Journals / Teknik Dergi / 2018 / Cilt: 29 - Sayı: 4

Experimental Study Concerning Iron Wire Fiber Reinforced Asphalt Concret

Pages
8515–8535
Publication Date
2022-10-18
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

Increasing fiber ratio especially, at 7-9 percentcaused compressing, durability and stability problems in the mixture.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:The usability of low-cost iron wire fiber for reinforcement of hot asphalt mixtures wasinvestigated with experiments in this study.
📊
Key Findings & Data:Five mixtures having different fiber content of1%, 3%, 5%, 7%, 9% and control mixtures were prepared.
💡
Conclusion & Impact:Increasing fiber ratio especially, at 7-9 percentcaused compressing, durability and stability problems in the mixture.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Abstract

The usability of low-cost iron wire fiber for reinforcement of hot asphalt mixtures wasinvestigated with experiments in this study. Five mixtures having different fiber content of1%, 3%, 5%, 7%, 9% and control mixtures were prepared. Characteristic properties ofbitumen, aggregate and iron wire used in the mixtures were determined by thermogravimetricanalysis (TGA), conventional bitumen tests, conventional aggregate tests, and metal tensiletests. After optimum bitumen rate was determined Marshall Stability Test, Cantabro Testswere performed in order to measure the performance of the mixtures. Additionally, moisturesusceptibility of samples was determined with indirect tensile strength test. As a result ofindirect tensile strength tests, indirect tensile strength (St) and indirect tensile strength ratio(ITSR) values were calculated. The results of the investigations indicate that the addition oflow-cost iron fiber in the amount of 1%-3% improved performance of asphalt mixtures.When the used fiber rate was increased over 3%, clustering created by fibers was observedthrough stereo-microscope observations. Consequently, air voids were increased andbitumen-aggregate interaction decreased. Increasing fiber ratio especially, at 7-9 percentcaused compressing, durability and stability problems in the mixture.

🔖

Cite This Article

KÖFTECİ, S. (2022). Experimental Study Concerning Iron Wire Fiber Reinforced Asphalt Concret. Teknik Dergi, Cilt: 29 - Sayı: 4, 8515–8535. https://ajindex.com/articles/596572

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (10)

  1. Tapkın, S., “The effect of polypropylene fibers on asphalt performance”, Building and Environment 43 (2008) 1065–1071 Liang R.Y., “Refine AASHTO T283 Resistance of compacted bituminous mixture to moisture induced damage for Superpave “, U.S. Department of Transportation Federal Highway Administration Report, Report No: FHWA/OH-2008/1, 2008
  2. Contreras, J.N., Gaecia, A., “Self-healing of asphalt mixture by microwave and induction heating”, Materials and Design 106 (2016), 404–414
  3. Pereira, S.M.S., Oliveira, J.R.M., Freitas, E.F., Machado, P., “Mechanical performance of asphalt mixtures produced with cork or rubber granulates as aggregate partial substitutes”, Construction and Building Materials 41 (2013), 209–215
  4. Colonna P, Berloco N., Ranieri V., Shuler S.T., “Application of Bottom Ash for Pavement Binder Course”, SIIV - 5th International Congress - Sustainability of Road Infrastructures, Procedia - Social and Behavioral Sciences 53 ( 2012 ), 962 – 972 Lin, J., Guo, P., Wan, L., Wu, S., “Laboratory investigation of rejuvenator seal materials on performances of asphalt mixtures”, Construction and Building Materials 37 (2012,) 41–45
  5. Celauro, C., Bernardo, C. Gabriele, B., “Production of innovative, recycled and highperformance asphalt for road pavements”, Resources, Conservation and Recycling 54 (2010), 337–347
  6. Chiu, C., “Use of ground tire rubber in asphalt pavements: Field trial and evaluation in Taiwan”, Resources, Conservation and Recycling 52 (2008), 522–532
  7. Shirini, B., Imaninasab, R., “Performance evaluation of rubberized and SBS modified porous asphalt mixtures”, Construction and Building Materials 107 (2016), 165–171
  8. Arrieta, V.S., Maquilon, J.E.C., “Resistance to degradation or cohesion loss in Cantabro test on specimens of porous asphalt friction courses.”, XVIII Panamerican Conference of Traffic and Transportation Engineering and Logistics (PANAM 2014), Procedia - Social and Behavioral Sciences 162 ( 2014 ) 290 – 299 Sengul C.E., Oruc, S., Iskender, E., Aksoy, A., “Evaluation of SBS modified stone mastic asphalt pavement performance”, Construction and Building Materials 41 (2013) 777–783
  9. Tayfur, S., Ozen, H., Aksoy, A., “Investigation of rutting performance of asphalt mixtures containing polymer modifiers”, Construction and Building Materials 21 (2007) 328–337.
  10. Zoorob, S.E., Suparma, L.B., “Laboratory design and investigation of the properties of continuously graded Asphaltic concrete containing recycled plastics aggregate replacement (Plastiphalt