Methanol by Using Chemical Vapor Deposition Technique

Çevre Dostu Karbon Nano Fiberlerin Kimyasal Buhar Biriktirme Tekniği Kullanılarak Metanol ile Sentezlenmesi

Pages
394–397
Publication Date
2023-09-30
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

SEM analysis revealed morphologically dense CNF formation under isothermal conditions for 20 min at 1300K synthesis temperature.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:This study aims to investigate the suitability of methanol as a carbon source for the synthesis of carbon nanofibres (CNFs), currently used in wastewater, water, and air purification systems, by chemical vapor deposition (CVD) in the presence of NiO catalyst.
📊
Key Findings & Data:Catalyst particles were loaded onto silicon wafers with <100> orientation by dip coating to grow CNFs.
💡
Conclusion & Impact:SEM analysis revealed morphologically dense CNF formation under isothermal conditions for 20 min at 1300K synthesis temperature.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Karbon Nano Fiber · Kimyasal Buhar Biriktirme · Metanol

Abstract

This study aims to investigate the suitability of methanol as a carbon source for the synthesis of carbon nanofibres (CNFs), currently used in wastewater, water, and air purification systems, by chemical vapor deposition (CVD) in the presence of NiO catalyst. Experimental studies were carried out in a tube furnace under isothermal conditions. Catalyst particles were loaded onto silicon wafers with <100> orientation by dip coating to grow CNFs. The reduction behavior of nickel oxide powder at 1000 K under non-isothermal and isothermal conditions was investigated before CNF synthesis studies. The percentage reduction of nickel oxide powder under non-isothermal conditions was 82.03%. The percentage reduction under isothermal conditions for 30 min was 78.03%. The experimental result obtained is very close to the theoretical value (78.57%). During CNF synthesis experiments, it was observed that CNF formation was not achieved at temperatures of 1000 - 1100 K due to the poor thermal decomposition of methanol. Pyrolysis of methanol increased with increasing synthesis temperature (1200 K), which promoted the synthesis of CNFs. SEM analysis revealed morphologically dense CNF formation under isothermal conditions for 20 min at 1300K synthesis temperature.

Özet

Bu çalışma, NiO katalizör varlığında kimyasal buhar biriktirme (KBB) yöntemiyle günümüzde atık su arıtma, su ve hava arıtma sistemlerinde kullanılmaya başlanan karbon nano fiberin (KNF) sentezlenmesi üzerinde karbon kaynağı olarak methanolün uygunluğunun araştırılması amaçlamaktadır. Deneysel çalışmalar tüp fırında izotermal şartlar altında yapılmıştır. Karbon nanofiberlerin büyütülmesi için <100> yönelimli bir silikon levhalar daldırma kaplama yöntemi ile katalizör parçacıkları ile yüklenmiştir. Nikel oksit tozunun 1000 K'de izotermal olmayan ve izotermal koşullar altında indirgenme davranışı CNF sentezi çalışmalarından önce incelenmiştir. Nikel oksit tozunun izotermal olmayan koşullar altında indirgenme yüzdesi %82,03'tür. İzotermal koşullar altında 30 dakika boyunca indirgenme yüzdesi %78,03'tür. Elde edilen deneysel sonuç teorik değere (%78,57) çok yakındır. CNF sentez deneylerinde 1000-1100 K sıcaklıklarında metanolün zayıf termal parçalanma derecesi nedeniyle KNF oluşumu sağlanmadığı gözlemlenmiştir. Sentez sıcaklığının artmasıyla (1200 K) metanolün pirolizi artmış bu durumda KNF’ lerin sentezini teşvik etmiştir. Sentez sıcaklığı 1300 K olduğunda ise morofolojide 20 dakika izo termal şartlar altında yoğun KNF mikroyapısı oluştuğunu yapılan SEM analiz sonuçları ortaya koymuştur.

🔖

Cite This Article

ALTAY, M. C. (2023). Synthesis of Environmentally Friendly Carbon Nano Fibers with Methanol by Using Chemical Vapor Deposition Technique. Journal of Anatolian Environmental and Animal Sciences, Cilt: 8 Sayı: 3, 394–397. https://ajindex.com/articles/964391

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (1)

  1. Altay, M.C. & Eroglu, S. (2012). Synthesis of multiwalled C nanotubes by Fe-Ni (70 wt.%) catalyzed chemical vapor deposition from pre-heated CH4. Materials Letters, 67(1). DOI: 10.1016/j.matlet.2011.09.011 Altay, M.C. & Eroglu, S. (2013a). Growth of multiwalled C nanotubes from pre-heated CH4 using Fe3O4 as a catalyst precursor. Diamond and Related Materials, 31. DOI: 10.1016/j.diamond.2012.10.009 Altay, M.C. & Eroglu, S. (2013b). Thermodynamic analysis and chemical vapor deposition of multiwalled carbon nanotubes from pre-heated CH4 using Fe2O3 particles as catalyst precursor. Journal of Crystal Growth, 364. DOI: 10.1016/j.jcrysgro.2012.11.062 Altay, M.C. & Eroglu, S. (2016). Non-isothermal reduction behavior of NiO in undiluted Ar and CH4 atmospheres. International Journal of Mineral Processing, 149. DOI: 10.1016/j.minpro.2016.02.005 Altay, M.C. & Eroglu, S. (2019). Synthesis of Mo2C from MoO3 and C5OH. JOM, 71(8). DOI: 10.1007/s11837-019-03571-z Bai, Z., Liu, Q., Lei, J. & Jin, H. (2018). Investigation on the mid-temperature solar thermochemical power generation system with methanol decomposition. Applied Energy, 217, 56-65. DOI: 10.1016/j.apenergy.2018.02.101 Bhatt, P. & Goe, A. (2017). Carbon Fibres: Production, Properties and Potential Use. Material Science Research India, 14(1), 52-57. DOI: 10.13005/msri/140109 Chen, D.S., Wang, Y. & Zou, Y.X. (2020). Activated Carbon Fiber Fabrics in Filtration and Clean Water Resources. Materials Science Forum, 980, 387-393. DOI: 10.4028/www.scientific.net/MSF.980.387 Falzon, B. G. (2022). Computational modelling of the crushing of carbon fibre-reinforced polymer composites. Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 380(2232). DOI: 10.1098/rsta.2021.0336 Grace, N. & Singh, S. (2005). Durability Evaluation of Carbon Fiber-Reinforced Polymer Strengthened Concrete Beams: Experimental Study and Design. ACI Structural Journal, 102. Hegde, S., Satish Shenoy, B. & Chethan, K.N. (2019). Review on carbon fiber reinforced polymer (CFRP) and their mechanical performance. Materials Today: Proceedings, 19, 658-662. DOI: 10.1016/j.matpr.2019.07.749 Lee, C.S. & Hyun, Y. (2016). Preparation and Characterization of Carbon Nanofibers and its Composites by Chemical Vapor Deposition. In S. Neralla (Ed.), Chemical Vapor Deposition. IntechOpen. DOI: 10.5772/63755 Manawi, Y., Ihsanullah, Samara, A., Al-Ansari, T. & Atieh, M. (2018). A Review of Carbon Nanomaterials’ Synthesis