Journals / Environmental Research and Technology / 2018 / Cilt: 1 Sayı: 4

Adsorption of Remazol Brilliant Blue R by raw and carbonized macroalgal wastes

Pages
40–46
Publication Date
2018-12-01
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

The best fit of equilibrium data for all adsorbents was described by the Langmuir model.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In this study, adsorption of Remazol Brilliant Blue R (RBBR) dye was carried out using Ulva lactuca, Codium fragile and their carbonization products; adsorption kinetics and isotherms were determined.
📊
Key Findings & Data:Carbonized adsorbents were produced in a tubular furnace at the heating rate of 20˚C min-1 and temperature of 500 ˚C with a nitrogen flow rate of 300 ml min-1.
💡
Conclusion & Impact:The best fit of equilibrium data for all adsorbents was described by the Langmuir model.
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Adsorption · carbonization · macroalgae

Abstract

In this study, adsorption of Remazol Brilliant Blue R (RBBR) dye was carried out using Ulva lactuca, Codium fragile and their carbonization products; adsorption kinetics and isotherms were determined. Carbonized adsorbents were produced in a tubular furnace at the heating rate of 20˚C min-1 and temperature of 500 ˚C with a nitrogen flow rate of 300 ml min-1. Adsorption was carried out in a shaking water bath at the temperature of 25 ˚C and shaking speed of 200 rpm for 2 h. Carbonized adsorbents have been found to have greater adsorption capacity than raw biomass. It was seen that the adsorption lasted for 90 and 60 minutes for raw and carbonized adsorbents, respectively and then desorption begun. Maximum adsorption was achieved with the carbonized Ulva lactuca macroalgae (2.11 mg g-1). It has been found that the most suitable kinetic model for all absorbents was the pseudo-second-order kinetic model. The best fit of equilibrium data for all adsorbents was described by the Langmuir model.

🔖

Cite This Article

KOCER, A. T., INAN, B., OZCİMEN, D. (2018). Adsorption of Remazol Brilliant Blue R by raw and carbonized macroalgal wastes. Environmental Research and Technology, Cilt: 1 Sayı: 4, 40–46. https://ajindex.com/articles/904921

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (8)

  1. M. Farnane, H. Tounsadi, A. Machrouhi, A. Elhalil, F.Z. Mahjoubi, M. Sadiq, M. Abdennouri, S. Qourzal and N. Barka, “Dye removal from aqueous solution by raw maize corncob and H3PO4 activated maize corncob”. Journal of Water Reuse and Desalination, vol. 8, pp. 1-11, 2017. D. Özçimen and T. Salan, “Removal of reactive dye Remazol Brilliant Blue R from aqueous solutions by using anaerobically digested sewage sludge based adsorbents”, Chemical Industry and Chemical Engineering Quarterly, vol. 22(2), pp. 167-179, 2016.
  2. S. Kanchi, K. Bisetty, G. Kumar and M.I. Sabela, “Robust adsorption of Direct Navy Blue-106 from textile industrial effluents by bio-hydrogen fermented waste derived activated carbon: equilibrium and kinetic studies” Arabian Journal of Chemistry, vol. 10, pp. 3084-3096, 2017.
  3. M.T. Yagub, T.K. Sen, S. Afroze and H.M. Ang, “Dye and its removal from aqueous solution by adsorption: a review” Advances in colloid and interface science, vol. 209, pp. 172-184, 2014. G. Crini, “Non-conventional low-cost adsorbents for dye removal: a review” Bioresource technology, vol. 97(9), pp. 1061-1085, 2006
  4. A. Mittal, D. Kaur, A. Malviya, J. Mittal and V.K. Gupta, “Adsorption studies on the removal of coloring agent phenol red from wastewater using waste materials as adsorbents” Journal of Colloid and Interface Science, vol. 337(2), pp. 345-354, 2009. D. Özçimen, “Evaluation of various vegetable residues by carbonization”, Phd thesis, Istanbul Technical University, Istanbul, Turkey, 2007.
  5. K. Vijayaraghavan, S.W. Won, and Y.S. Yun, “Treatment of complex Remazol dye effluent using sawdust-and coal-based activated carbons” Journal of Hazardous Materials, vol. 167(1-3), pp. 790-796, 2009.
  6. V.K. Gupta, S.K. Srivastava, D. Mohan, and S. Sharma, “Design parameters for fixed bed reactors of activated carbon developed from fertilizer waste for the removal of some heavy metal ions” Waste management, vol. 17(8), pp. 517-522, 1998. D. Özçimen and A. Ersoy-Meriçboyu, “Adsorption of copper (II) ions onto hazelnut shell and apricot stone activated carbons” Adsorption Science & Technology, vol. 28(4), pp. 327-340, 2010.
  7. A.T. Koçer, B. Mutlu and D. Özçimen, “Algal biochar production from macroalgal wastes”, EURASIA Waste Management 2016,
  8. Istanbul, Turkey, 2016. R. García, C. Pizarro, A.G. Lavín and J.L. Bueno, “Biomass proximate analysis using thermogravimetry”, Bioresource Technology, vol. 139, pp. 1-4, 2013. S.K. Lagergren, “About the theory of so-called adsorption of soluble subst