Journals / Türk Deprem Araştırma Dergisi / 2020 / Cilt: 2 Sayı: 1

Stress Tensor and Coulomb Analysis for Erzurum and Its Surroundings

Erzurum ve Çevresi İçin Gerilme Tensör ve Coulomb Analizleri

Pages
101–114
Publication Date
2020-06-29
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

Especially, increase in stress is observed in the North Anatolian Fault Zone, Horasan-Narman fault and Askale fault.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:ln this study, the dominant stress regime was investigated by stress tensor analysis, and stress change was modelled by Coulomb stress analysis for Erzurum and its surroundings.
📊
Key Findings & Data:The data set consists of 58 earthquakes (4.0≤Mw≤6.9) focal mechanism solutions, occurred between 1966 and 2019 for both analyses.
💡
Conclusion & Impact:Especially, increase in stress is observed in the North Anatolian Fault Zone, Horasan-Narman fault and Askale fault.
🔬Design:Modeling & Simulation
📍Scope:2019 Verileri
⚙️Variables:Coulomb Gerilme Analizi · Gerilme Tensör Analizi · Doğu Anadolu Fay Zonu

Abstract

ln this study, the dominant stress regime was investigated by stress tensor analysis, and stress change was modelled by Coulomb stress analysis for Erzurum and its surroundings. The data set consists of 58 earthquakes (4.0≤Mw≤6.9) focal mechanism solutions, occurred between 1966 and 2019 for both analyses. According to the stress tensor analysis results, the largest (σ1) and smallest (σ3) principal stress axes are horizontal and the middle principal stress (σ2) axis is vertical, which are compatible with strike-slip faults due to the tectonic regime in the region. Based on focal mechanism solutions, Coulomb stress variation was obtained by using azimuth and dip values of the principal stress axes. Especially, increase in stress is observed in the North Anatolian Fault Zone, Horasan-Narman fault and Askale fault.

Özet

Bu çalışmada Erzurum ve çevresi için gerilme tensör analizi ile hâkim gerilme rejimi araştırılmış, Coulomb gerilme analizi ile gerilme değişimi modellenmiştir. Her iki analiz için veri seti 1966-2019 yılları arasında meydana gelen 58 adet depreme (4.0≤Mw≤6.9) ait odak mekanizması çözümlerinden oluşmaktadır. Gerilme tensör analiz sonuçlarına göre en büyük (σ1) ve en küçük (σ3) asal gerilme eksenleri yatayda, orta asal gerilme (σ2) ekseni ise düşeyde çıkmış ve bu sonucun bölgedeki tektonik rejime bağlı doğrultu atımlı faylar ile uyumlu olduğu görülmüştür. Odak mekanizma çözümlerinden hareketle azimut ve dalım değerleri kullanılarak Coulomb gerilme değişimi elde edilmiştir. Özellikle Kuzey Anadolu Fay Zonu, Horasan-Narman Fayı ve Aşkale Fayında gerilmelerde artış olduğu tespit edilmiştir.

🔖

Cite This Article

BAYRAK, E., ÖZER, Ç., PERK, Ş. (2020). Stress Tensor and Coulomb Analysis for Erzurum and Its Surroundings. Türk Deprem Araştırma Dergisi, Cilt: 2 Sayı: 1, 101–114. https://ajindex.com/articles/914233

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (15)

  1. AFAD, 2020a. Erişim adresi: https://deprem.afad.gov.tr/depremkatalogu AFAD, 2020b. Erişim adresi: https://deprem.afad.gov.tr/faycozumleri
  2. Bayrak Y., Yadav R.B.S., Kalafat D., Tsapanos T.M., Cinar H., Singh A.P., Bayrak E., Yilmaz S., Ocal F., Koravos G., 2013. Seismogenesis and earthquake triggering during the Van (Turkey) 2011 seismic sequence. Tectonophysics 601, 163-176.
  3. Bayrak E., Yilmaz S., Softa M., Turker T., Bayrak Y., 2015. Earthquake hazard analysis for East Anatolian Fault Zone, Turkey, Natural Hazards 76, 1063–1077. Bayrak E., 2019. Earthquake Hazard Analysis For Erzurum, Eastern Turkey, 4. International Conference on Civil, Environmental, Geology and Mining Engineering, 20-22 April 2019,
  4. Trabzon, Turkey, 731-740.
  5. Bayrak E., Nas M., Bayrak Y., 2019. New macroseismic intensity predictive models for Turkey, Acta Geophysica 67, 1483–1513.
  6. Bayrak E., Ozer C., Perk S., 2020. The Ground-Motion Attenuation Comparison: A case study for the 2017/05/11 Askale earthquake (Mw4.7), Brilliant Engineering 3, 22-26.
  7. Emre Ö., Duman T.Y., Özalp S., Elmacı H., Olgun S., Şaroglu F., 2013. 1/1.250.000 scaled Turkey active fault map, General Directorate of Mineral Research and Exploration Special Publication, Erişim adresi: http://www.mta.gov.tr/
  8. Emre O., Duman T. Y., Ozalp S., Saroglu F., Olgun S., Elmaci H., Can T., 2018.
  9. Active fault database of Turkey, Bulletin of Earthquake Engineering 16, 3229-3275.
  10. Eyidogan H., Nalbant S.S., Barka A., King G.C.P., 1999. Static stress changes induced by 1934 Pasinler (M=6.8) and 1983 Horasan-Narman (M=6.8) earthquakes, Northeastern Turkey. Terra Nova 11, 38–44.
  11. Gephart J.W., Forsyth D.W., 1984. An improved method for determining the regional stress tensor using earthquake focal mechanism data: application to the San Fernando earthquake sequence, Journal of Geophysical Research: Solid Earth, 89(B11), 9305-9320.
  12. Iturrieta P.C., Hurtado D.E., Cembrano J., Stanton-Yonge A., 2017. States of stress and slip partitioning in a continental scale strike-slip duplex: Tectonic and magmatic implications by means of finite element modeling, Earth and Planetary Science Letters 473,71-82.
  13. King G.C.P, Stein R.S., Lin J., 1994. Static stress changes and the triggering of earthquakes, Bulletin of the Seismological Society of America 84(3), 935–953.
  14. Kocyigit A., Canoglu M.C., 2017. Neotectonics and Seismicity of Erzurum Pull-apart Basin, East Turkey, Russian Geology and Geophysics 58, 99-122.
  15. Lin J., Stein R.S., 2004. Stress triggering in thrust