Moreover, it is reported that Hooke’s law converges the experimental results for small strain values but diverges significantly from the experimental results at higher strain values.
📌 3 Key Takeaways
🎯
Objective & Hypothesis:Aerospace-grade carbon fiber reinforced polymer composite plates with four different fiber orientations 0º, 30º, 45ºand 60º is produced with the autoclave curing method and subjected to tensile testing.
📊
Key Findings & Data:The stress-strain curves of the composite specimens are compared with Hooke’s law.
💡
Conclusion & Impact:Moreover, it is reported that Hooke’s law converges the experimental results for small strain values but diverges significantly from the experimental results at higher strain values.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Hooke’s law · composite lamina · tensile test
Abstract
Aerospace-grade carbon fiber reinforced polymer composite plates with four different fiber orientations 0º, 30º, 45ºand 60º is produced with the autoclave curing method and subjected to tensile testing. The stress-strain curves of the composite specimens are compared with Hooke’s law. It is observed that Hooke’s law coincides precisely with the experimental results for samples containing fibers parallel to the loading direction. However, it does not coincide with samples where the fibers make a certain angle with the applied load direction.. Moreover, it is reported that Hooke’s law converges the experimental results for small strain values but diverges significantly from the experimental results at higher strain values.
YİLMAZ, C., ALİ, H. Q., YILDIZ, M. (2022). APPLICATION OF HOOKE’S LAW TO ANGLE PLY LAMINA. Eskişehir Technical University Journal of Science and Technology A - Applied Sciences and Engineering, Cilt: 23 - Sayı: 4, 244–255. https://ajindex.com/articles/859275
Yilmaz C, Yildiz M. A study on correlating reduction in Poisson’s ratio with transverse crack and delamination through acoustic emission signals. Polym Test 2017;63:47–53.
Yilmaz C, Akalin C, Gunal I, Celik H, Buyuk M, Suleman A, et al. A hybrid damage assessment for E-and S-glass reinforced laminated composite structures under in-plane shear loading. Compos Struct 2018;186:347–54.
Yilmaz C, Akalin C, Kocaman ES, Suleman A, Yildiz M. Monitoring Poisson’s ratio of glass fiber reinforced composites as damage index using biaxial Fiber Bragg Grating sensors. Polym Test 2016;53:98–107.
Ali HQ, Emami Tabrizi I, Khan RMA, Tufani A, Yildiz M. Microscopic analysis of failure in woven carbon fabric laminates coupled with digital image correlation and acoustic emission. Compos Struct 2019;230:111515.
Munoz V, Valès B, Perrin M, Pastor M-L, Welemane H, Cantarel A, et al. Damage detection in CFRP by coupling acoustic emission and infrared thermography. Compos Part B Eng 2016;85:68–75
Emami Tabrizi I, Alkhateab B, Seyyed Monfared Zanjani J, Yildiz M. Using digital image correlation for in situ strain and damage monitoring in hybrid fiber laminates under in-plane shear loading. Polym Compos 2021;n/a.
Saeedifar M, Saleh MN, El-Dessouky HM, Teixeira De Freitas S, Zarouchas D. Damage assessment of NCF, 2D and 3D woven composites under compression after multiple-impact using acoustic emission. Compos Part A Appl Sci Manuf 2020;132:105833.
Strungar EM, Yankin AS, Zubova EM, Babushkin A V, Dushko AN. Experimental study of shear properties of 3D woven composite using digital image correlation and acoustic emission. Acta Mech Sin 2019:1–12
Khan RMA, Tabrizi IE, Ali HQ, Demir E, Yildiz M. Investigation on interlaminar delamination tendency of multidirectional carbon fiber composites. Polym Test 2020;90.
Khan RMA, Saeidiharzand S, Emami Tabrizi I, Ali HQ, Yildiz M. A novel hybrid damage monitoring approach to understand the correlation between size effect and failure behavior of twill CFRP laminates. Compos Struct 2021; 270: 114064. ht