Journals / Sigma Journal of Engineering and Natural Sciences / 2020 / Cilt: 38 Sayı: 1

Removal of methylene blue on zinc oxide nanoparticles: nonlinear and linear adsorption isotherms and kinetics study

Pages
289–303
Publication Date
2020-03-27
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

In general, the results indicated that the nonlinear fitting method of the experimental data with the models provided better results.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Environmental pollution caused by colored effluents is threatening to the world.
📊
Key Findings & Data:The effects of various operating parameters such as pH (3 - 11), ZnO-NPs dosage (0.1 – 0.4 g/L), contact time (30 - 120 min), initial MB concentration (20 – 80 mg/L) on the removal of MB were studied.
💡
Conclusion & Impact:In general, the results indicated that the nonlinear fitting method of the experimental data with the models provided better results.
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Methylene blue · nanoparticles · kinetics

Abstract

Environmental pollution caused by colored effluents is threatening to the world. The aim of this study is to evaluate the applicability of Zinc oxide nanoparticles (ZnO-NPs) for the removal of methylene blue (MB) from aqueous solution and also to study the applicability of the nonlinear and linear adsorption isotherm and kinetic models on the process. The effects of various operating parameters such as pH (3 - 11), ZnO-NPs dosage (0.1 – 0.4 g/L), contact time (30 - 120 min), initial MB concentration (20 – 80 mg/L) on the removal of MB were studied. The adsorption kinetic and isotherm models were examined using the linear and nonlinear regression analyses methods. The results revealed that under optimal conditions of pH 7, ZnO-NPs dosage of 0.2 g/L and contact time of 60 min at concentration of 40 mg/L, the maximum adsorption capacity (qm) of MB adsorption on ZnO NPs was 9.6. mg/g and maximum removal was 96.25 %. The MB adsorption data was found to follow the Langmuir isotherm model than the Freundlich model using the linear regression analysis method. But the values of the error functions (RMSE, SD, RSS, 𝑅𝑎𝑑𝑗2, and 𝑋𝑟𝑒𝑑2) estimated revealed that the Freundlich isotherm was more suitable for describing the adsorption process. The process of MB adsorption on ZnO-NPs was found to be governed by the pseudo-second-order model using both the linear and nonlinear adsorption models. The rate-determining step is chemisorption. In general, the results indicated that the nonlinear fitting method of the experimental data with the models provided better results. The adsorption of MB on ZnO-NPs was favorable since the intensity of adsorption (n = 9.62) lies within the range of 1-10. The monolayer adsorption capacity (qm) for ZnO-NPs with MB was 12.78 mg/g. It could be concluded from the study that ZnO-NPs can be useful for the removal of MB from its aqueous solution.

🔖

Cite This Article

AHMADI, S., IGWEGBE, C. A. (2020). Removal of methylene blue on zinc oxide nanoparticles: nonlinear and linear adsorption isotherms and kinetics study. Sigma Journal of Engineering and Natural Sciences, Cilt: 38 Sayı: 1, 289–303. https://ajindex.com/articles/897570

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (12)

  1. Kumar P.S., Fernando P.S.A., Ahmed R.T., Srinath R., Priyadharshini M., Vignesh A.M., Thanjiappan A., (2014) Effect of temperature on the adsorption of methylene blue dye onto sulfuric acid–treated orange peel, Chemical Engineering Communication 11, 1526- 1547
  2. Royer B., Cardoso N.F., Lima E.C., Macedo T.R., Airoldi C., (2010) A useful organ functionalized layered silicate for textile dye removal, Journal of Hazardous Materials 181, 366-374
  3. Srivastava S.N., (2008) Effects of process variables on kinetics of methylene blue sorption onto untreated guava (Psidium guajava) leaf powder: Statistical analysis, Chemical Engineering Journal 140, 609-621
  4. Rafatullah M., Sulaiman O., Hashim R., Ahmad A., (2010) Adsorption of methylene blue on low-cost adsorbents: A review, Journal of Hazardous Materials 177, 70-78
  5. Mulugeta M., Belisti L., (2014) Removal of methylene blue (MB) dye from aqueous solution by bioadsorption onto untreated Parthenium hystrophorous weed, Modern Chemistry Applications 2, 1-5
  6. Qingdong Q., Sun T., Yin W., Xu Y., (2017) Rapid and efficient removal of methylene blue by freshly prepared manganese dioxide, Cogent Engineering 1, 1-10
  7. Ahmadi S., Kord Mostafapour F., (2017) Adsorptive removal of aniline from aqueous solutions by Pistacia atlantica (Baneh) shells: isotherm and kinetic studies, Journal of Science, Technology and Environment Informatics 5, 327–335
  8. Igwegbe C.A., Onyechi P.C., Onukwuli O.D., Nwokedi I.C., (2016) Adsorptive treatment of textile wastewater using activated carbon produced from Mucuna pruriens seed shells, World Journal of Engineering and Technology 4, 21-37
  9. Kapdan I.K., Kargi F., (2002) Simultaneous biodegradation, and adsorption of textile dye stuff in an activated sludge unit, Process Biochemistry 37, 973-98
  10. Ahmadi Sh., Kord Mostafapoor F., (2017) Adsorptive removal of bisphenol A from aqueous solutions by Pistacia atlantica: isotherm and kinetic studies, Pharmaceutical and Chemical Journal 4, 1–8
  11. Igwegbe C.A., Mohmmadi L., Ahmadi S., Rahdar A., Khadkhodaiy D., Dehghani R., Rahdar S., (2019) Modeling of adsorption of Methylene blue dye on Ho-CaWO4 nanoparticles using Response surface methodology (RSM) and Artificial neural network (ANN) techniques, MethodsX 6, 1779-1797
  12. Igwegbe C.A., Banach A.M., Ahmadi S., (2018) Adsorption of Reactive Blue 19 from aqueous environment on magnesium oxide nanoparticles: kinetic, isotherm and thermodynamic studies, Pharmaceutical and